ENGINE AND ENGINE COOLING
2007 Kenworth T600 Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Data refreshed
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
14 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
POWER TRAIN:AXLE ASSEMBLY
SERVICE BRAKES, AIR
SUSPENSION
ENGINE AND ENGINE COOLING:ENGINE:DIESEL
TRAILER HITCHES:FIFTH WHEEL ASSEMBLY
TRAILER HITCHES:FIFTH WHEEL ASSEMBLY
TRAILER HITCHES:FIFTH WHEEL ASSEMBLY
ENGINE AND ENGINE COOLING
TRAILER HITCHES
FUEL SYSTEM, GASOLINE:DELIVERY
POWER TRAIN:AXLE ASSEMBLY
SERVICE BRAKES, AIR
STEERING:COLUMN
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
Driveshaft separates from tractor
SummaryOn July 13, 2010, the Office of Defects Investigations (ODI) opened an investigation on model year (MY) 2007-2009 Peterbilt tractors equipped with the (SPL170XL extended lube inter-axle driveline).ODI opened this investigation based on one Vehicle Owners Questionnaire (VOQ) and certain Peterbilt field reports.During the course of the investigation, ODI reviewed PACCAR's IR (October 22, 2010) response with associated data related to Warranty and complaint information, mined field data, interviewed customers and visited local dealers within the Washington Metropolitan area.PACCARconducted testing regarding torsional loading and identified various causative factors contributed to this safety defect finding.The Defect is a consequence of the bearing surfaces of the SPL170XL extended lube universal joint that attaches the inter-axle driveline to the drive axle becoming prematurely worn due to a breakdown of lubrication and/or excessive heat.Prematurely worn bearing surfaces may result in the u-joint becoming loose and/or binding.This condition may result in universal joint failure, allowing the inter-axle driveline to detach from the axle, which may cause the drive shaft to separate from the vehicle, increasing the risk of personal injury or property damage hazard.ODI learned that the affected population of the alleged defect extended to peer models within PACCAR.In summary, the following vehicles are being recalled: MY 2007 and 2008 Kenworth trucks, models T600, T660, T2000, T800 and W900 and MY 2007/2008 Peterbilt trucks, models357, 378, 379, 385, 386, 387, 388, and 389 allequipped with extended lube inter-axle drivelines manufactured by Dana Corporation.The recall affects vehicles manufactured between February 2, 2006 and April 30, 2007.At this time PACCAR has not yet identified a fix for the inner-axle safety defect and is currently conducting testing with the intent to provide a solution to the failure.ODI will monitor the development of PACCARS testing and ensure a timely repair for the consumer.This investigation is closed.
Horton Fan Hub Failures
PACCAR is conducting an Owner Notification Program (ONP) for select vehicles within the subject and peer populations.The ONP are attached to the closing report and can be found in the NHTSA Technical Service Bulletin (TSB) database. (TSB: 10033585, 10033584)See Closing report for investigation details.
REAR BRAKE AIR CHAMBER MTG BRACKETS
ON JUNE 23, 2009 PACCAR NOTIFIED ODI THAT 3,423 KENWORTH T2000, T800, T600, W900, AND T660 TRUCKS, MODEL YEARS 2004 - 2009, EQUIPPED WITH BENDIX BRAKES, WIDE BASE LOW PROFILE TIRES AND AIRGLIDE (AG) 400/460 REAR SUSPENSIONS ARE BEING RECALLED.CERTAIN OF THESE VEHICLES HAVE EXPERIENCED FATIGUE CRACKS IN THE BRAKE CAM TUBE MOUNTING OR AIR CHAMBER MOUNTING FLANGES BRACKET ADJACENT TO THE ATTACHMENT WELDS. IF LEFT UNREPAIRED, THE CRACKS CAN CAUSE A COMPLETE FRACTURE OF THE CAM TUBE, WHICH COULD DISABLE THE AFFECTED BRAKE AND RISK INCREASING VEHICLE STOPPING DISTANCES UNDER HIGH PRESSURE BRAKE APPLICATIONS AND DECREASE PARKING BRAKE CAPABILITY.THIS CONFIGURATION HAS EXPERIENCED FAILURES AT A HIGHER RATE THAN SIMILAR VEHICLES WITH OTHER TYPES OF SUSPENSIONS AND BRAKE INSTALLATION CLOCKING. PACCAR WILL ALSO SEND AN OWNER NOTIFICATION LETTER TO OWNERS OF VEHICLES EQUIPPED WITH SUSPENSIONS OTHER THAN THE AG 400/460, WHICH WILL PRESCRIBE A PERIODIC INSPECTION OF THE COMPONENTS AND IF A CRACK IS DISCOVERED, OFFER THE OWNERS THE OPPORTUNITY FOR A FREE REPAIR.THIS POLICY WILL BE IN EFFECT UNTIL JULY 15, 2014. COPIES OF THE RECALL AND THE OWNER NOTIFICATION ARE ATTACHED.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations
Data on this page last refreshed .