EQUIPMENT:OTHER:LABELS
2026 Grand Design Lineage
Recalls, owner-reported complaints, investigations and safety data
NHTSA has issued a “do not drive” advisory affecting this model year.
Campaign 26V057000. Confirm whether your specific vehicle is covered using its VIN before acting on this.
Check your VIN on NHTSA.govOverview
Our database contains no NHTSA owner-reported complaints for the 2026 Grand Design Lineage. 9 safety recalls have been issued covering this model year; and 9 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Safety recalls
9 campaigns cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govELECTRICAL SYSTEM; EQUIPMENT:RECREATIONAL VEHICLE/TRAILER
EQUIPMENT:ELECTRICAL:ACCESSORY GENERATOR:SOLAR PANEL; STRUCTURE:CRITICAL FASTENERS
Recent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
No owner complaints recorded for this model year
Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
ELECTRICAL SYSTEM
This bulletin describes the procedure to install the Compressor Power Relay Upgrade on affected Lineage units. The upgrade routes the A/C compressor positive power feed through a dedicated 120-amp relay, removing the compressor load from the control board. The upgrade is supplied as SDG kit 5000041 (GDRV PN 710676). GDRV has updated the scope and instructions on this campaign.
ELECTRICAL SYSTEM
This bulletin describes the procedure to install the Compressor Power Relay Upgrade on affected Lineage units. The upgrade routes the A/C compressor positive power feed through a dedicated 120-amp relay, removing the compressor load from the control board. The upgrade is supplied as SDG kit 5000041 (GDRV PN 710676).
This bulletin describes the procedure to replace the plastic threaded pivot fitting on the rain shower head with a metal threaded pivot fitting on affected Lineage LVT1 units. The metal fitting addresses a failure of the plastic threaded pivot fitting as supplied by the shower head manufacturer.
This bulletin describes the procedure to relocate the LP solenoid power source from the chassis battery to the house battery on Lineage M-Series 25FW units equipped with an LP solenoid. The relocation uses retrofit harness EL-0189.
This bulletin describes the procedure to replace the plastic threaded pivot fitting on the rain shower head with a metal threaded pivot fitting on affected Lineage LVT1 units. The metal fitting addresses a failure of the plastic threaded pivot fitting as supplied by the shower head manufacturer.
ELECTRICAL SYSTEM
This bulletin describes the procedure to connect the 12-volt side of the water heater using harness EL-2031 (410536) on affected Lineage units.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.