2012 Ford F-550 Sd Recalls

The Office of Defects Investigation (ODI) opened this RQ to investigate allegations that the scope and remedy of safety recall 13V-535 were inadequate. Recall 13V-535 was limited to a relatively small population of Ambulance Package vehicles and ODI received complaints of pickup trucks and Fire Engine Prep Package vehicles being affected by the same defect. Ford manufactured approximately 555,985 subject vehicles between February 22, 2010 and January 30, 2015 that may be affected by defective EGT sensors and Powertrain Control Module (PCM) software calibration. The subject vehicles are equipped with four (4) EGT sensors to monitor engine operating conditions. An EGT sensor fault may produce false exhaust over-temperature signals. If these signals are produced, the Powertrain Control Module (PCM) implements a Failure Management Effects Mode (FMEM) and the driver receives a Stop Safely Now (SSN) system warning on the instrument cluster message center. The FMEM triggers a 70% reduction in available engine power over a period of no more than 45 seconds, during which it may not be possible to accelerate or maintain vehicle speed. The PCM then commands the engine to shut down when vehicle speed reaches approximately 1 mph. There is no immediate restart capability. Depending on the PCM software calibration, ignition key position and ambient temperature conditions, the engine may not restart until the end of a 10-60 minute cool down period.Ford and its component supplier(s) made numerous changes to the PCM software calibration and the design, material and manufacture of the EGT sensors over the period of subject vehicle production. This continuous product improvement affected vehicle performance regarding the alleged defect. Ford acknowledges the defect condition in the subject vehicles but argues that an unreasonable risk to motor vehicle safety is limited to Ambulance Package and Fire Engine Prep Package vehicles where commanded shutdown could impact emergency response and patient care. Ford also argues that the defect trend is in decline. Ford also initiated a new safety recall (15V-175) to address the 13V-535 remedy concerns in the Ambulance Package vehicles and Fire Engine Prep Package vehicles. The 15V-175 remedy reprograms the PCM with a new software calibration that stops a single EGT sensor fault to cause the vehicle to enter the FMEM shutdown mode.Ford also initiated an EPA emissions recall (14E03) for all subject vehicles that reprograms the PCM with the software calibration employed in safety recall 15V-175. Finally, Ford initiated a Customer Satisfaction Program (15M01) providing extended warranty coverage of 8 years or 80,000 miles for the the EGT sensors on certain MY2011-2012 subject vehicles.Due to the EPA emissions recall, that had a 66.6% completion rate in Ford's December 2015 progress report to the EPA, the defect trend is in decline. ODI is not aware of any crashes, deaths or injuries related to the alleged defect.ODI believes the alleged defect poses a safety risk but notes that the EPA emissions recall is addressing the safety problem.Compelling issuance of a duplicate recall would not represent a wise use of agency resources.Accordingly, this Recall Query is closed.This action is not a finding that no defect exists and NHTSA will take further action if such action is warranted.

The Office of Defects Investigation (ODI) is aware of 1 incident related to the alleged defect. By letter dated January 10, 2014, Almared, Inc. (doing business as A-1 Alternative Fuel Systems) has notified ODI that it has conducted a safety recall (NHTSA Recall No. 14V-040) to address a safety defect in 18 model year 2011-2012 Ford F-550 transit buses manufactured between May 2011 and April 2013. These vehicles have been altered by A-1 to contain one or more compressed natural gas (CNG) fuel containers. According to A-1, the brackets securing passenger side CNG fuel containers to the vehicle chassis may fracture, resulting in a CNG fuel container that is unsecured. A-1 has reportedly inspected all 18 affected vehicles and repaired all vehicles equipped with the defective mounting bracket by installing a new bracket of an improved design. The new bracket has added strength as a result of the following design revisions: the cantilevered mounting plate is reinforced with additional support plates, the cantilevered position is mounted higher on the bracket above the CNG fuel container center line position (thus reducing the moment arm), and it is constructed of heavier gauge steel plate that is also dimensionally wider, which provides for a greater bonding surface area with the vehicle chassis.Based on the recall action taken by Almared, Inc., this investigation is closed.