2007 Harley-Davidson Flhrc

TL* THE CONTACT OWNS A 2007 HARLEY-DAVIDSON FLHRC. THE CONTACT STATED THAT WHEN THE REAR BRAKES HAD BEEN APPLIED SEVERAL TIMES THEY FAILED TO ENGAGE AND FUNCTIONED RANDOMLY. THE DEALER WAS NOTIFIED OF THE FAILURE, PROVIDED A COVER FOR THE BRAKE FLUID RESERVOIR BUT DID NOT PROVIDE A DIAGNOSIS TO PREVENT THE FAILURE. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND THE CONTACT WAS WAITING FOR A REPAIR SOLUTION TO BE PROVIDED TO A DEALER. THE CONTACT WAS NOT INCLUDED IN NHTSA ACTION NUMBER: PE16009 (SERVICE BRAKES, HYDRAULIC). THE FAILURE MILEAGE WAS NOT AVAILABLE.

NHTSA ID

10883916

Incident

Nov 10, 2010

WHILE CHANGING LANES ON THE HIGHWAY I ENCOUNTERED A WOBBLE IN THE STEERING. I CHECKED THE STEERING HEAD BEARING FOR PROPER ADJUSTMENT PER FACTORY SPECS AND FOUND IT TO BE PROPERLY ADJUSTED. I HAVE ALWAYS HAD THE SAME WOBBLE AND NOTED WHEN SPEED IS INCREASED THE WOBBLE APPEARS WITHOUT BEING PROVOKED WITH A LEAN ANGLE. I HAVE BEEN RIDING FOR 46 YEARS AND HAVE BEEN TEACHING MOTORCYCLE SAFETY FOR 13 YEARS. I HAVE NEVER HAD ANYTHING LIKE THIS HAPPEN ON ANY OTHER MOTORCYCLE (INCLUDING PREVIOUS HD SPORTSTER). THE BEST WAY I FOUND TO RECOVERING FROM THIS WOBBLE IS A EASY ROLL BACK OFF OF THE THROTTLE. HARLEY SHOULD BE FORCED TO RECALL AND FIX THE PROBLEM. I BELIEVE IT WOULD NEED A REVISED ENGINE MOUNT OR A ADDED STEERING DAMPENING STABLING SYSTEM. I PURCHASED MOTORCYCLE NEW AND HAVE NEVER RECEIVED ANY WARNING OF SUCH WOBBLE PROBLEM BEING REPORTED. I HAVE NOT MOVED, AND HAVE HAD MY MOTORCYCLE SERVICED AT THE DEALER WHEN IT WAS 2 WEEKS OLD DUE TO A SHAKE CAUSED BY LOOSE SPOKES OF THE REAR WHEEL, AS WELL AS A NEW REAR TIRE 2 YEARS AGO. *TR

NHTSA ID

10621181

Incident

Aug 7, 2014

Mileage

1,200 mi

IT START ABOUT A YEAR AGO, MY BIKE THEN HAD 25,000 MILE ON IT. IT WAS GETTING HARD TO START AFTER THE MOTOR WAS WARM. I CHANGE THE SPARK PLUGS, SPARK PLUG CABLES, IGNITION COIL AND BATTERY AND ITS WAS STILL HARD TO START. I TOOK THE BIKE TO THE DEALER WITH ABOUT 30,000 MILES ON IT AND THEY DIAGNOSE THE PROBLEM TO BE THE COMPENSATOR. HOW CAN A BIKE WITH 30,000 MILE ON IT HAVE A MAJOR POWERTRAIN PROBLEM AND COST ME $800.00 TO REPAIR?

NHTSA ID

10513570

Incident

May 22, 2013

Mileage

25,000 mi

I WAS RIDING MY 2007 HARLEY DAVIDSON ROAD KING CLASSIC AT APPROXIMATELY 60 MPH WITH A PASSENGER WHEN THE BOLTS HOLDING THE REAR SPROCKET TO THE REAR WHEEL STARTED BACKING OUT. THE HEADS OF THE BOLTS STARTED HITTING THE SWING ARM AND SHEARING OFF. AS THIS HAPPENED THE BIKE LURCHED VIOLENTLY AND WAS DIFFICULT TO CONTROL. I WAS ABLE TO SLOW AND PULL TO THE SIDE OF THE ROAD WITHOUT CRASHING. UPON INSPECTION THE BOLTS TORE UP THE REAR WHEEL HUB, THE SPROCKET, AND THE SWING ARM. I WAS LUCKY THAT THE BACK TIRE DIDN'T LOCK UP AND CAUSE ME TO LOSE CONTROL. MY BIKE HAS 24,000 MILES ON IT, I BOUGHT IT NEW, AND HAVE HAD ALL THE SERVICE AND TIRE CHANGES DONE AT THE DEALERSHIP THAT I BOUGHT IT FROM. I HAVE HAD EVERY SERVICE REQUIRED AND IN FACT IT WAS SERVICED ABOUT 100 MILES BEFORE THIS HAPPENED. AS FAR AS I KNOW THE SPROCKET HAS NEVER BEEN REMOVED FROM THE REAR WHEEL, IT DOES NOT NEED TO BE REMOVED TO CHANGE THE TIRE. IF YOU DO AN INTERNET SEARCH USING THE SEARCH CRITERIA "HD REAR SPROCKET BOLTS BACKING OUT" YOU WILL FIND THAT THIS IS A SERIOUS AND PERVASIVE PROBLEM THAT HARLEY DAVIDSON ISN'T ACKNOWLEDGING. I CAN SEND YOU PICTURES AND ACTUAL DESTROYED PARTS IF IT WILL HELP. *TR

NHTSA ID

10466374

Incident

Jul 5, 2012

Mileage

24,000 mi

TL* THE CONTACT OWNS A 2007 HARLEY DAVIDSON ROAD KING. THE CONTACT STATED THE BURNING FUMES EMITTED FROM THE ENGINE COMPARTMENT. AFTER INSPECTING THE MOTORCYCLE HE NOTICED THAT THREE DIFFERENT WIRE HARNESS MELTED. THE VEHICLE WAS TAKEN TO THE DEALER WHO WAS UNABLE TO DIAGNOSE THE FAILURE. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE VIN WAS NOT AVAILABLE. THE FAILURE AND CURRENT MILEAGE WAS 14,500.

NHTSA ID

10461619

Incident

Jun 6, 2012

Mileage

14,500 mi

I PURCHASED FRONT AND REAR TIRES FROM AN AVON VENDOR AT STURGIS, ND IN AUG 2010. 200 MILES LATER, ON MY WAY HOME, THE FRONT TIRE BLEW AT 70MPH. AFTER NEARLY CRASHING I MANAGED TO GET THE BIKE TO COME TO A STOP. AFTER RECEIVING A TOW I CALLED DAVID ALARI, THE DEALER WHO SOLD AND INSTALLED THE TIRES. ALL I WANTED WAS MY MONEY BACK FOR THE FRONT TIRE AND REINSTALLATION ($256). HE WOULD ONLY GIVE ME EXCUSES. I WILL VOICE MY DISGUST TO ALL WHO WILL HEAR, ESPECIALLY NEXT YEAR AT DAVID'S STURGIS LOCATION, HOW BADLY I WAS TREATED AND HOW DANGEROUS YOUR PRODUCT IS. *TR

NHTSA ID

10351821

Incident

Aug 12, 2010

Mileage

200 mi

THE ELECTRONIC CRUISE CONTROL ON THE 2007 HARLEY DAVIDSON ROAD KING FLHR FAILED TO DISENGAGE AFTER FRONT AND REAR BRAKES WERE APPLIED CAUSING LOSS OF CONTROL OF MOTORCYCLE IN A TURN CAUSING A CRASH AND SEVERE INJURIES TO RIDER. *TR

NHTSA ID

10331155

Incident

Jul 25, 2009

I BOUGHT A NEW HARLEY-DAVIDSON, AND FROM THE FIRST MILE IT HAS HAD A SEVERE PULL TO THE LEFT. I HAVE AN INDEPENDENT EVALUATION THAT CONFIRMS MY COMPLAINT. HARLEY-DAVIDSON REFUSES TO CORRECT THIS WARRANTY ISSUE. *TR

NHTSA ID

10212364

Incident

Apr 17, 2007

Mileage

1 mi

SERVICE BULLETIN M1684: MARKET SPECIFIC BATTERY INTRODUCTION. PURPOSE: Initial Release. This bulletin informs dealers of the availability of new batteries for new Original Equipment (OE) vehicle production and in the Parts and Accessories (P&A) catalog. Availability of the new Absorbed Glass Mat (AGM) batteries will vary by market and will be transitioning over the next few months. NOTE: The ring terminal screws are not compatible between Leoch and East Penn batteries. The new batteries will include new ring terminal screws, which must be used. The ring terminal screws from the old battery need to be discarded.

SERVICE BULLETIN M1650: MILWAUKEE EIGHT AND TWIN CAM CAMSHAFT DRIVE GEAR RETENTION KIT CHANGES. PURPOSE: This bulletin informs dealers that changes have been made to the Camshaft Drive Gear Retention Kit and service proceduresfor the Milwaukee-Eight and Twin Cam applications. In an effort to increase the clamp load of the camshaft drive sprocket bolted joint and prevent the drive bolt from loosening in high lift camshaft applications, the following changes have been made: a. The camshaft drive bolt final torque has been increased to 40 ft-lbs (54 N·m) for all Milwaukee-Eight and certain Twin Cams models. See Vehicles Affected. This increase in torque will make the bolt a one time use application. Never re-use a camshaft drive bolt for service after tightening to the increased specification. See service manual for updated procedure. b. A new camshaft drive gear retention kit (Part No. 91800088) has been created. This new kit is compatible with all Milwaukee-Eight and Twin Cam engines using Parts and Accessories (P&A) camshaft and Original Equipment (OE) camshaft applications. See Instruction sheet for specific fitment on Twin Cam OE camshaft applications. The new kit utilizes friction washers to prevent unwanted rotation of components in the drive sprocket bolted joint under stress. The use of liquid threadlocker on the threads of the bolt and pre-lube to the head of the bolt flange and outside of the washer help the bolt reach full stretch when tightening. NOTE: Engines produced at all Harley-Davidson Motor Company (HDMC) plants will not come with the new kits installed. They will continue to be produced with (Part No. 25566-06).

SERVICE BULLETIN M1555 (REV E): BATTERY WARRANTY GUIDELINES. PURPOSE: Revision E. Added: Added procedures for the DCA-8000 E Battery Tester.* Updated: All sections. This bulletin informs the dealership network that Harley-Davidson has provided guidelines for battery warranty.

SERVICE BULLETIN M1490 (V 24.8.8): DIGITAL TECHNICIAN II - UPDATES AND RELEASE NOTES. PURPOSE: This bulletin informs dealers that Harley-Davidson has made a software update to Digital Technician II (DT II). DIGITAL TECHNICIAN II (PART NUMBER: HD-48650). Version 24.8.8. Release Date: Week of August 5, 2024. New Features for Harley-Davidson vehicles: Advanced Module Replace for 2021 and later Revolution Max; 2023 and later CVO Touring; and 2024 Street Glide (FLHX), Road Glide (FLTRX). New Features for LiveWire vehicles: Updated calibrations for 2024 S2DM EV1/ EV6; 2024 S2MH EV1; and 2024 S2DM, S2MH. Changes: Added Hand Control Module (HCM) (Part No. 71500522A and 71500536A) for reflash support.

GENUINE MOTOR PARTS AND MOTOR ACCESSORIES BULLETIN PAB1158: OIL FILTER PACKAGING AND CASE QUANTITY UPDATE. PURPOSE: To inform dealerships that Harley-Davidson has made updates to oil filters including new part numbers, packaging design, and bulk case quantity changes.

SERVICE BULLETIN M1490 (V 24.6.4): DIGITAL TECHNICIAN II - UPDATES AND RELEASE NOTES. PURPOSE: Revision. This bulletin informs dealers that Harley-Davidson has made a software update to Digital Technician II (DT II). DIGITAL TECHNICIAN II (PART NUMBER: HD-48650). Version 24.6.4. Release Date: Week of May 1, 2024. New Features for LiveWire S2DM and S2MH, 2024 Revolution® Max, and 2024 Touring.