RoadVitals

2002 GMC Sierra 2500 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
4
Newest Jun 6, 2006
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
3 investigations on file

Recall campaigns

4 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

06E050000

SERVICE BRAKES, AIR

Jun 6, 2006
6,800 units potentially affected
The defect: CERTAIN FEDERAL-MOGUL NATIONAL AND CARQUEST AFTERMARKET HUB ASSEMBLIES, P/N 515058, SOLD FOR USE ON 2001-2006 GENERAL MOTORS 1500 AND 2500 4WD TRUCKS. ON THE SUBJECT HUB ASSEMBLIES, THE ABS SENSOR CORD DEPARTS FROM THE HUB ASSEMBLY AT A 90 DEGREE ANGLE. AS A RESULT, THERE IS A FIT ISSUE WITH THE BRAKE ROTOR DUST SHIELD INTERFERING WITH THE ABS SENSOR CORD. IF THE HUB ASSEMBLY IS INSTALLED DESPITE THIS INTERFERENCE, THE GAP BETWEEN THE ABS SENSOR AND THE TONE WHEEL MAY BE ALTERED. THIS MAY WEAKEN THE OUTPUT OF THE ABS SENSOR. DIMINISHED OUTPUT COULD RESULT IN AN UNWANTED ABS ACTIVATION AT LOW SPEEDS AND STOPPING DISTANCE COULD BE AFFECTED.
The risk: IF STOPPING DISTANCE IS LIMITED, A VEHICLE CRASH COULD OCCUR.
The remedy: FEDERAL-MOGUL WILL NOTIFY ITS OWNERS AND WILL EITHER CREDIT THE CUSTOMERS ACCOUNT OR REPLACE THE UNIT. THE RECALL IS EXPECTED TO BEGIN DURING JUNE 2006. OWNERS CAN CONTACT FEDERAL-MOGUL CUSTOMER SERVICE AT 1-800-563-8507 EXT 3530.
FEDERAL-MOGUL CORPORATIONView on NHTSA.gov
06E043000

FUEL SYSTEM, GASOLINE

May 19, 2006
88,303 units potentially affected
The defect: CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
The risk: THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
The remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
HONEYWELL INTERNATIONAL, INC.View on NHTSA.gov
06E010000

STEERING

Feb 1, 2006
1,360 units potentially affected
The defect: CERTAIN FABTECH AFTERMARKET REPLACEMENT PITMAN ARMS, P/NOS. FTS71000 AND FTS71001, INSTALLED FOR USE ON CERTAIN 2001-2006 GM C/K 2500 PICK UP TRUCKS AND SPORT UTILITY VEHICLES. THE PIN LOCATED INSIDE THE PITMAN ARM CAN SHEAR OFF DUE TO A REVERSE BENDING FATIGUE CONDITION, RESULTING IN A TOTAL LOSS OF STEERING CONTROL.
The risk: LOSS OF STEERING CONTROL COULD LEAD TO A VEHICLE CRASH WITH POTENTIAL INJURY OR DEATH.
The remedy: FABTECH WILL NOTIFY OWNERS AND REPLACE THE PITMAN AND IDLER ARMS FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING FEBRUARY 2006. OWNERS MAY CONTACT FABTECH AT 909-597-7800.
FABTECH MOTORSPORTSView on NHTSA.gov
01V220000

INTERIOR LIGHTING

Jun 26, 2001
38,863 units potentially affected
The defect: VEHICLE DESCRIPTION: CERTAIN PICKUP TRUCKS EQUIPPED WITH 6.6L DIESEL ENGINES FAIL TO COMPLY WITH REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." THESE VEHICLES HAVE A BRAKE SYSTEM WARNING LIGHT IN THE INSTRUMENT CLUSTER THAT MAY NOT ILLUMINATE WHEN THE BRAKE FLUID IS LOW. IN ADDITION, WHEN THE BRAKE FLUID IS LOW, THE VEHICLE MAY NOT MEET THE PARTIAL SYSTEM REQUIREMENTS OF FMVSS NO. 105.
The risk: THESE CONDITIONS COULD RESULT IN REDUCED BRAKING CAPABILITY, WHICH COULD LEAD TO A CRASH.
The remedy: DEALERS WILL CHANGE THE LOCATION OF A WIRE CONNECTION IN THE UNDERHOOD BUSSED ELECTRICAL CENTER. OWNER NOTIFICATION BEGAN JULY 9, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020 OR GMC AT 1-800-462-8782.
GENERAL MOTORS CORP.Manufacturer number 01050View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

EA07013ClosedEngineering Analysis

TRAILER HITCH RECEIVER FAILURE

Opened Sep 14, 2007
Closed Sep 12, 2008

COMPLAINT REPORTS ALLEGE POOR WELD QUALITY AND/OR BENDING OF THE SUBJECT VEHICLE ORIGINAL EQUIPMENT TRAILER HITCH RECEIVER.THE AGENCY'S INVESTIGATION INCLUDED ANALYSIS OF MANUFACTURER AND AGENCY INCIDENT REPORTS, REVIEW OF POLICE REPORTS, ANALYSIS OF THE AGENCY'S FATAL ANALYSIS REPORTING SYSTEM, A VEHICLE OWNER SURVEY, INSPECTION OF TOW VEHICLES/HITCHES AND ANALYSIS OF FAILED PARTS.INCIDENTS OF WELD FAILURE WERE RARE AND ASSOCIATED WITH VERY LOW-SPEED DRIVING (TURNING, BACKING AND SUDDEN STOPPING).INCIDENTS OF BENDING WERE ASSOCIATED WITH IMPROPER TRAILER HITCH ADJUSTMENT OR OVERLOADING. A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.ACCORDINGLY, THIS INVESTIGATION IS CLOSED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT A SAFETY-RELATED DEFECT DOES NOT EXIST.THE AGENCY WILL MONITOR THIS ISSUE AND RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.SEE DOCUMENT SEARCH FILE FOR ADDITION INFORMATION.

TRAILER HITCHES
PE07025ClosedPreliminary Evaluation

TRAILER HITCH RECEIVER FAILURE

Opened May 14, 2007
Closed Sep 14, 2007

GM PROVIDED ADDITIONAL DATA REGARDING ALLEGATIONS OF FAILURE OF THE TRAILER HITCH.ODI REVIEWED THAT AS WELL AS OTHER DATA PROVIDED BY PEER MANUFACTURERS.BASED ON OUR REVIEW, ODI FINDS THE NEED TO FURTHER INVESTIGATE THIS ISSUE.THIS PRELIMINARY EVALUATION IS UPGRADED TO AN ENGINEERING ANALYSIS (EA07-013) FOR FURTHER ASSESSMENT AND STUDY OF THIS ISSUE.

TRAILER HITCHES
PE04004ClosedPreliminary Evaluation

HYDRAULIC PUMP SHAFT FAILURES

Opened Jan 8, 2004
Closed Apr 30, 2004

THE PRELIMINARY EVAULATION IS BEING UPGRADED.DURING THE EA ODI WILL LIMITITS INVESTIGATION TO ONLY THOSE VEHICLES EQUIPPED WITH A HYDRO-BOOST SYSTEM, WHICH PROVIDES POWER ASSIST TO THE BRAKING AND STEERING SYTEMS.VACCUUM BRAKE BOOSTER VEHICLES ARE EXCLUDED.ODI HASEXPANDED THE SCOPE OF THE EA TO INCLUDE MODEL YEARS2003 AND 2004, ASDURING THE PE, ODI LEARNED THAT THE HYDROBOAST PUMPS WERE MODIFIED IN FEBRAURY 2004.THEREFORE,ODI HAS EXPANDED THE SCOPE TO INCLUDE THE ADDITIONAL MODEL YEARS.ODI'S IS CONCERNED BECAUSE THISISA SUDDEN FAILURE THAT AFFECTS TWO CRITICAL SYSTEMS OF THE VEHICLE, BRAKES AND STEERING, AT THE SAME TIME.THE ABILITY OF THE OPERATOR TO HANDLE THE DUAL FAILURES IS A CONCERN. FURTHER, THESE VEHICLES TEND TO BE WORK VEHICLES, WITH SOME OVER 10,000 POUNDS GVWR AND MANY EQUIPPED TO PULL LARGE TRAILERS.DUAL FAILURES OF HEAVILY LOADED VEHICLES AND VEHICLES PULLING TRAILERS FURTHER INCREASES THE SAFETY RISK.ODI PLANS TO CONDUCT TESTING TO QUANTIFY THE BRAKING AND STEERING PERFORMANCE DEGRADATION AND THE IMPACT ON SAFE VEHICLE CONTROL, WHEN A HYDROBOAST PUMP FAILS.

SERVICE BRAKES, HYDRAULIC

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .