EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH
2001 Chevrolet Blazer Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Data refreshed
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
3 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH; EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS:SWITCH
SEAT BELTS
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
HAZARD LIGHT SWITCH FAILURE
ON NOVEMBER 30, 2001, GENERAL MOTORS (GM) CONDUCTED SAFETY RECALL 01V-364 FOR THE SUBJECT VEHICLES BUILT BETWEEN SEPTEMBER 16, 1999 AND AUGUST 28, 2001 TO REMEDY A DEFECTIVE HAZARD SWITCH THAT WOULD CAUSE A LOSS OF HAZARD AND STOP LAMP ILLUMINATION.THE HAZARD SWITCH IS CONTAINED WITHIN THE VEHICLE MULTIFUNCTION SWITCH.ODI OPENED THIS INVESTIGATION BASED ON REPORTS THAT SOME CONSUMERS WERE NOT NOTIFIED OF THE ORIGINAL RECALL OR THAT THEY HAD REPAIRS DONE UNDER 01V-364 BUT EXPERIENCED SUBSEQUENT MULTIFUNCTION SWITCH FAILURES.THE MULTIFUNCTION SWITCH SUPPORTS THE OPERATION OF CRUISE CONTROL, WINDSHIELD WIPERS, EXTERIOR LIGHTING AND TURN SIGNALS IN ADDITION TO HAZARD AND STOP LAMPS. ON MAY 21, 2008, GM NOTIFIED THE AGENCY THAT IT ERRONEOUSLY MISSED IDENTIFYING 5,862 VEHICLES THAT SHOULD HAVE BEEN INCLUDED IN RECALL 01V-364.GM WILL NOW NOTIFY OWNERS OF THESE VEHICLES UNDER A NEW NHTSA RECALL NUMBER 08V-231.OWNER NOTIFICATION BEGAN ON JUNE 17.THE PRIMARY CAUSE OF BRAKE LAMP FAILURE WAS A DESIGN CHANGE FROM COPPER TO BRASS CONTACT MATERIAL IN THE HAZARD SWITCH.THIS CHANGE WAS EFFECTIVE FOR VEHICLES BUILT AFTER SEPTEMBER 16, 1999.GM CHANGED THE MATERIAL BACK TO COPPER FOR VEHICLES BUILT AFTER AUGUST 28, 2001. THE REMEDY PART FOR BOTH 01V-364 AND 08V-231 CONTAINS COPPER CONTACTS.GM'S DATA SHOWS THAT LESS THAN 1% OF VEHICLES REPAIRED UNDER RECALL 01V-364 REQUIRED ADDITIONAL SUBSEQUENT REPAIR OR REPLACEMENT OF THE HAZARD OR MULTIFUNCTION SWITCH.THIS INVESTIGATION IS CLOSED.
LOSS OF STOP LAMP ILLUMINATION
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations
Data on this page last refreshed .