EXTERIOR LIGHTING
2013 Freightliner Business Class M2 Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
11 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
STEERING:LINKAGES:TIE ROD ASSEMBLY
SERVICE BRAKES, AIR:DISC:CALIPER
TRAILER HITCHES:FIFTH WHEEL ASSEMBLY
POWER TRAIN:AUTOMATIC TRANSMISSION
ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL
SUSPENSION:FRONT
EXTERIOR LIGHTING:HEADLIGHTS
SERVICE BRAKES, AIR:SUPPLY:QUICK RELEASE VALVE
STEERING:COLUMN
ENGINE AND ENGINE COOLING:ENGINE:DIESEL
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
SmartPlex Multiplexer Module Failure
The Office of Defects Investigation (ODI) received Early Warning Reporting (EWR) data from the manufacturer that indicated some number of subject vehicles may allegedly experience a SmartPlex electronic multiplexing switch hub module failure. This failure may result in inadvertent activation of accessory equipment such as external lighting, outriggers, crane, or power takeoff.By letter dated March 1, 2013, Daimler Trucks North America LLC (DTNA) notified ODI that it has initiated a safety recall (NHTSA Recall No. 13V-074 and DTNA Recall No. FL-639) to address a safety defect in approximately 161 model year (MY) 2012 through 2013 Freightliner 108SD, 114SD and Business Class M2 trucks.The affected population was manufactured from December 3, 2011 through October 12, 2012 and originally equipped with a certain SmartPlex electronic multiplexing switch hub module with a suspect serial number. According to DTNA, unpassivated flux residue may be present on the printed circuit board assembly in the switch hub module. Under certain heat and humidity conditions, this flux residue may lead to intermittent short circuits, thereby activating certain outputs in the switch hub module.According to DTNA, they identified the issue with the switch hub module on vehicles undergoing the assembly process.DTNA states they have not received any customer or field reports related to the switch hub module.To date, ODI is unaware of any switch hub module failures on in-service vehicles.DTNA will notify affected owners by mail no later than April 29, 2013. Affected vehicles will be inspected and if the switch hub module is in the suspect range the module will be replaced.Repairs will be performed by DTNA authorized service facilities.Accordingly, this investigation is closed.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations