RoadVitals

1997 International Harvester 4700 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
4
Newest Mar 6, 2003
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

4 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

03V083000

SEATS

Mar 6, 2003
2,418 units potentially affected
The defect: ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH BOSTROM DRIVER SEAT MODELS 910, 910SC, OR 914 AND INTERNATIONAL'S PARKING BRAKE CODE 04036, IF SOMEONE OUTSIDE THE CAB ADJUSTS/SLIDES THE DRIVER'S SEAT TO ITS MOST FORWARD POSITION, WITH THE PARKING BRAKE SET, THE SEAT WILL CONTACT AND RELEASE THE PARKING BRAKE LEVER.
The risk: IF THE PARKING BRAKE IS ACCIDENTALLY RELEASED, THE VEHICLE COULD MOVE UNEXPECTEDLY, INCREASING THE RISK OF A CRASH.
The remedy: DEALERS WILL INSTALL A STOP-BRACKET ON THE SEAT TRACK TO LIMIT THE TRAVEL OF THE SEAT SO THAT THE SEAT CANNOT RELEASE THE PARKING BRAKE LEVER. OWNER NOTIFICATION BEGAN ON MARCH 31, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
INTERNATIONAL TRUCK & ENGINE CORPORATIONManufacturer number 03503View on NHTSA.gov
96V240000

SUSPENSION:REAR

Nov 27, 1996
233 units potentially affected
The defect: VEHICLE DESCRIPTION: SCHOOL BUSES AND HEAVY DUTY TRUCKS EQUIPPED WITH REAR AXLE ASSEMBLIES PRODUCED BY DANA SPICER. CERTAIN REAR AXLE ASSEMBLIES WERE IMPROPERLY HEAT TREATED WHICH COULD ALLOW PINION BREAKAGE AT THE PINION THREADS.
The risk: CRACKS CAN INITIATE AND RESULT IN SEPARATION OF THE THREADED END OF THE PINION RESULTING IN SEPARATION OF THE YOKE AND DRIVE LINE FROM THE REAR AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT.
The remedy: DEALERS WILL REPLACE THE REAR AXLE CARRIER/PINION ASSEMBLY.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov
96V233002

SUSPENSION:REAR

Nov 22, 1996
1,133 units potentially affected
The defect: THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION.
The risk: THIS LOCKING TAB PREVENTS THE WHEEL BEARING NUT FROM LOOSENING DURING VEHICLE OPERATION. IF THIS TAB IS DEFORMED, THE NUT CAN LOOSEN ALLOWING THE WHEEL TO SEPARATE FROM THE AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT.
The remedy: DEALERS WILL REPLACE THE DRIVE AXLE HOUSING NUTS WITH A CONVENTIONAL WHEEL NUT HARDWARE SYSTEM.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov
96V154000

STEERING: STEERING WHEEL/HANDLE BAR

Aug 20, 1996
215 units potentially affected
The defect: THE STEERING COLUMN USED WAS INCORRECTLY MANUFACTURED. THE TUBE PORTION OF THE STEERING COLUMN HAS A WELDED END WITH A SPECIFIED LENGTH OF 5.5 INCHES. A 3.5 INCH WELDED END WAS USED BY MISTAKE. WITH THE SHORTER END, IT IS POSSIBLE THERE IS INSUFFICIENT ENGAGEMENT OF THE MALE END INTO THE TUBE PORTION AND SEPARATION OF THE COLUMN COULD OCCUR.
The risk: SHOULD THE COLUMN SEPARATE, THE OPERATOR WOULD LOSE STEERING CONTROL INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
The remedy: DEALERS WILL REPLACE THE INCORRECTLY BUILT STEERING COLUMN WITH A NEW CORRECTLY BUILT STEERING COLUMN.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .