2018 BMW 540D

The Office of Defects Investigation (ODI) opened PE21-021 on October 14, 2021, to investigate incidents alleging a stall/loss of motive power as a result of high-pressure fuel pump failures in certain model year (MY) 2019-2020 Ram 2500, 3500, 4500, and 5500 heavy duty trucks equipped with 6.7L Cummins turbodiesel engines. During the investigation, ODI sought to determine if the related defect allegation was limited in scope to the recalled population. After review of information request response materials from both FCA and BMW, NHTSA determined that sufficient information to identify a comprehensive recall population could not be produced by FCA and BMW.During the investigation FCA filed recalls 22V406, 22E048, 22V767, and 22E087 which include vehicles not identified in the initial subject population by ODI. ODI also received recall 21V586, involving loss of motive power due to failed CP4 fuel pumps on certain BMW manufactured vehicles. An information request letter response received from BMW indicated that failed pumps on their vehicles were caused by an interaction between pump internal components and US market diesel fuel, leading to increased slip and eventual particle-generating wear surface. Additional work will be done to identify whether a similar root cause is associated with the FCA recalled population and if similar wear dynamics occur on pumps supplied to vehicle manufacturers other than those included in the recalled population.ODI has upgraded this investigation to an EA in order to 1) determine engineering specifications of internal pump components that are correlated with pump failure leading to loss of motive power or other safety related hazards, 2) identify vehicle populations equipped with alleged defective pump variants, 3) assess if vehicles equipped with alleged defective pump variants result in an unreasonable risk to motor vehicle safety and 4) gather and review any other relevant information related to high pressure fuel pump failure associated with the subject populations of recalls 21V586, 21V880, 21E094, 22V406, 22E048, 22V767, and 22E087.Review of the above information will allow NHTSA to confirm root cause and recall remedy viability, and identify and evaluate vehicle populations equipped with pump components that may pose an unreasonable risk to motor vehicle safety.The ODI reports cited above can be reviewed at: http://www-odi.nhtsa.dot.gov/owners/SearchNHTSAID using the following complaint identification numbers: 11257550, 11351441, 11361603, 11361616, 11365300, 11365426, 11365858, 11366401, 11372337, 11373793, 11374797, 11376793, 11377871, 11378173, 11384377, 11386063, 11387018, 11399710, 11402550, 11415339, 11418868, 11418870, 11427075, 11434276, 11436807, 11437226, 11437249, 11437273, 11437292, 11437294, 11437394, 11437399, 11437403, 11437405, 11437423, 11437528, 11437565, 11437579, 11437580, 11437590, 11437679, 11437744, 11437781, 11437842, 11437993, 11438006, 11438008, 11438121, 11438138, 11438155, 11438392, 11438629, 11439359, 11439879, 11440397, 11443030, 11446542, 11448163, 11453556, 11458918, 11460558, 11469337

The 540d has swirl flaps on the intake manifold to regulate air intake so it adjusts how much air the intake manifold feeds the engine. There's an actuator motor that connects to the swirl flap shaft that connects via a plastic linkage. When the linkage breaks, the flaps are no longer controlled by the actuator and stays in its semi closed state. The result is when you give it full throttle, it spews out plumes of black smoke that is thick and the equivalent to rolling coal on a deleted diesel truck. The car still runs, but this poses a danger to those behind you and not very environmentally friendly to spew out soot. BMW's solution is a $6,000 repair bill, because the entire intake manifold has to be replaced for that linkage. This will be a guaranteed fail again - considering I had a check engine light for swirl flap issues starting around 40K miles.

NHTSA ID

11602418

Incident

Jun 30, 2024

My passenger restraint system randomly faults. Problem with passenger seat mat. Many BMW owners have reported the issue. Should be recalled by BMW.

NHTSA ID

11575506

Incident

Sep 1, 2023

There is an exhaust leak which has developed in the turbo. This causes untreated fumes and soot to be emitted in the engine compartment. This untreated exhaust makes its way into the passenger cabin, putting passengers at safety risk due to untreated exhaust fumes entering the cabin. The dealership has acknowledged the issue and describes it as follows: "The soot that you have seen and the smell is coming out of the wastegate shaft which by design there is a tolerance for it to move, but due to back pressure from the soot build up before the regen has occurred there is some soot that comes out." This problem happens every time I start and drive the car. The dealership is stating that this is not covered by the factory warranty. An exhaust leak like this is a serious passenger safety issue.

NHTSA ID

11474850

Incident

May 2, 2022

One or more of the LED daytime running lights are dim or discolored.

Check Control message (CCM) indicates: (ID 213): Stop, exercising due care. Voltage supply The Service Engine Soon light is on with the following DME Fault Code: 21B209 - Starter alternator / belt for 48V system (OSA_RIEMEN_RISS): Belt betweenCombustion engine and starter generator torn And/or one or more of the following other issues are also occurring: Noise in the area of the belt drive. Odor from the engine compartment. Smoke formation in the area of the belt drive. Drive belt damaged or prematurely worn. Torn drive belt.

The basic conditions for initializing the power windows are not met.

The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle “discharged battery” complaints.

At low outside temperatures (below 40 degrees F) and slow driving speeds (i.e. when parking, maneuvering)with a large steering angle, the front end can be slightly axially misaligned. This can be felt (jerking)/ heard via an acoustic acknowledgement (clunk) as seen at the 11 second mark of the video. See attached video V36 01 21.

The Central Information Display goes black intermittently due to resets of the Head Unit (HU-H3). FaultB7F8F9 – “HU-H: Reset” will be stored in the HU-H3.