RoadVitals

2006 GMC Topkick 8500

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Latest Aug 16, 2006
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2006 GMC Topkick 8500. 2 safety recalls have been issued covering this model year; and 125 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

2 campaigns cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
06V311000

SERVICE BRAKES, AIR

Aug 16, 2006
1,369 units potentially affected
The defect: CERTAIN TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." AN INTERNAL CONTROL AND CHECK VALVE WITHIN THE AIR BRAKE APPLICATION VALVE ASSEMBLY WAS CONFIGURED IMPROPERLY, PREVENTING AIR FROM FLOWING THROUGH THE BRAKE SYSTEM AS DESIGNED. IN THE EVENT OF AN EMERGENCY STOP, THE VEHICLE'S STOPPING DISTANCE WOULD BE INCREASED.
The risk: IF STOPPING DISTANCE WAS LIMITED, A VEHICLE CRASH COULD RESULT.
The remedy: DEALERS WILL REPLACE THE AIR BRAKE APPLICATION VALVE ASSEMBLY ON C-SERIES OR REROUTE THE AIR BRAKE LINES ON T-SERIES FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 20, 2006. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463 AND ISUZU AT 1-800-255-6727.
GENERAL MOTORS CORP.Manufacturer number 06077View on NHTSA.gov
06V254000

PARKING BRAKE:CONVENTIONAL:AIR

Jul 13, 2006
1,184 units potentially affected
The defect: CERTAIN MEDIUM DUTY TRUCKS EQUIPPED SR-7 BENDIX BRAKE VALVES, THE CHECK VALVE INSIDE THE VALVE CAVITY MAY NOT PROPERLY SET, CAUSING INTERNAL AIR LEAKAGE. IF THE CHECK VALVE DOES NOT PROPERLY SEAT, THE RESULTING LEAKAGE CAN CAUSE A DELAY IN THE APPLICATION OF THE SPRING BRAKES TO PARK THE VEHICLE AFTER OPERATOR PULLS THE DASH VALVE BUTTON.
The risk: THE DELAYED PARKING BRAKE APPLICATION CAN OCCUR WITHOUT WARNING, LEADING TO UNINTENDED VEHICLE ROLLAWAY INCREASING THE RISK OF A CRASH.
The remedy: DEALERS WILL INSPECT THE VALVES AND REPLACE IT FREE OF CHARGE. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463, OR ISUZU AT 1-800-255-6727.
GENERAL MOTORS CORP.Manufacturer number 06054View on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

PIP5601C

This PI communicates the requirement to provide a pico file to receive diagnostic assistance from TAC.

PIT5074R

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

PIT5074R

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

PIT5074R

This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.

02-00-89-002X

This service bulletin provides information for dealers/technicians on When and How to Submit a Field Product Report (FPR) (U.S. and Canada Dealers Only).

PIT3271P

This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection.

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.