2009 Dodge Nitro

In a letter dated August 21, 2014, the Center for Auto Safety (CAS) petitioned the National Highway Traffic Safety Administration (NHTSA) to initiate a defect investigation of alleged failures associated with the Totally Integrated Power Module (TIPM) installed in Chrysler SUV?s, trucks, and vans beginning in the 2007 model year. The petitioner alleges that TIPM defects may result in engine stall, airbag non-deployment, failure of fuel pump shutoff resulting in unintended acceleration, fire, and other symptoms. On September 25, 2014, the Office of Defects Investigation (ODI) opened DP14-004 to evaluate the petition for a grant or deny decision. ODI analyzed complaint data provided by CAS as well as complaints submitted to ODI from consumers. In total, there were 296 complaints submitted by the petitioner in the original petition and five supplements, including 271 complaints related to the subject vehicles equipped with TIPM-7. Approximately 3 percent of CAS complaints are related to vehicles equipped with TIPM-6 and ODI?s review of these complaints did not identify any safety defect trends. ODI conducted a detailed review of complaints narratives submitted by CAS and consumers including careful analysis of vehicle repair histories, warranty claims obtained from the manufacturer and any available Customer Assistance Inquiry reports (CAIR). Analysis of the field data indicated that MY2011-2013 Jeep Grand Cherokee and Dodge Durango vehicles exhibited significantly higher complaint rates related to fuel pump relay (FPR) failures than other subject vehicles. In a September 3, 2014 letter to NHTSA, Chrysler submitted a Defect Information Report (DIR) identifying a defect in the FPR within the TIPM-7 which can result in a no start or stall condition in approximately 188,723 model year (MY) 2011 Jeep Grand Cherokee (WK) and Dodge Durango (WD) vehicles manufactured from January 5, 2010 through July 20, 2011 (14V-530).In a February 24, 2015 letter, Chrysler submitted a second DIR expanding the scope of the FPR defect condition to include an additional 338,216 MY 2012 through 2013 Jeep Grand Cherokee vehicles manufactured from September 17, 2010 through August 19, 2013 and MY 2012 through 2013 Dodge Durango vehicles manufactured from January 18, 2011 through August 19, 2013 (15V-115).ODI analysis of the CAS allegations of TIPM defects resulting in stall while driving, airbag non-deployment, unintended acceleration, fire and other faults identified a single defect condition related to 1 of over 60 different circuits in the TIPM assembly. The most common effect of this defect condition, related to the fuel pump relay, was a no-start concern, but it could also result in stall while driving (76 complaints). No valid evidence was presented in support of claims related to airbag non-deployment, unintended acceleration or fire resulting from TIPM faults and these claims were found to be wholly without merit based on review of the field data and design of the relevant systems and components.Except insofar as the petitioner's contentions relate to the defect condition addressed by the Chrysler recalls, the factual bases of the petitioner's contentions that any further investigation is necessary are unsupported. In our view, additional investigation is unlikely to result in a finding that a defect related to motor vehicle safety exists or a NHTSA order for the notification and remedy of a safety-related defect as alleged by the petitioner at the conclusion of the requested investigation. Therefore, in view of the need to allocate and prioritize NHTSA's limited resources to best accomplish the agency's safety mission, the petition is den

The contact owns a 2009 Dodge Nitro. The contact received recall notification of the NHTSA Campaign Number: 20V396000 (Air Bag, Steering) however, the vehicle was taken to the dealer for the recall repair where the emblem was removed however, the emblem was then replaced due to parts were unavailable to complete the recall . The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 20,000. Parts distribution disconnect.

NHTSA ID

11522128

Incident

May 2, 2023

Mileage

20,000 mi

The contact owns a 2009 Dodge Nitro. The contact stated while refueling the vehicle, the contact became aware of pressure build up which caused gasoline to not be able to be added to the fuel tank. The contact was unsure if there were any warning lights illuminated. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 160,000.

NHTSA ID

11500448

Incident

Dec 6, 2022

Mileage

160,000 mi

TIPM MODULE MALFUNCTIONS. THIS IS THE SECOND TIME THIS HAS HAPPENED. I BELIEVE IT IS ABOUT A $1000.00 REPAIR.STATIONARY IN MY DRIVEWAY

NHTSA ID

11360058

Incident

Sep 15, 2020

Mileage

120,000 mi

TL* THE CONTACT OWNS A 2009 DODGE NITRO. THE CONTACT STATED THAT WHILE DRIVING 35 MPH, THE VEHICLE HESITATED AND DECELERATED INDEPENDENTLY WITH THE CHECK ENGINE WARNING LIGHT ILLUMINATED. THE VEHICLE WAS RESTARTED AND DRIVEN TO HIS DESTINATION. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC AND THE CONTACT WAS INFORMED THE TRANSMISSION NEEDED TO BE REPLACED. THE CONTACT CALLED HAWK CHRYSLER DODGE JEEP RAM LOCATED AT 7911 W. ROOSEVELT RD, FOREST PARK, IL 60130, (708) 366-1001, TO NOTIFY THE DEALER OF THE FAILURE. THE VEHICLE WAS NOT DIAGNOSED NOR REPAIRED. THE MANUFACTURER WAS INFORMED OF FAILURE. THE FAILURE MILEAGE WAS 101,456.

NHTSA ID

11341646

Incident

Jun 28, 2020

Mileage

101,456 mi

ON 5/24/2019 JONES JUNCTION T/A JONES CHRYSLER JEEP DODGE DIAGNOSED MY 2009 DODGE NITRO WITH A FAILING FRONT DRIVE SHAFT (THE ASSEMBLY FROM THE TRANSFER CASE TO THE DIFFERENTIAL JOINT) AND RECOMMENDED IMMEDIATE REPLACEMENT. I WAS TOLD NOT TO DRIVE THE VEHICLE BECAUSE THERE WAS A SAFETY CONCERN THAT THE JOINT INSIDE THE BOOT COULD COMPLETELY FAIL AND THE SOLID METAL SHAFT WOULD DROP AND SNAG THE ROAD. THE PART (#52853363AF) HAS BEEN ON BACKORDER WITH DODGE CHRYSLER SINCE LATE MAY. FIRST DELIVERY DATE QUOTED WAS 6/7/19, THEN 6/20/19, AND NOW 7/7/19. I HAVE NO ANSWERS TO WHEN THIS ISSUE WILL BE RESOLVED AND WHEN THE VEHICLE WILL BE SAFE TO DRIVE AGAIN.

NHTSA ID

11221221

Incident

Jun 19, 2019

Mileage

106,000 mi

TL* THE CONTACT OWNS A 2009 DODGE NITRO. THE CONTACT STATED THAT THE AIR BAG WARNING INDICATOR ILLUMINATED. AN INDEPENDENT MECHANIC INSPECTED THE VEHICLE TO CHECK THE DIAGNOSTIC TROUBLE CODE AND STATED THAT THE FAILURE MAY BE RELATED TO THE AIR BAG MODULE. THE DEALER WAS NOT CONTACTED. THE MANUFACTURER WAS NOTIFIED. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS NOT AVAILABLE. *BF CONSUMER STATED DEALER WAS CONTACTED AND WAS TOLD HER DODGE NITRO WAS NEVER ON RECALLED. ENCLOSED IS A REPORT STATING AIR BAGS HAS BEEN RECALLED.*JB

NHTSA ID

11205320

Incident

Aug 1, 2014

Mileage

112,008 mi

FUEL TANK OVERFLOWS WHEN FILLING UP AT THE PUMP. I'VE HAD GASOLINE SPEW OUT ALL OVER ME SEVERAL TIMES NOW. I CAN SEE BY INVESTIGATING THIS ONLINE THAT THIS IS A "DANGEROUS" AND "KNOWN" ISSUE ON MANY DODGE MAKES, MODELS AND YEARS.

NHTSA ID

11170611

Incident

Dec 27, 2018

Mileage

69,000 mi

TAKATA RECALL / SEVERAL TIMES MY 4WD WILL GET A SERVICE 4WD LIGHT AND I WILL LOSE 4WD. THIS TIME I WAS SITTING STILL IN NEUTRAL AND TURNED MY SELECTOR SWITCH FROM 2WD TO 4WD AND RECEIVED THE SERV 4WD LIGHT. DODGE DEALERSHIP AS WELL AS LOCALLY OWNED SHOPS ARE AT A LOSS OF WHAT'S WRONG. AFTER MANY SEARCHES ONLINE I FIND I AM NOT THE ONLY PERSON WITH THIS PROBLEM AND NO ANSWER. ALSO, THE SECURITY LIGHT IS FLASHING, WINDSHIELD WIPERS GOING CRAZY, HORN BLARING, AND WASHER FLUID SQUIRTING OUR RANDOMLY FOR A LONG PERIOD OF TIME. HELP!!! DODGE SAYS 4WD SHOULD BE FINE BUT IS NOT... I ONLY HAVE 2WD AND THE SERVICE LIGHT IS STILL ON.

NHTSA ID

11161748

Incident

Dec 10, 2018

Mileage

108,001 mi

SWITCH - CLUTCH STARTER INTERLOCK & MASTER CYLINDER ASSEMBLY - CLUTCH

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.

Customer Satisfaction Notification Y22 Driver Airbag Emblem

Customer Satisfaction Notification Y22 Driver Airbag Emblem

Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.