RoadVitals

2000 Isuzu Fvr

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Latest Feb 12, 2002
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2000 Isuzu Fvr. 3 safety recalls have been issued covering this model year; and 25 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

3 campaigns cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov

POWER TRAIN:CLUTCH ASSEMBLY

Feb 12, 2002
1,368 units potentially affected
The defect: CERTAIN MEDIUM DUTY TILT CAB TRUCKS EQUIPPED WITH MANUAL TRANSMISSIONS HAVE A CONDITION IN WHICH THE CLUTCH MASTER-CYLINDER PUSHROD END THAT ATTACHES TO THE CLUTCH PEDAL PIN CAN WEAR PREMATURELY. THE FIRST NOTICEABLE EFFECT OF THIS WEAR COULD BE THE CLUTCH PEDAL NOT RETURNING COMPLETELY TO THE FULL-UP POSITION.
The risk: IF THIS OCCURS, THE FAST-IDLE ENGINE SPEED CONTROL MAY NOT FUNCTION. IF THE CLUTCH MASTER-CYLINDER PUSHROD END WEARS SUFFICIENTLY TO ALLOW THE ATTACHING END TO BEND OPEN OR BREAK OFF, THE PEDAL PIN WOULD DETACH FROM THE CLUTCH ROD LINK AND THE CLUTCH WOULD ENGAGE. IF CLUTCH ENGAGEMENT OCCURRED WHILE THE VEHICLE WAS STOPPED, WITH THE ENGINE RUNNING AND THE TRANSMISSION IN GEAR, AND IF THE BRAKES WERE NOT APPLIED, THE VEHICLE COULD MOVE FORWARD IF THE TRANSMISSION WERE IN A FORWARD GEAR, OR REARWARD IF THE TRANSMISSION WERE IN A REVERSE GEAR.
The remedy: DEALERS WILL INSTALL A NEW CLUTCH MASTER-CYLINDER ASSEMBLY AND CLUTCH PEDAL ASSEMBLY. OWNER NOTIFICATION IS EXPECTED TO BEGIN DURING APRIL 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT ISUZU AT 1-800-643-4070.
ISUZU MOTORS LIMITEDView on NHTSA.gov

STEERING:LINKAGES:DRAG:LINK:CONNECTION

Jun 15, 2001
203 units potentially affected
The defect: VEHICLE DESCRIPTION: COMMERCIAL VEHICLES EQUIPPED WITH AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS/DRAG LINKS. THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.
The risk: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE STEERING CONTROL, POSSIBLY RESULTING IN A VEHICLE CRASH.
The remedy: DEALERS WILL REPLACE THE DRAG LINK ASSEMBLIES. OWNER NOTIFICATION BEGAN DURING MAY 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT ISUAU AT 1-800-643-4070, EXT. 428.
ISUZU MOTORS LIMITEDView on NHTSA.gov

STEERING:LINKAGES:TIE ROD ASSEMBLY

Jun 15, 2001
203 units potentially affected
The defect: VEHICLE DESCRIPTION: COMMERCIAL VEHICLES EQUIPPED WITH TIE ROD ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.
The risk: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE PARTIAL CONTROL OF THE RIGHT FRONT WHEEL, POSSIBLY RESULTING IN A CRASH.
The remedy: DEALERS WILL REPLACE THE DEFECTIVE BALL SOCKETS AND/OR DRAG LINKS. OWNER NOTIFICATION BEGAN DURING MAY 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT ISUZU AT 800-643-4070, EXT. 428.
ISUZU MOTORS LIMITEDView on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

IB13-R-001G

This bulletin outlines the procedures for using the Alpine Exchange Program (the "Exchange Program"). The Exchange Program must be used when any Alpine radio or other component covered by this bulletin is repaired under warranty and may also be used for radio and component repairs not covered under warranty. Contact Alpine directly for pricing and payment methods applicable to radio and component repairs not covered under warranty.

WB13-X-001B

EQUIPMENT

Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback. This bulletin was revised to add a Parts Warranty Form

WB13-X-001A

EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL

Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback.

IB09-X-002B

EQUIPMENT

The following is a list of the Isuzu-recommended Threebond product part numbers identified in the various Isuzu Workshop Manuals and bulletins. If a Threebond product is unavailable, we recommend that you utilize the chart below to find equivalent of similar products (when available) from Loctite and Permatex.

IB09-X-004C

ENGINE AND ENGINE COOLING; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY

The Isuzu Commercial Truck of America (ICTA) Service Technical Assistance Center (TAC) provides diagnostic support to Isuzu dealer technicians repairing Isuzu vehicles in and out of vehicle warranty. A TAC case number will be issued solely for information tracking purposes and future contact reference.

020604041

FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM:FUEL RAIL

DIAGNOSTIC HINTS / TROUBLESHOOTING GUIDE FOR DENSO COMMON RAIL FUEL SYSTEM FOR CERTAIN MEDIUM DUTY TILT CAB AND COMMERCIAL MODELS. *TT

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

Isuzu Fvr by model year
YearComplaintsRecallsInvestigationsIssue Index
2026020
2025020
2024030
2023030
2022050
2009000
2008000
2007000
2006000
2005000
2004000
2002000
2001000
2000Viewing030
1999030
1998000
1997000
1996000
1995000
1994000
1993000
1992000

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.