POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT
2014 Ford Edge Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Data refreshed
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
3 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP
POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
Wheel Separation
On November 29, 2014, ODI received a complaint reporting the complete separation of an original equipment 22-inch alloy wheel rim mounted on the right front position of a model year 2014 Ford Edge vehicle (VOQ 10661278).The driver indicated that the right-front corner of the vehicle suddenly dropped while driving, causing the vehicle to go off the road to the right and into a field.The right-front wheel rim was found to have broken into two pieces. The owner said that there was no prior warning or wheel related problems with the vehicle. The vehicle had been driven approximately 8,500 miles at the time of the incident.On May 29, 2015 ODI sent an information request to Ford asking for detailed information related to the specific 22 inch alloy wheel used on the Edge as well as any peer vehicles which used the same type of wheel.On July 17, 2015 Ford provided ODI with the requested information. Ford's search showed that the single incident reported to ODI is the only instance of a wheel failure on the subject or peer vehicles.The failed wheel was sent to the National Transportation Service Board (NTSB) materials analysis laboratory for examination. The NTSB determined that the wheel failed because of a severe impact that caused a crack that rapidly propagated around the circumference of the wheel, The rim fracture surface had a predominantly rough appearance consistent with an overstress fracture (rapid fracture)There were no abnormalities or unique features associated with the fracture initiation site.Metallurgical analysis of the rim found that the material was within specification and no anomalies were identified that could have contributed to the failure.See the full NTSB report for more details.Based on the absence of additional failures and the results of the wheel material testing and failure analysis, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and take further action in the future if warranted.The following VOQ is associated with this investigation: 10661278
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations
Data on this page last refreshed .