2014 Acura Rlx Hybrid

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.

The Office of Defects Investigation (ODI) opened this investigation to determine if the failure of airbags to deploy during severe crashes, in certain vehicles, was the result of a safety related defect.  During the investigation a complex failure was studied that can result in non-deployment of subject vehicle air bags and other restraint system devices in severe crash events. The subject vehicles may be equipped with an airbag control unit (ACU) for the supplemental restraint system (SRS) Electronic Control Unit (ECU) manufactured by ZF-TRW.  The ECU receives signals from crash sensors mounted in the vehicle and deploys the vehicle air bags and seat belt pretensioners in accordance with manufacturer design specifications.  The ECU in the subject vehicles contains a model DS84 application-specific integrated circuit (ASIC) which controls the communication of the crash sensor signal, firing commands (i.e., when to deploy the airbag(s) and/or pretensioners), and fault information (e.g., diagnostic trouble codes). In September 2016, FCA announced recall 16V-668 for certain model year (MY) 2010 to 2014 Chrysler, Dodge and Jeep products manufactured with the subject ZF-TRW ACU.  In this recall, FCA discussed an EOS condition that resulted in a failure of the subject DS84 ASIC, which caused air bag non-deployment.  FCA noted that the defect condition had only been observed in vehicles equipped with sensor harnessing routed across the front of the vehicle.  Other FCA vehicles that also used the subject ACU, but were not equipped with cross-car harnessing, had not experienced EOS failures, despite similar time in service. During the course of this investigation, ODI sent two separate Information Request (IR) letters to six vehicle manufactures (including FCA, Hyundai, Honda, Kia, Mitsubishi, and Toyota) and one IR letter to ZF-TRW.  These IR letters resulted in ODI receiving comprehensive data from these manufacturers and suppliers. Studies of this data found that the DS84 ASIC does not have sufficient protection against negative electrical transients or electrical overstress (“EOS”) that can be generated in certain severe crashes.  An electrical transient occurs when the electrical power supplied to a circuit changes momentarily over a short duration of time.   In these severe crash cases, the crash sensors and other powered wiring can be damaged and short circuited so as to create a negative electrical transient of sufficient intensity and duration (that are outside the vehicle manufacturer's specification) to damage the ASIC before the restraint device deployment signal is received by the SRS ECU.  This damaged signal can lead to incomplete or nondeployment of the air bags and/or pretensioners.  Airbag non-deployment and/or lack of pretensioner operation can increase the risk or severity of injury in a crash.A total of 8 fatalities and 14 injuries were associated with known EOS events. The common element in all investigated manufacturers vehicles is the SRS ECU containing a DS84 ASIC manufactured by ZF-TRW.  The risk associated with the ASIC is equally shared among all OEMS involved in the investigation.  The actual real-world risk can be mitigated by other factors which were assessed by ODI during this investigation. The first mitigating factor involves protections built into the ACU design which protect the DS84 ASIC from damage.  There are multiple strategies and levels of protection employed by different OEMs that provide effective EOS mitigation.  The two most common strategies at the ACU level are circuit protection diodes on the remote senor signal lines, and current limiting resistors that protect critical components. The second mitigating factor is found at the vehicle level and involves the location and routing of the wires leading from the crash sensors to the SRS ECU.  If the wires are well protected in a crash and are not routed with other power wires carrying large currents, the risk for an EOS event is significantly reduced or eliminated. These design specific factors combine to produce a spectrum of risk for the vehicles equipped with ACUs using the DS84 ASIC.  Given the many of years of field exposure, it is possible to divide the subject population into two groups; vehicles which have experienced EOS events, and vehicles which have not experienced EOS field events. Four of the six OEMs involved in this investigation have experienced EOS field events on at least one of their models equipped with a DS84 ASIC.  All vehicle models (including the Toyota models identified in the Failure Report Summary of the opening resume for this investigation) with field events have been recalled.  In an abundance of caution, ODI kept this investigation open five years to monitor field performance and did not identify any field events on vehicles not included in existing safety recalls. Given the spectrum of risk identified in this investigation and that all vehicles with a demonstrated unreasonable risk have been recalled, ODI is closing this investigation. ODI is closing this investigation with the following manufacturer safety recalls: 16V-668, 18E-043, 18V-137, 18V-363, and 20V-024.  With the recall actions taken by the subject vehicle and equipment manufacturers, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exists on other model or model year vehicles outside of the recall scopes. The agency reserves the right to take further action if warranted by the circumstances.

MY CAR HAS BEEN DAMAGED 3 TIMES BY RODENTS CHEWING ON WIRING IN THE ENGINE COMPARTMENT. THE CAR HAD TO BE TOWED TWICE. FORTUNATELY, THE BREAKDOWNS HAVE OCCURRED WHILE THE CAR WAS PARKED, AND NOT WHILE I WAS DRIVING. BUT, YOU ONLY NEED TO DO A SEARCH OF THE 'NET TO FIND REPORTS OF PEOPLE THAT HAVE HAD BREAKDOWNS WHILE DRIVING, AND EVEN FIRES IN THE ENGINE COMPARTMENT. THE ROOT CAUSE OF THIS PROBLEM IS THAT MANUFACTURING OF WIRING IS NOW USING "ECO-FRIENDLY" LUBRICANTS BASED ON SOY OR PEANUTS. THIS CREATES AN "ATTRACTIVE NUISANCE" FOR RODENTS TO CHEW ON THE WIRING, THINKING IT MAY CONCEAL FOOD. IF YOU LOOK CLOSELY AT THE PICTURE I ATTACHED, THE WIRING HAD BEEN WRAPPED WITH A GREY "ANTI-RODENT" TAPE (WHICH CONTAINS CAPSAICIN) THE SECOND TIME IT WAS REPAIRED. BUT, I DON'T THINK IT WAS COMPLETELY WRAPPED ALL THE WAY TO THE CONNECTOR, AND ONLY A SMALL PART WAS LEFT EXPOSED. THIS TAPE IS AN ACTUAL HONDA PART THAT CAN BE ORDERED BY THEIR SERVICE DEPT. SO, HONDA IS WELL AWARE OF THE PROBLEM. THREE MEN FILED A LAWSUIT AGAINST AMERICAN HONDA IN 2016. AFTER REPEATED ATTEMPTS BY HONDA TO DISMISS IT, THE PLAINTIFFS FILED A MOTION TO CERTIFY THE LAWSUIT AS A CLASS ACTION. WITHIN WEEKS, THE LAWSUIT WAS WITHDRAWN WITHOUT PREJUDICE BY THE PLAINTIFFS, PRESUMABLY BECAUSE HONDA SETTLED. THIS METHOD OF MANUFACTURE IS IMPOSING SIGNIFICANT COSTS ON CONSUMERS TO REMEDY THE RESULTING PROBLEM, INCLUDING HIGHER INSURANCE PREMIUMS. I'M ACTUALLY NOT FILING A CLAIM ON MY LATEST DAMAGE, BECAUSE MY INSURANCE COMPANY CAN CANCEL MY INSURANCE IF I HAVE MORE THAN ONE CLAIM IN A YEAR DUE TO ANIMAL DAMAGE. I AM NOT ASKING FOR A RECALL. BUT, SOME REGULATION IS NEEDED TO BAN AUTOMOBILE MANUFACTURERS FROM USING FOOD-DERIVED LUBRICANTS IN MANUFACTURING, FOR SAFETY REASONS.

NHTSA ID

11071578

Incident

Jan 24, 2018

Mileage

27,500 mi

Service Bulletin - Drivers may experience a chirping sound coming from the engine area with the engine warmed up due to the high pressure fuel pump is making a chirp.

Owner notification - Our records indicate that a Emissions Recall has not been completed on this vehicle. When the powertrain control module (PCM) detects a malfunction in one of the odd number transmission gears, it will set one of four diagnostic trouble codes (DTCs). Due to inappropriate calibration of the PCM, the On Board Diagnostic (OBD) system cannot properly clear the transmission permanent DTC as required.

ServiceNews Article - Do you have a slow tire leak, but there are no signs of sidewall damage or anything stuck in the tread? While you're checking for leaks, check the valve stem; it could have oxidation buildup from road salt. This buildup can cause a poor seal, resulting in a slow leak.

Owner Notification Letter - When the powertrain control module (PCM) detects a malfunction in one of the odd number transmission gears, it will set one of four diagnostic trouble codes (DTCs). Due to inappropriate calibration of the PCM, the On Board Diagnostic (OBD) system cannot properly clear the transmission permanent DTC as required.

Service Bulletin - The timing belt area chirps after the engine warms up.

"Service Bulletin - When the PCM detects a malfunction in one of the odd number transmission gears, it will set one of the following DTCs: -P073F (unable to engage gear 1) -P074B (unable to engage gear 3) -P074D (unable to engage gear 5) -P074F (unable to engage gear 7) Due to inappropriate calibration of the PCM, the OBD system cannot properly clear the transmission permanent DTC as required."