Owner-reported complaints naming the interior system, filed with NHTSA
Data refreshed
Reports naming seats, latches, locks, linkages and interior fittings. Every record below is an owner-reported complaint about the 1995 GMC K1500 submitted to NHTSA — not a confirmed defect, not a recall and not a manufacturer bulletin. 8 reports on file name it.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Shown in the owner’s own words, exactly as filed
WHILE TURNING A CORNER HEARD A LOUD SNAP. UPON PULLING OVER TO THE SIDE I FOUND THE SEAT BRACKET HAD BROKE LOOSE. THE SEAT IS EXTREMELY SHAKY NOW AND NEEDS TO BE REPAIRED WITH A NEW LOWER SEAT CUSHION BRACKET ASSEMBLY (COSTING OVER $200 FOR PARTS AND LABOR IS AN ADDITIONAL $225). I THOUGHT THERE WAS A RECALL ON THIS SEAT ASSEMBLY WHICH I HAD DONE A COUPLE YEARS AFTER I BOUGHT IT. *JB
THE DRIVER AND PASSENGER SEAT COLLAPSED WHEN ANOTHER CAR REAR ENDED THE CONSUMERS VEHICLE. THE OTHER VEHICLE WAS TRAVELING AT 55 MPH. AS A RESULT THE DRIVER AND PASSENGER WERE INJURED. *NLM *AK THE VEHICLE WAS TOTALED. THE RECLINING MECHANISM FAILED AND THE BACKS OF THE SEATS RECLINED AND AS A RESULT THE DRIVER AND PASSENGER ENDED UP IN THE BACK SEAT OF THE EXTENDED CAB. *SCC
METAL BASE OF THE DRIVER'S SIDE SEAT, WHERE IT WAS ATTACHED TO THE RAIL ON THE FLOORBOARD, BROKE. THIS COULD CAUSE SEATBACK TO COLLAPSE. WHEN REPORTING THIS PROBLEM TO THE DEALERSHIP, DEALER STATED THAT THE PROBLEM WAS COMMON AND THAT THE FAILURE WAS CAUSED BY METAL FATIGUE--A DESIGN AND MANUFACTURING DEFECT. *AK *ML
WHILE DRIVING AND APPLYING BRAKES DRIVER'S AND PASSENGER'S SEATS WILL MOVE FORWARD. WHEN ACCELERATING THE SEATS WILL SLIDE BACK. CONTACTED DEALER AND MANUFACTURER.*AK
WHEN I CONTACTED THE GMC DEALERSHIP, I WAS INFORMED THAT I WAS ON MY OWN AND THERE WAS NOTHING THAT THEY COULD DO. THIS WAS THE SAME RESPONSE THAT I RECEIVED FROM FOUR SEPARATE DEALERS. EVEN WHEN I EXPLAINED THAT I AM THE ORIGINAL OWNER AND THE TRUCK HAS NEVER BEEN INVOLVED IN A TRAFFIC COLLISION. DUE TO THE CONDITION OF THE SEAT FRAME, I CONSIDER IT A "CATASTRPPHIC FRAME FAILURE". IT IS VERY OBVIOUS THAT THE FRAME WAS CONSTRUCTED WITH A POOR QUALITY METAL. THE DAY THAT THE FRAME FAILED, I HAD JUST ENTERED MY TRUCK IN PREPARATION TO LEAVE FOR WORK. WHEN I ENTERED THE VEHICLE, THE FRAME SNAPPED OFF FROM THE BASE AND THIS FLEX CAUSED THE SEAT BACK TO RELEASE. I THEN FOUND MYSELF LOOKING UP AT THE ROOF OF MY TRUCK. THIS FAILURE HAS NOTHING TO DO WITH ANY MECHANICAL OR MOVING PART. THIS IS A SIMPLE CASE OF METAL FAILURE AND HAS NOTHING TO DO WITH MILEAGE. AT A 185LBS I DON'T FEEL THAT MY WEIGHT HAD ANY THING TO CONTRIBUTE TOWARDS THE FAILURE OF THIS SEAT FRAME. I LOCATED ON THE NHTSA WEB PAGE AND LOCATED THE ACTION NUMBER: PE97027 WITH REFERENCE TO THIS EXACT ISSUE. I AM VERY THANKFUL THAT I WAS NOT INVOLVED IN A COLLISION WITH THIS FRAME. THER IS NOT DOUBT IN MY MIND THAT I WOULD HAVE BEEN SERIOUSLY INJURED DUE TO THIS FRAME FAILURE. IS THERE ANY INFORMATION THAT I CAN GET WITH REFERENCE TO THE NHTSA INVESTIGATION ON THIS FAILURE. I ALSO HAVE THE FRAME AND ITS BROKEN PARTS IN MY POSSESSION FOR REVIEW OR INSPECTION IF NHTSA NEEDS TO SEE THE COMPONENT. THANK YOU FOR YOUR TIME AND CONSIDERATION REGARDING THIS ISSUE. SINCERELY J. TREVOR ANDERS
LEATHER SEATS HAVE BEEN REPLACED THREE TIMES DUE TO RIPPING, HOWEVER THEY CONTINUE TO RIP.
THE DRIVER SEAT TRACK BROKE, CAUSING THE SEAT TO MOVE, TOOK TO DEALER AND HE SAID THAT THE SEAT TRACK BOLT BROKE AND HAS TO BE REPLACED, THE WHOLE SEAT TRUCK NOT UNDER WARRANTY .*AK
DURING VEHICLE OPERATION THE FRONT DRIVER'S SIDE SEAT DISCONNECTED FROM THE BASE. *AK *SLC
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .