RoadVitals

2000 Dodge Durango Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
4
Newest Oct 20, 2008
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
4 investigations on file

Recall campaigns

4 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

08E064000

SUSPENSION:FRONT:HUB

Oct 20, 2008
2,805 units potentially affected
The defect: SKF IS RECALLING 2,805 HUB UNITS, PART NO. BR930361, SOLD AS A SERVICE PART FOR 1997-2004 DODGE DAKOTA VEHICLES AND 1999-2003 DODGE DURANGO VEHICLES EQUIPPED WITH 2-WHEEL DRIVE & REAR AXLE ABS. DUE TO A SPECIFICATION ERROR, THE ROTOR PILOT FOR THE HUB UNIT MAY BE TOO LONG. THIS RESULTS IN THE WHEEL TO NOT BE SEATED FULLY AGAINST THE HUB FLANGE FACE DURING MOUNTING.
The risk: IMPROPER SEATING OF THE WHEEL CAN RESULT IN EXCESSIVE VIBRATION, BRAKE ROTOR NOISE, DIFFICULTY REMOVING THE WHEEL AFTER INSTALLATION AND OPERATION OF THE VEHICLE, AND POSSIBLY WHEEL-END SEPARATION DURING VEHICLE OPERATION. SHOULD WHEEL-END SEPARATION OCCUR, THE DRIVER COULD LOOSE CONTROL OF THE VEHICLE, POSSIBLY RESULTING IN A CRASH.
The remedy: SKF WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE HUB UNITS FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 5, 2008. OWNERS MAY CONTACT SKF VSM NORTH AMERICA CUSTOMER SERVICE AT 1-800-644-8999.
SKF USA, INC.View on NHTSA.gov
06E024000

ENGINE AND ENGINE COOLING

Mar 15, 2006
44,386 units potentially affected
The defect: CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAIN DODGE PICKUP TRUCKS AND SUVS. A SMALL PIECE OF MATERIAL FROM THE TUBE WALL COULD BE SUCKED INTO THE ENGINE THROTTLE BODY, WHICH COULD CAUSE THE THROTTLE TO BECOME JAMMED IN THE OPEN POSITION.
The risk: A JAMMED OPEN THROTTLE COULD CAUSE UNINTENDED ACCELERATION OF THE VEHICLE, POSSIBLY RESULTING IN A CRASH OR INCREASED STOPING DISTANCES WHEN BRAKING.
The remedy: K&N WILL PROVIDE OWNERS WITH A FREE REPAIR KIT ALONG WITH REPAIR INSTRUCTIONS. THE RECALL BEGAN ON APRIL 20, 2006.
K&N ENGINEERING, INC.View on NHTSA.gov
04V596000

SUSPENSION:FRONT:CONTROL ARM:UPPER BALL JOINT

Dec 21, 2004
592,707 units potentially affected
The defect: ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH FOUR-WHEEL DRIVE (4X4), IF MOISTURE LEAKS INTO THE FRONT SUSPENSION UPPER BALL JOINT, EVACUATION OF THE LUBRICANT AND CORROSION OF THE JOINT MAY CAUSE THE JOINT TO WEAR OVER AN EXTENDED PERIOD OF TIME. THIS COULD CAUSE A CLUNKING NOISE IN THE FRONT SUSPENSION, WHICH MAY NOT ALWAYS BE HEARD BY THE VEHICLE OCCUPANTS.
The risk: EXCESSIVE WEAR IN THE UPPER BALL JOINT MAY ALLOW IT TO SEPARATE, WHICH COULD RESULT IN LOSS OF CONTROL OF THE VEHICLE.
The remedy: DEALERS WILL REPLACE THE FRONT SUSPENSION UPPER BALL JOINTS. THIS SAFETY IMPROVEMENT CAMPAIGN BEGAN ON DECEMBER 21, 2004. OWNERS CAN CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
DAIMLERCHRYSLER CORPORATIONManufacturer number D47View on NHTSA.gov
01V153000

AIR BAGS

May 8, 2001
216,100 units potentially affected
The defect: VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALBERTO ASSEMBLY PLANT ("M" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000; AND SALTILLO ASSEMBLY PLANT ("G" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000. IMPORTANT: VEHICLES THAT HAVE ALREADY HAD THE PROPER CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN EXCLUDED FROM THIS RECALL. IN ADDITION, 1997-2000 MODEL YEAR VEHICLES THAT HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN ADDED TO THIS RECALL.
The risk: WHEN THIS OCCURS, THE MATERIAL COULD INTERFERE WITH THE CLOCKSPRING RIBBON AND CAUSE AN OPEN CIRCUIT. THE DRIVER AIR BAG SYSTEM WILL BECOME DISABLED, AND THE AIR BAG WARNING LAMP WILL ILLUMINATE ON THE INSTRUMENT PANEL.
The remedy: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY. OWNER NOTIFICATION BEGAN JUNE 18, 2001. ALSO SOME 1997-200 MODEL YEAR VEHICLES THAT, ACCORDING TO WARRANTY RECORDS, HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, WILL ALSO BE INCLUDED IN THIS CAMPAIGN. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
DAIMLERCHRYSLER CORPORATIONManufacturer number 982View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

EA03023ClosedEngineering Analysis

UPPER BALL JOINT SEPARATION

Opened Nov 19, 2003
Closed Feb 11, 2005

DAIMLERCHRYSLER CORPORATION (DCC) IS RECALLING THE TARGET POPULATION OF APPROXIMATELY 600,000 MY 2000 THROUGH 2003 DURANGO AND DAKOTA VEHICLES WITH FOUR-WHEEL DRIVE TO REPLACE THE FRONT SUSPENSION UPPER BALL JOINTS WITH REDESIGNED PARTS THAT DO NOT HAVE THE JOINT INTEGRITY CONCERNS AND HAVE SUBSTANTIALLY IMPROVED JOINT RETENTION CAPACITY (NHTSA RECALL NO. 04V-596).THOUGH DCC DOES NOT ADMIT TO A SAFETY-DEFECT IN THE SUBJECT COMPONENTS, ODI BELIEVES THAT THE FACTS IN THIS INVESTIGATION SHOW OTHERWISE.BECAUSE OF THE LOW RATES OF SEPARATION INCIDENTS IN THE REMAINING SUBJECT VEHICLES, A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED IN THOSE POPULATIONS AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS IN THOSE VEHICLES.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.FOR ADDITIONAL INFORMATION, SEE THE ATTACHED CLOSING REPORT.

SUSPENSIONLed to recall 04V596000
PE03032ClosedPreliminary Evaluation

FRONT SUSP. UPPER BALL JOINT FAILURE

Opened Jul 16, 2003
Closed Nov 19, 2003

IN JULY 2003, ODI OPENED PE03-032 BASED ON 4 CONSUMER COMPLAINTS ALLEGING SEPARATION OF AN UPPER BALL JOINT.COMPLAINTS ALLEGED AN UNEXPECTED COLLAPSE IN THE FRONT END AND IN SOME OCCASIONS THE BALL JOINT SEPARATION IS ALLEGED TO HAVE RESULTED IN THE WHEEL, BRAKE ROTOR, AND STEERING KNUCKLE SEPARATING FROM THE VEHICLE.SINCE OPENING THE PE, ODI HAS RECEIVED 23 ADDITIONAL COMPLAINTS RELATED TO BALL JOINT SEPARATION. DAIMLERCHRYSLER HAS IDENTIFIED A WEAROUT CONCERN IN THE SUBJECT BALL JOINTS THAT IS BELIEVED TO OCCUR AFTER WATER INTRUSION EVACUATES THE JOINT LUBRICANT.DAIMLERCHRYSLER DOES NOT BELIEVE THE CONDITION POSES AN UNREASONABLE RISK TO SAFETY BECAUSE THE SUSPENSION DESIGN IN THE SUBJECT VEHICLES SIGNIFICANTLY REDUCES THE LIKELIHOOD OF JOINT SEPARATION.OVER 99 PERCENT OF THE FAILURES ARE RELATED TO WORN BALL JOINTS (E.G., NOISE COMPLAINTS).DAIMLERCHRYSLER REVISED THE REPAIR PROCEDURE IN AUGUST 2003 TO ALLOW THE UPPER BALL JOINTS TO BE SERVICED SEPARATELY FROM THE UPPER CONTROL ARM AND REDUCE REPAIR COSTS. DAIMLERCHRYSLER CHANGED THE SUPPLIER OF THE SUBJECT BALL JOINTS FROM TRW TO NEW CASTLE MACHINING & FORGE FOR MY 2000 VEHICLES.MY 2000 DURANGO VEHICLES ACCOUNT FOR 25 OF THE 37 SEPARATION COMPLAINTS.THE UPPER BALL JOINT WAS REDESIGNED IN MY 2003.THIS INVESTIGATION HAS BEEN UPGRADED TO AN ENGINEERING ANALYSIS TO FURTHER ASSESS THE ALLEGED DEFECT IN MY 2000-02 DURANGO VEHICLES.

SUSPENSION:FRONT
PE02082ClosedPreliminary Evaluation

SAFETY BELT CINCHING LATCH PLATE

Opened Nov 6, 2002
Closed Apr 23, 2003

THERE ARE NO INJURIES OR FATALITIES ASSOCIATED WITH THIS ALLEGED DEFECT.WHILE CONDUCTING THIS INVESTIGATION, ODI FOUND THAT THE SUBJECT CINCHES MEET THE LOAD BEARING REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 208, AND THAT MANY OF THE REPORTED FAILURES WERE DUE TO INCORRECT CHILD SAFETY SEAT INSTALLATIONS. ADDITIONALLY, THE REPORT RATE IS LOW (1.60/100K).THE INFORMATION AVAILABLE FAILS TO ESTABLISH THE EXISTENCE OF A DEFECT TREND AT THIS TIME.FURTHER ALLOCATION OF AGENCY RESOURCES TO THIS ISSUE IS UNWARRANTED AND THE PRELIMINARY EVALUATION IS BEING CLOSED.

SEAT BELTS
PE99074ClosedPreliminary Evaluation

STEERING WHEEL/SHAFT SPLINE ATTACHMENT

Opened Dec 13, 1999
Closed Feb 24, 2000

THIS PE WAS OPENED BASED ON ODI'S RECEIPT OF ONE COMPLAINT OF STEERING WHEEL SEPARATION ON THE SUBJECT VEHICLES.ALLEGEDLY (THAT IS, ACCORDING TO THE REPAIRING FACILITY'S SERVICE MANAGER) THE HUB NUT WAS NEVER INSTALLED ON THE SHAFT SPLINE.ALTHOUGH THE DRIVER LOST CONTROL OF THE VEHICLE, HE/SHE WAS ABLE TO STOP WITHOUT IMPACTING ANYTHING.BASED ON OUR INVESTIGATION AND THE MANUFACTURER'S RESPONSE, ODI IS CLOSING THIS INVESTIGATION BECAUSE THE SINGLE KNOWN COMPLAINT APPEARS TO BE AN ISOLATED INCIDENT.FURTHER, CHRYSLER HAS NO OTHER WARRANTY CLAIMS AND HAS NOT ISSUED ANY SERVICE BULLETINS.IN SUMMARY, A SAFETY-RELATED DEFECT TREND HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.ODI WILL CONTTINUE TO MONITOR THIS MATTER CLOSELY, AND THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION ON THESE MODELS IF WARRANTED BY THE CIRCUMSTANCES.

STEERING

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .