ELECTRICAL SYSTEM:WIRING
2025 BMW M5 Sportswagon
Recalls, owner-reported complaints, investigations and safety data
Overview
Our database contains no NHTSA owner-reported complaints for the 2025 BMW M5 Sportswagon. 1 safety recall has been issued covering this model year; and 11 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Safety recalls
1 campaign cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
No owner complaints recorded for this model year
Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
STRUCTURE:BODY
When pulling on the hood (highlighted inorange in the top photo) release lever (highlighted in orange in the bottomphoto; driver’s footwell shown ) , there is anoticeable lack of cable tension; and the hoodwill not unlock.
ELECTRICAL SYSTEM
Due to unfavorable software, the Storage Management Electronics (SME) will not show fault codes that trigger the Malfunction Indicator Lamp (MIL) when performing ISTA Service Function "Display Permanent SAE Fault Codes." As a result, workshops will have to identify SME-specific permanent SAE (emission related) Diagnostic Trouble Codes (DTCs) stored in the vehicle during diagnosis or when preparing a vehicle for a State Emission Inspection and Maintenance through a workaround procedure.
ELECTRICAL SYSTEM
After programming the vehicle via ISTA/RSUto I-level …26-03-5xx, some of the interiorambient lighting strips (arrows) may begin tofail sporadically after a deep sleep cycle.
ENGINE
This Service Bulletin provides instructions to clean the intake valves using the BMW Carbon Blaster Tool P/N 81 29 2 208 034 and the S68T / XB1T Kit P/N 83 30 5 BAD 3D5. Refer to SI B04 12 11 for existing documentation about the carbon blaster tool and SI B04 02 26 for the S68T /XB1T tool kit.
ENGINE
This Service Bulletin provides instructions to clean the intake valves using the BMW Carbon Blaster Tool
ELECTRICAL SYSTEM
Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.