2024 Jeep Gladiator Problems

Caught fire while driving

Electrical Fire Recall / NOT FIXED / Dealers and Jeep refuse to repair as there is no repair for it. Afraid to park this at home/work. Currently no signs other than steering feeling heavier over time.

Caught fire while driving

The contact owns a 2024 Jeep Gladiator. Upon research, the contact discovered that the VIN was included in NHTSA Campaign Number: 26V363000 (Steering); however, the part to do the recall repair was not yet available. The contact had not yet received the notification of the recall but was concerned about the fire risk associated with the recall. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure.

I. Dash lights go on and off intermittently 2. If you bump the gear shift lightly it comes out of gear.

The contact owns a 2024 Jeep Gladiator. The contact stated while driving approximately 40 MPH, the steering wheel became firm, and the check engine and battery warning lights illuminated. The contact stated that simultaneously, the temperature gauge rose to HOT(H) and remained on HOT(H). The vehicle was turned off and was towed to the dealer and the contact was informed that the alternator had failed causing the power steering and the battery failures. The contact was informed that the alternator needed to be replaced. The vehicle was not repaired due to parts not being available. The manufacturer was notified of the failure. The failure mileage was approximately 20,000.

This happened on a 2024 Jeep Gladiator. When parking I went to set the parking brake and as I pulled the handle I heard a pop and felt the handle release all pressure. With the handle up there was no braking effect. Dealer repaired by hooking the right wheel cable back onto the bracket located under the center console, and then adjusting.

My 2024 Jeep Gladiator Mojave has an ongoing brake issue that persists despite inspections by multiple dealerships. When starting the vehicle in the morning, the brake pedal is unusually hard and sits lower than expected, requiring excessive force before the engine will engage. Once the engine is running, pedal pressure returns to normal. For comparison, I also regularly drive a 2020 Jeep Gladiator and a 2023 Jeep Wrangler, neither of which exhibit this condition. Additionally, after driving for approximately one hour or longer, the vehicle experiences significant brake fade. Increased pedal pressure is required to slow or stop the vehicle, particularly during downhill driving. I routinely drive long distances between Seattle and Tucson and consider this a serious safety concern. In an attempt to address the issue, I spent several hundred dollars upgrading the braking system with ceramic brake pads and drilled rotors. While overall braking performance improved somewhat, the hard brake pedal during startup and brake fade issues remain constant and unresolved. I have worked extensively with two Jeep dealerships regarding this matter: Larry H. Miller Chrysler Jeep Tucson and West Hills Chrysler Jeep Dodge RAM. I also contacted a Jeep customer service representative, who advised that if dealership technicians could not identify a problem, then no issue existed. An independent mechanic suggested the symptoms may indicate a vacuum leak affecting the brake booster system, which could explain the excessive pedal force required during startup. However, to the best of my knowledge, neither dealership has performed a thorough investigation of the brake booster or vacuum system.

Premature clutch failure around 20,000 miles. It happened the first time the 4WD was engaged. Vehicle is in limp mode and cannot drive. There were no warnings prior to the issue. Previous year models have had NHTSA recalls issued for clutch failures.

I. Dash lights go on and off intermittently 2. If you bump the gear shift lightly it comes out of gear.

The contact owns a 2024 Jeep Gladiator. The contact stated that while attempting to shift the vehicle into first gear, the vehicle unexpectedly accelerated up to approximately 25 MPH without the accelerator pedal being depressed. There was no warning light illuminated. The vehicle was taken to the dealer; however, the vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure, and a case was opened. The approximate failure mileage was 11,000.

Date of Incident: [XXX] Time: [XXX] Location: Mount Pleasant, South Carolina Vehicle: 2024 Jeep Gladiator Rubicon X Mileage at Time of Incident: Approximately 11,000 miles System Involved: Adaptive Cruise Control / Braking System Speed at Time of Incident: 45 MPH in a 45 MPH zone Road & Weather Conditions: Dry, clear weather, good road conditions Description of Incident: While driving at approximately 45 MPH with the adaptive cruise control engaged, the traffic light ahead turned yellow. As I have done many times before in similar conditions, I applied the brakes firmly to slow and stop for the light. However, the vehicle did not slow down as normally expected. As the light turned red and cross traffic began entering the intersection, I pressed the brakes as hard as possible. The vehicle began to slow, and the tires felt like they were “hopping,” but the vehicle never came to a complete stop. Because I was now in the middle of the intersection with a red light and vehicles entering from other directions, I released the brake to avoid a collision. At that point, the vehicle lurched forward, and I realized the cruise control system was still engaged and was actively propelling the vehicle forward. A short time later, the cruise control system finally disengaged on its own. This malfunction nearly caused a serious accident. Under normal operation, pressing the brake pedal firmly at any speed should immediately disengage adaptive cruise control, but this did not occur. Dealer Response: Immediately after the incident, the vehicle was taken to the Mount Pleasant Jeep dealership, SC. The dealership’s technician connected a diagnostic code reader and stated there were no fault codes. They also checked for Technical Service Bulletins (TSBs) and stated none existed for this issue. The technician told me there was nothing further they could do. The dealership did not perform a road test, did not escalate the issue to the manufacturer. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 5

The vehicle is still new and has not been taken offroad other than a few boring unpaved roads. It has never hit any significant pothole. The tires still have the original OEM tire pressure, I have never removed or added air to them. At the time of the incident the tire pressure was 39psi and the temperature outside was about 80F. I was driving on the highway at about 75mph with cruise control. I started feeling a strange slight lateral instability then we heard a strong noise and we thought we had a helicopter on top of us or maybe that something else was loose in the car. As I was stopping in the shoulder it became clear that it was a tire problem as we saw pieces of tire flying off. Thankfully we were able to stop safely. Then it became clear what happened: the tire external sidewall just exploded with absolutely no reason. There was no pothole, no sudden braking or cornering. It just decided to explode. The car behaved very well given the gravity of the situation, but I lost trust in the Bridgestone Dueler H/T 245/75R17 tires that came with it. I'm no tire expert, but the broken tire sidewall construction seems very flimsy to me. This tire has no steel on the sidewall and it looks like the polyester threads is not appropriate and may even be missing in some areas. I took a large number of photos to what is left of the tire.