RoadVitals

2005 BMW K1200LT Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Sep 9, 2004
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
1 investigation on file

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

04V438000

FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP

Sep 9, 2004
380 units potentially affected
The defect: ON CERTAIN MOTORCYCLES, AT LOWER TEMPERATURES, WIRING WITHIN THE ANTI-THEFT CONTROL UNIT MAY PRESS AGAINST THE FUEL PUMP RELAY. THE FUEL PUMP RELAY CONTACTS COULD OPEN, INTERRUPTING THE FUEL SUPPLY TO THE ENGINE, RESULTING IN STALLING.
The risk: IF STALLING WERE TO OCCUR, THE DRIVER WOULD BE UNABLE TO MAINTAIN SPEED OR ACCELERATE, INCREASING THE RISK OF A CRASH.
The remedy: DEALERS WILL INSPECT AND, IF NECESSARY, REPLACE THE ANTI-THEFT CONTROL UNIT. THE RECALL BEGAN OCTOBER 4, 2004. CUSTOMERS SHOULD CONTACT BMW AT 1-800-831-1117.
BMW OF NORTH AMERICA, LLCView on NHTSA.gov
04V304000

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER

Jun 23, 2004
181 units potentially affected
The defect: ON CERTAIN MOTORCYCLES, AN INCORRECT SEALING RING WAS MOUNTED TO THE PISTON OF THE REAR BRAKE MASTER CYLINDER.
The risk: IF ONLY THE REAR BRAKE WERE APPLIED DURING RIDING, INSUFFICIENT BRAKING PRESSURE WOULD BE AVAILABLE TO SLOW THE MOTORCYCLE, WHICH COULD INCREASE THE RISK OF A CRASH.
The remedy: DEALERS WILL REPLACE THE REAR BRAKE MASTER CYLINDER. THE RECALL BEGAN JULY 16, 2004. OWNERS SHOULD CONTACT BMW AT 1-800-831-1117.
BAYERISCHE MOTOREN WERKEView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

DP12001ClosedDefect Petition

M/C final drive ball bearing failure

Opened Jan 20, 2012
Closed Jun 20, 2013

The Office of Defects Investigation (ODI) received a defect petition requesting that it open an investigation into model year (MY) 1998-2009 BMW KLT series motorcycles for final drive bearing failures.The petitioner asked NHTSA to issue an order that [BMW] be required to recall the affected models for inspection ofcomponent wear and proper assembly of the [final drive] bearing.ODI has reviewed the petition, assessed relevant consumer complaints, and gathered other data in the course of investigating this issue.Based on its review, ODI does not believe that a safety-related defect trend currently exists for final drive bearing failures in the subject motorcycles.Therefore, in view of the need to allocate and prioritize NHTSA's limited resources to accomplish the agency's safety mission, the petition is denied.However, the agency will continue to monitor information related to this issue and will take further action if warranted.For detailed information, see the Federal Register notice: https://federalregister.gov/a/2013-13779.

POWER TRAIN:DRIVELINE:DIFFERENTIAL UNIT

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .