2019 Hyundai Veloster N

The contact's daughter owns a 2019 Hyundai Veloster N. The contact stated that the brake pads needed to be replaced and that the rear calipers were leaking brake fluid. The local dealer was contacted but the seals for the repair were not available. The seals were purchased from O’Reilly’s Auto Parts. The contact stated that the left-side cable had popped off, and the vehicle rolled back while in first gear. There was low compression in the engine. The contact associated the failure with NHTSA Campaign Number: 24V528000 (Fuel System, Gasoline). The contact stated that a compression test was performed. The vehicle was taken to the local dealer, where a leak-down test was performed for one minute, but the result was not provided. The dealer notified the contact of an extended warranty coverage. The dealer stated that the pump could not be replaced. The fuel pump was previously replaced. The contact stated that the crankcase was saturated with raw fuel and the vehicle was unsafe to drive. The dealer needed DTC: P0088 to be populated. The dealer requested that the vehicle be driven for 3,000 more miles before being taken back to the dealer. While receiving an oil change there was an abnormal fuel odor coming from the vehicle. The contact stated that the crank case was saturated with raw fuel. The contact was concerned about a potential fire. The manufacturer was contacted by phone. The failure mileage was approximately 114,941.

NHTSA ID

11766349

Incident

Sep 21, 2026

Mileage

114,941 mi

The contact's daughter owns a 2019 Hyundai Veloster N. The contact stated that the brake calipers were leaking brake fluid. There were no warning lights illuminated. The contact was able to obtain the parts from an independent parts supplier. The local dealer was contacted and confirmed that the caliper seals were ordered but were the incorrect part. The vehicle had not been diagnosed or repaired. The manufacturer was notified of the failure and opened a case. The approximate failure mileage was 114,000.

NHTSA ID

11759332

Incident

Jun 25, 2026

Mileage

114,000 mi

while driving at approximately 45 miles per hour electronic power steering system failed and and it felt like the motor in the steering column was trying to pull the car hard right. the EPS warning light on the dash flashed red. Safely stopped the car on the shoulder of road. turned car on and off and resumed driving. problem repeated (this time with steering trying to lock at center) another 1/2 mile down the road. stopped again and pulled and reseated apparently undamaged fuse in under hood fuse box. restarted car and switched drive mode from "normal" to "sport" which changes the cars EPS power assist profile. drove remaining 18 miles home without incident. currently trying to schedule service appointment with dealer.

NHTSA ID

11676118

Incident

Jul 24, 2025

The contact owns a 2019 Hyundai Veloster N. The contact stated while driving 45 MPH, the check the engine warning light illuminated. The vehicle was repaired under NHTSA Campaign Number: 24V258000 (ELECTRICAL SYSTEM); however, the remedy failed to repair the vehicle. The manufacturer was notified of the failure but offered no assistance. The failure mileage was 81,000.

NHTSA ID

11620668

Incident

Sep 30, 2024

Mileage

81,000 mi

The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.

The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.

This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Bluelink Service functions. This may be due to an irregular disconnection on Verizon’s communication network. Follow the procedure in this TSB to reestablish the connection via the AVN pinhole reset method.

Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Bluelink Service functions. This may be due to an irregular disconnection on Verizon's communication network. If you are experiencing issues with remote commands, or other Bluelink services, please see the instructions below to reestablish the connection via the AVN pinhole reset method.

Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Bluelink Service functions. This may be due to an irregular disconnection on Verizon’s communication network. Follow the procedure in this TSB to reestablish the connection via the AVN pinhole reset method.