2025 Chrysler Pacifica Problems

On Saturday July 25th, while driving at 70 mph on the highway, my van lost the ability to accelerate or maintain velocity. There was no warning or indication that this was going to happen. There was a beep and the screen flashed to a screen that said to pull over immediately and safely. Surprised and scared, I had to cut across 3 lanes of traffic while losing velocity cutting off a tractor trailer because my velocity dropped quickly. After restarting, the vehicle ran normally. I drove in the slow lane for a mile an it happened again. I was able to get the vehicle off the highway and drive slowly and safely on backroads to get the van to a Ourisman Chrysler in Clarksville, MD. The check engine light was on when I arrived at the dealer. Immediately upon arrival I was told by a service representative that it will most likely need a new transmission. On Tuesday he told me a tech verified it needs a new transmission. He told me the vehicle was classified as VOR (Vehicle Off Road) meaning it was unsafe or unable to be driven on the road and that parts were ordered and expedited. I did not hear back from the dealership until Friday at which point they surprisingly told me my vehicle was ready to pick up. In an email I was told: "what was found was a stored fault code P0A43-00 Drive motor "A" position sensor circuit intermittent. There is a TSB 21-037-26 for that fault code and vehicle going into limp mode and the repair is a rebuild kit for the transmission. " Despite this they also said in an email: "cleared codes and perform test drive. Code never came back and it states in the procedure you must verify the problem meaning it happened or is happening via active fault code which it is not." They refuse to fix the problem, despite acknowledging it happened. I was told to take the vehicle back and drive it as normal until it happens again, which I refused due to safety concerns. The vehicle currently has a bumper-to-bumper warranty.

We were at a complete stop waiting for traffic to go, I had my foot on the brake pedal and the car lunge/revved up and hit the car in front of me. This is the 3rd time this has happened. The first time we were advised it was probably the front-end sensor that were probably covered with ice. We were advised they are very sensitive. The 2nd time it was winter still, so we took the car through the car wash to make sure no ice was built up. We did not get in an accident because traffic started to move. We took the vehicle to the dealership, and they could not find anything wrong with it. Chrysler Corp got involved and they sent a 3rd party to check the van and black box. They advised nothing was found on the black box (not even an accident) and their investigators found nothing wrong with the vehicle. No warning messages were reported after the crash. Police were called to the scene and insurance was notified. Our insurance company advised that we should file this on here. There were 3 people in the van besides myself. We had a loaner vehicle for almost 3 months and we cannot get any information or paper work from Chrysler Corp regarding the investigation. We were advised the investigation was confidential and proprietary.

Manufacturer and dealer failed to remediate safety recall after seven weeks under the pretense that the dealer is not authorized to order more than 2 parts every 7 days. But I am not aware of a federal, state, nor county regulation establishing such restriction. The restriction thus seems to be self-imposed and therefore under the control of the manufacturer.

My local dealer, Dan Deery Motors, Waterloo, Iowa, said these airbag repairs are on a waiting list which is now over a year out! Which means I'll be driving with faulty airbags for at least a year! This is simply not acceptable! Is it?

My van has been in the shop for 22 days. They have replaced the engine 1 time and I had the van back 2 more times for check engine light issues and now the engine is being replaced for a a second time, so this is the 3rd engine in my 2025 Chrysler Pacifica that has 9100 miles on it.

At 9,000 miles the check engine light came on. We took the van to the dealership and there was metal in the engine and the engine needs to be replaced.

On Saturday July 25th, while driving at 70 mph on the highway, my van lost the ability to accelerate or maintain velocity. There was no warning or indication that this was going to happen. There was a beep and the screen flashed to a screen that said to pull over immediately and safely. Surprised and scared, I had to cut across 3 lanes of traffic while losing velocity cutting off a tractor trailer because my velocity dropped quickly. After restarting, the vehicle ran normally. I drove in the slow lane for a mile an it happened again. I was able to get the vehicle off the highway and drive slowly and safely on backroads to get the van to a Ourisman Chrysler in Clarksville, MD. The check engine light was on when I arrived at the dealer. Immediately upon arrival I was told by a service representative that it will most likely need a new transmission. On Tuesday he told me a tech verified it needs a new transmission. He told me the vehicle was classified as VOR (Vehicle Off Road) meaning it was unsafe or unable to be driven on the road and that parts were ordered and expedited. I did not hear back from the dealership until Friday at which point they surprisingly told me my vehicle was ready to pick up. In an email I was told: "what was found was a stored fault code P0A43-00 Drive motor "A" position sensor circuit intermittent. There is a TSB 21-037-26 for that fault code and vehicle going into limp mode and the repair is a rebuild kit for the transmission. " Despite this they also said in an email: "cleared codes and perform test drive. Code never came back and it states in the procedure you must verify the problem meaning it happened or is happening via active fault code which it is not." They refuse to fix the problem, despite acknowledging it happened. I was told to take the vehicle back and drive it as normal until it happens again, which I refused due to safety concerns. The vehicle currently has a bumper-to-bumper warranty.

When i put van in park ,shut off,it moves a little even on flat surface.When i back up in grass or out of a sloped driveway the van acts like something is preventing it from going backwards.The van,when going from the right lane to the left will act like it pulls to the right,hard to explain.Also when going down a road with slight bumps it makes a noise like something is loose,a rattle like.

We were at a complete stop waiting for traffic to go, I had my foot on the brake pedal and the car lunge/revved up and hit the car in front of me. This is the 3rd time this has happened. The first time we were advised it was probably the front-end sensor that were probably covered with ice. We were advised they are very sensitive. The 2nd time it was winter still, so we took the car through the car wash to make sure no ice was built up. We did not get in an accident because traffic started to move. We took the vehicle to the dealership, and they could not find anything wrong with it. Chrysler Corp got involved and they sent a 3rd party to check the van and black box. They advised nothing was found on the black box (not even an accident) and their investigators found nothing wrong with the vehicle. No warning messages were reported after the crash. Police were called to the scene and insurance was notified. Our insurance company advised that we should file this on here. There were 3 people in the van besides myself. We had a loaner vehicle for almost 3 months and we cannot get any information or paper work from Chrysler Corp regarding the investigation. We were advised the investigation was confidential and proprietary.

The contact rented a 2025 Chrysler Pacifica. While the contact's husband was driving at an undisclosed speed, the brake pedal was depressed; however, the vehicle failed to stop. The vehicle was driven to the residence. The contact stated that several days later, the failure reoccurred. The contact stated that while the husband was driving at an undisclosed speed, the brake pedal was depressed, however the vehicle failed to stop as intended. The contact's husband depressed the brake pedal to the floorboard while attempting to stop the vehicle. The rented vehicle crashed into the rear of the vehicle that was in front of the rented vehicle before coming to a complete stop. No warning lights were illuminated. The vehicle was driven to the residence. No injuries were sustained. A Police report was filed. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 26,000.

On Saturday July 25th, while driving at 70 mph on the highway, my van lost the ability to accelerate or maintain velocity. There was no warning or indication that this was going to happen. There was a beep and the screen flashed to a screen that said to pull over immediately and safely. Surprised and scared, I had to cut across 3 lanes of traffic while losing velocity cutting off a tractor trailer because my velocity dropped quickly. After restarting, the vehicle ran normally. I drove in the slow lane for a mile an it happened again. I was able to get the vehicle off the highway and drive slowly and safely on backroads to get the van to a Ourisman Chrysler in Clarksville, MD. The check engine light was on when I arrived at the dealer. Immediately upon arrival I was told by a service representative that it will most likely need a new transmission. On Tuesday he told me a tech verified it needs a new transmission. He told me the vehicle was classified as VOR (Vehicle Off Road) meaning it was unsafe or unable to be driven on the road and that parts were ordered and expedited. I did not hear back from the dealership until Friday at which point they surprisingly told me my vehicle was ready to pick up. In an email I was told: "what was found was a stored fault code P0A43-00 Drive motor "A" position sensor circuit intermittent. There is a TSB 21-037-26 for that fault code and vehicle going into limp mode and the repair is a rebuild kit for the transmission. " Despite this they also said in an email: "cleared codes and perform test drive. Code never came back and it states in the procedure you must verify the problem meaning it happened or is happening via active fault code which it is not." They refuse to fix the problem, despite acknowledging it happened. I was told to take the vehicle back and drive it as normal until it happens again, which I refused due to safety concerns. The vehicle currently has a bumper-to-bumper warranty.

Auto stall at stop is not working safely on my vehicle there are two issues that can cause safety problems .A) when system restarts engine the vehicle has jumped forward several feet quickly causing very nearly hitting the car in front of me as a traffic light turned green . B) when I slow not quite to a stop making a left turn I have experience very low or no power and could be hit if a car is coming towards me . Both these issues do stop if I remember to turn off the auto stall system but I do not always remember ! I did make a compliant at a Chrysler Dealer they found no issues and did not reproduce the problem no warning lights come up when the problem happens . I have not had damage to the vehicle but have had two close calls one nearly rearending a vehicle at a intersection as my Pacicifca lurched forward and the other as an oncoming car needed to brake when I made a left turn in an intersection and had a loss of power .

Passenger rear-sliding door will not open automatically/ will not properly re-latch despite multiple repair attempts (ie sensor and module replacement).

On 10-23-25 my son pushed the button at the bottom rear of the drivers seat that moves the seat forward when using the stow-n-go feature. I was in the seat at the time and had just seconds to react. I pushed the Driver 1 setting on the door and it reversed the action. If I hadn't, would I have been crushed into the steering wheel or would the air bag have gone off? What if I hadn't set up that feature? What if I had panicked? I took it to the dealership today. After inspecting it, they said there was no protocol for this problem. The only thing they could do was to disable the button, which they did upon my request. "5447 B Piller on left side has button for rear passengers to press to move seat forward. There is no setting to disengage function, only way to disengage would be to unplug button. Per customer request unplugged switch to disengage button from working." There were no warnings and just seconds to react. There is a button at the roof front center that disengages the side doors from opening. Perhaps this button should also include disengaging that feature, or eliminate it altogether. My 2015 Dodge Caravan also had stow-n-go. It was simple to move the seat forward to utilize this feature. Now, with the Driver presets, it is very convenient to move it back. This is an unnecessary and unsafe "convenience." Only someone in the driver seat should be able to move the seat forward.

Issue Timeline: • [XXX] (944 miles): Check engine light code P1A01 (high voltage electrical system). Vehicle serviced at dealership; issue unresolved. • Mid-February 2025: Check engine light code P0A0A appeared and cleared itself shortly thereafter. • [XXX] (1607 miles): Check engine light code P0A0A reoccurred. Vehicle was serviced at Criswell Auto (Gaithersburg, MD) from March 4–19, 2025. Power Inverter Module (PIM) replaced. No comparable loaner provided, resulting in inconvenience and additional expense. • [XXX] (2419 miles) : P0A0A error code recurred again. Vehicle returned to Criswell Auto; Chrysler Cares case #[XXX] initiated. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)