RoadVitals

1986 Chevrolet P30 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Oct 24, 2007
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
6 investigations on file

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

07E088000

EQUIPMENT

Oct 24, 2007
121,680 units potentially affected
The defect: CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
The risk: THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.
The remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
HONEYWELL INTERNATIONAL, INC.View on NHTSA.gov
88V110000

SUSPENSION:FRONT:CONTROL ARM:LOWER ARM

Jul 6, 1988
21,485 units potentially affected
The defect: LEFT HAND LOWER CONTROL ARM CAN CRACK AND COULD EVENTUALLY CAUSE THE LOWER BALL JOINT TO SEPARATE FROM THE CONTROL ARM.
The risk: LOSS OF STEERING CONTROL CAN OCCUR WHICH COULD RESULT INA CRASH WITHOUT PRIOR WARNING.
The remedy: REPAIR OR REPLACE LOWER LEFT CONTROL ARM.
GENERAL MOTORS CORP.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

EA88043ClosedEngineering Analysis

FUEL EXPULSION

Opened Sep 20, 1988
Closed Sep 26, 1989

===

VEHICLE SPEED CONTROL:LINKAGES
PE88016ClosedPreliminary Evaluation

EXHAUST MANIFOLD LEAKS

Opened Jan 14, 1988
Closed Mar 31, 1988

SUMMARY:SOME 1981-86 TRUCKS WITH 7.4L ENGINES AND CAST IRON EXHAUSTMANIFOLDS MAY EXPERIENCE A CONDITION WHERE AN EXHAUST LEAK DEVELOPSBETWEEN THE MANIFOLD AND THE CYLINDER HEAD MATING SURFACE CAUSING A NOISECONDITION. MOST OF THE REPORTS (AND ALL OF THE INJURIES AND THEMANIFOLD FIRE) ARE FROM THE P30 MOTORHOME CHASSIS.GM STATES THAT A WARPEDOR CRACKED MANIFOLD WOULD PERMIT SMALL AMOUNTS OF EXHAUST GAS LEAKAGEGENERALLY RESULTING IN NOTICEABLE NOISE AND FUMES.THE EXHAUST MANIFOLDSARE SUSCEPTIBLE TO EXTREME HEAT CONDITIONS (SUCH AS OPERATING UNDER SEVEREENGINE/VEHICULAR LOAD CONDITIONS AND HIGH AMBIENT TEMPERATURES).THEMOTORHOME APPLICATION IS PARTICULARLY SUSCEPTIBLE TO THIS ALLEGED DEFECTSINCE THE VEHICLE IS NEARLY ALWAYS AT OR NEAR THE GVWR OF THE VEHICLE.THEFEW NUMBER OF REPORTS RECEIVED BY ODI FOR A PROBLEM WHICH BEGAN 8 YEARS AGOSUGGESTS THAT THE DEFECT EITHER OCCURS INFREQUENTLY OR IS NOT PERCEIVED ASA SIGNIFICANT SAFETY HAZARD.THE SERVICE BULLETIN WAS ISSUED TO IDENTIFYTHE HIGH TEMPERATURE PROBLEM AND PROVIDE A REMEDY AGAINST REOCCURRENCE.===

VEHICLE SPEED CONTROL:LINKAGES
EA88007ClosedEngineering Analysis

LOWER CONTROL ARM

Opened Nov 6, 1987
Closed Oct 24, 1988

SUMMARY OF INFORMATION FROM MANUFACTURER:MANUFACTURER IS IN RECEIPT OFONE COMPLAINT AND FIVE FIELD REPORTS.PRODUCT REPORT ANALYSIS STATES THELOWER CONTROL ARM FROM WAGGONER CORPORATION APPEARS TO HAVE A SMALL RADIUSAT THE TRANSITION OF THE SIDE WALL TO THE BALL STUD NOSE.CURRENT STAMPINGSOURCE, S.K.D., ALSO HAS A SMALL RADIUS IN THE SAME AREA.S.K.D. HASCHANGED THE TRIM TO INCREASE THE RADIUS TO 1 INCH AND PROVIDE ADDITIONALSTRENGTH IN THE BALL STUD AREA.ANALYSIS:FAILURE DATA INDICATES THE LEFT CONTROL ARM AND DIESEL ENGINEAPPLICATION ARE OVER REPRESENTED.ALL KNOWN FAILURES HAVE OCCURRED AT LOWSPEEDS, OR HAVE BEEN LOCATED AS A RESULT OF AN INCREASE IN THE FREQUENCY OFMAINTENANCE INSPECTIONS.BALL JOINT SEPARATION COULD RESULT IN COLLAPSE OFFRONT WHEEL SUSPENSION AND LOSS OF VEHICLE CONTROL.ACTION: IR TO GM SENT 11/19/87 CONTACT FLEET OWNERS.===

SUSPENSIONLed to recall 88V110001
PE87056ClosedPreliminary Evaluation

LOWER CONTROL ARM FAILURE

Opened Sep 8, 1987
Closed Nov 6, 1987

SUMMARY OF INFORMATION FROM MANUFACTURER:MANUFACTURER IS IN RECEIPT OFONE COMPLAINT AND FIVE FIELD REPORTS.PRODUCT REPORT ANALYSIS STATES THELOWER CONTROL ARM FROM WAGGONER CORPORATION APPEARS TO HAVE A SMALL RADIUSAT THE TRANSITION OF THE SIDE WALL TO THE BALL STUD NOSE.CURRENT STAMPINGSOURCE, S.K.D., ALSO HAS A SMALL RADIUS IN THE SAME AREA.S.K.D. HASCHANGED THE TRIM TO INCREASE THE RADIUS TO 1 INCH AND PROVIDE ADDITIONALSTRENGTH IN THE BALL STUD AREA.ANALYSIS:DATA INDICATES 38 OF 40 FAILURES INVOLVE THE LEFT CONTROL ARM,39 OF THE VEHICLES ARE POWERED BY THE DIESEL ENGINE.ALL FAILURES HAVEOCCURRED AT LOW SPEEDS, OR HAVE BEEN LOCATED DURING INCREASED FREQUENCYMAINTENANCE INSPECTIONS.SEPARATION OF THE BALL JOINT FROM THE CONTROLARM COULD CAUSE ONE SIDE OF THE FRONT WHEEL SUSPENSION TO COLLAPSE,POSSIBLY RESULTING IN LOSS OF VEHICLE CONTROL.PROPOSED ACTION:UPGRADE THIS PE TO AN EA.===

SUSPENSION
PE87043ClosedPreliminary Evaluation

EXHAUST SYSTEM HEAT

Opened Aug 7, 1987
Closed Jan 14, 1988

SUMMARY OF INFORMATION FROM MANUFACTURER:ANALYSIS OF THE 65 COMPLAINTSFORWARDED BY GM ON THIS ISSUE REVEALS THAT 15 OF THE COMPLAINTS MAY BESAFETY RELATED.COMPLAINTS IDENTIFYING THE PROBLEM AS A RED HOT EXHAUSTSYSTEM OR MUFFLER FAILURE WERE NOT COUNTED.GM ALSO INCLUDED NUMEROUSCOMPLAINTS PERTAINING TO FUEL EXPULSION IN THE MOTOR HOME CHASSIS.THEYWERE NOT COUNTED SINCE THAT PROBLEM IS ALREADY UNDER INVESTIGATION.CONCERNING BRUSH FIRES RESULTING FROM THE HIGH EXHAUST TEMPERATURES, GMSTATESOUR FIELD EXPERIENCE, AS EVIDENCED BY THE LOW NUMBER OF REPORTSPERTAINING TO THE EXHAUST TEMPERATURE, INDICATES TO US THAT OUR CUSTOMERSARE OBSERVING THE PRECAUTIONS CONTAINED IN OUR OWNER'S MANUAL AND AREEXERCISING THE NECESSARY PRECAUTIONS.ANALYSIS:THE ALLEGED DEFECT ORIGINATES WITH THE GENERATION OF HEAT IN THEEXHAUST SYSTEM.HIGHER EXHAUST TEMPERATURES ARE OCCURRING AS A RESULT OFSTRINGENT ENVIRONMENTAL PROTECTION AGENCY (EPA) REQUIREMENTS WHICH WENTINTO EFFECT IN 1985 FOR VEHICLES WITH A GVW IN EXCESS OF 8,500 LBS.THEHIGHER EXHAUST TEMPERATURES CAN LEAD TO EXCESSIVE UNDERBODY TEMPERATURESWHICH MAY RESULT IN FUEL SYSTEM PRESSURIZATION AND A HIGHER POTENTIAL FORTHE EXPULSION OF LIQUID FUEL UPON REMOVAL OF THE FUEL TANK FILLER CAP.INADDITION, OTHER SIDE EFFECTS SUCH AS SMOLDERING ITEMS IN PICK UP BEDS,BURNT TIRES AND MUDFLAPS HAVE BEEN REPORTED.PROPOSED ACTION:UPGRADE THIS PE TO AN EA.SINCE SOME MODELS ARE ALREADYBEING INVESTIGATED, AND COMPLAINT DATA IS SPARSE ON OTHER MODELS, THE NEWEA SHOULD BE DIRECTED ONLY TO VEHICLE MODELS C AND K WHICH UTILIZE THEHEAVY DUTY (VEHICLES WITH A GVW IN EXCESS OF 8,500 LBS) EMISSION SYSTEM.===

VEHICLE SPEED CONTROL:LINKAGES
PE87006ClosedPreliminary Evaluation

FUEL SPURTING

Opened Nov 14, 1986
Closed Apr 22, 1987

SUMMARY OF INFORMATION FROM MANUFACTURER:IT APPEARS THAT THE GASOLINE INTHE FUEL TANKS OF THE CHEVROLET P-30 CHASSIS VEHICLES VOLATIZE INCREASINGTHE PRESSURE WITHIN THE FUEL TANKS.THE FUEL RESERVOIR SYSTEM IS CLOSEDREQUIRING THE GASOLINE VAPOR TO BE REMOVED THROUGH THE CARBON CANISTER ATTHE FRONT OF THE VEHICLE.THE CAPACITY OF THE CANISTER TO PROCESS THE GASVAPOR IS LIMITED BY AN ORIFICE IN THE CANISTER INLET LINE (THE ORIFICE ISDESIGNED TO RESTRICT LIQUID GASOLINE FROM ENTERING THE CANISTER).THEFUEL LINES ON THE RAILS PARALLEL TO THE EXHAUST SYSTEM.WHEN PRESSURE DOES BUILD UP WITHIN THE FUEL SYSTEM, THE FUEL CAP DESIGN DOES NOT APPEARTO ALLOW FOR CONTROLLED PRESSURE RELEASE ALLOWING GASOLINE TO SPEW FROMTHE INLET PIPE.ANALYSIS:WHEN THE VEHICLE IS OPERATED IN PARTICULARLY HOT DAYS (AND/ORHIGH ALTITUDES) THE GASOLINE IN THE FUEL TANKS CAN VOLATIZE IN EXCESS OFTHE CARBON CANISTER CAPACITY ALLOWING PRESSURE TO BUILD IN THE FUEL TANKS.IF THE FUEL CAP IS NOT DESIGNED TO ALLOW CONTROLLED PRESSURE RELIEF DURINGREMOVAL, GASOLINE MAY SPURT OUT OF THE INLET PIPE RESULTING IN A POTENTIALFIRE.PROPOSED ACTION:CLOSE THIS PE ON GM AND OPEN AN ENGINEERING ANALYSISINVOLVING VARIOUS MOTORHOME MANUFACTURERS BUILDING ON THE GM P30 CHASSIS.===

VEHICLE SPEED CONTROL:LINKAGES

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .