2022 Ford Transit Connect Problems

The radioator failed it started leaking the car is only 60k ish miles

While driving my 2022 Ford Transit Connect (cargo model, 2.0L) in city traffic, I experienced a serious intermittent issue. Twice now, the vehicle suddenly jerked, throttle response was delayed or non-existent, and a “Collision Detection Disabled” warning flashed on the dash. Simultaneously, the “Service Vehicle Soon” light illuminated. Both times, I pulled over and shut off the vehicle. Upon restarting, the warnings cleared and the vehicle drove normally again. There were no prior warning signs or fault messages. I brought the vehicle to Mullinax Ford in Apopka, FL, and explained the issue in detail. However, I was told there were no diagnostic trouble codes (DTCs) stored, and they refused to conduct any further testing. I specifically asked them to perform: A full scan of all vehicle modules (including the IPMA/collision system), Check the forward collision camera and wiring, Confirm all PCM/ADAS software is up to date, Perform a battery and charging system test, Inspect the throttle body or related sensors. They declined, saying “if there are no codes, there’s no issue.” This is concerning because the symptoms are intermittent and potentially safety-related — including unexpected loss of power and the disabling of a major safety system. Based on owner reports and technical bulletins from Ford for similar symptoms in other models (such as F-150 and Explorer), this may be due to software or hardware faults that do not always trigger DTCs. This issue affects my confidence in the safety and reliability of the vehicle. I am requesting that Ford investigate further, open a case, and provide support in ensuring proper diagnostics and resolution — even if the dealer won’t take further action.

While driving my 2022 Ford Transit Connect (cargo model, 2.0L) in city traffic, I experienced a serious intermittent issue. Twice now, the vehicle suddenly jerked, throttle response was delayed or non-existent, and a “Collision Detection Disabled” warning flashed on the dash. Simultaneously, the “Service Vehicle Soon” light illuminated. Both times, I pulled over and shut off the vehicle. Upon restarting, the warnings cleared and the vehicle drove normally again. There were no prior warning signs or fault messages. I brought the vehicle to Mullinax Ford in Apopka, FL, and explained the issue in detail. However, I was told there were no diagnostic trouble codes (DTCs) stored, and they refused to conduct any further testing. I specifically asked them to perform: A full scan of all vehicle modules (including the IPMA/collision system), Check the forward collision camera and wiring, Confirm all PCM/ADAS software is up to date, Perform a battery and charging system test, Inspect the throttle body or related sensors. They declined, saying “if there are no codes, there’s no issue.” This is concerning because the symptoms are intermittent and potentially safety-related — including unexpected loss of power and the disabling of a major safety system. Based on owner reports and technical bulletins from Ford for similar symptoms in other models (such as F-150 and Explorer), this may be due to software or hardware faults that do not always trigger DTCs. This issue affects my confidence in the safety and reliability of the vehicle. I am requesting that Ford investigate further, open a case, and provide support in ensuring proper diagnostics and resolution — even if the dealer won’t take further action.

Speedometer stops working/ lighting up. I called Ford regarding recall 25C19 and they said it doesn't cover this vehicle.

While driving my 2022 Ford Transit Connect (cargo model, 2.0L) in city traffic, I experienced a serious intermittent issue. Twice now, the vehicle suddenly jerked, throttle response was delayed or non-existent, and a “Collision Detection Disabled” warning flashed on the dash. Simultaneously, the “Service Vehicle Soon” light illuminated. Both times, I pulled over and shut off the vehicle. Upon restarting, the warnings cleared and the vehicle drove normally again. There were no prior warning signs or fault messages. I brought the vehicle to Mullinax Ford in Apopka, FL, and explained the issue in detail. However, I was told there were no diagnostic trouble codes (DTCs) stored, and they refused to conduct any further testing. I specifically asked them to perform: A full scan of all vehicle modules (including the IPMA/collision system), Check the forward collision camera and wiring, Confirm all PCM/ADAS software is up to date, Perform a battery and charging system test, Inspect the throttle body or related sensors. They declined, saying “if there are no codes, there’s no issue.” This is concerning because the symptoms are intermittent and potentially safety-related — including unexpected loss of power and the disabling of a major safety system. Based on owner reports and technical bulletins from Ford for similar symptoms in other models (such as F-150 and Explorer), this may be due to software or hardware faults that do not always trigger DTCs. This issue affects my confidence in the safety and reliability of the vehicle. I am requesting that Ford investigate further, open a case, and provide support in ensuring proper diagnostics and resolution — even if the dealer won’t take further action.

The factory windshield is loose/improperly bonded causing MOLD. This problem was found when i first bought the only four year old vehicle because of a musty/moldy smell. On the way home from the dealership it happened to storm and there were a few raindrops coming in at the top center of the windshield. I also had terrible allergy symptoms and headaches after only a few minutes of driving. I peeked under part of the vinyl floor and discovered major water and mold issues. I took it to my local Ford dealership who confirmed the windshield was likely the culprit as it was very loose. I researched this online and found an auto leak specialist demonstrating this same make/year/model van that the windshield could be easily moved simply by pushing lightly on the glass from inside the cabin, showing a bonding issue. This was the case on my van as well. This is the same issue that there WAS a recall for on the previous model (there just isn't one for this model yet) The damage was extensive and very dangerous for people like me who are sensitive to mold and can cause respiratory issues. I removed the seats and floor. There was approximately half gallon of water under the vinyl floor and mold everywhere. the vinyl floor conceals the water as it is waterproof. I spent well over a week on mold mitigation with drying/contaminated part removal/disinfecting. The insulation in the footwell was soaked and full of mold as well as the open cell foam on the underside of the vinyl. The metal body parts also had mold. I reached out to Ford Customer Care who claimed there's nothing they could do to help because there are no recalls for this model. I have to pay for everything myself. The windshield was confirmed by an auto glass specialist to have been factory and an original factory bead of sealant. They also confirmed it was a bonding issue, They were able to detach and reset it PROPERLY for $424. I still have to replace the insulation and entire vinyl floor.