RoadVitals

2019 Keystone Raptor Problems

Owner-reported complaints filed with NHTSA, grouped by component

Data refreshed

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
2
Latest Aug 4, 2024
Components namedHow many of our component categories appear on at least one report for this model year. One report can name several.
3
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

What this page shows

Everything below is an owner-reported complaint submitted to NHTSA about the 2019 Keystone Raptor, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Reports by component

Ranked by how many owner reports name each component category

  • Body & structure133.3%
  • Electrical133.3%
  • Other / unspecified133.3%

Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.

Each component in detail

What the reports in each category say, in the owners' own words

Body & structure

Reports naming the vehicle structure, frame, body panels, doors, hood and trim.

1
report

From owner reports, verbatim

Component failed: while traveling at 65 mph on [XXX] the black tank (waste tank) fell from its mounting brackets and hitting the road way. At the time approximately 10 gallons on clean water was in the tank. No warning or way to know it dislodged from its brackets. I was flagged down by a passing motorist. How was your safety at risk: Routed under the waste tank there are approximately 12 power wires, generator fuel lines (connect to 30 gallon fuel tank) and propane lines. (120 gallons), When i came to a stop and surveyed the damage along side the road, i realized my generator was running, caused by arching/shorting wires. I had numerous hot wires sparking and arching. the tank fell forward out of its mounts and the front was dragging on the road way along with the underbelly insulation. The generator fuel lines were loose and pulled from their mounts, but fortunately were not leaking. After the vehicle was safely secured and removed from the roadside, it was taken to a Keystone dealer in Saco, Maine. The dealer confirmed the tanks slid from the mounts, the technician stated, when installing the new tank, he was able to move the mounting brackets inwards to better secure /hold the tank in place. My tank brackets were moved one inch inward. In short, the process to install the tank mounts in the correct position is not repeatable. Dealer charges were $1,509. supplies to secure tank and connect wires were ~ $200. I have invoice, unable to upload. The vehicle is available for inspection, although repairs have been made. No warning lights or messages or symptoms were given. the tank is not visible from the underside due to the chassis insulation and shielding. When posting my experience on the Facebook Keystone Raptor website, I learn of 5-6 others who experienced the same issue, include a video with a tank dragging down the roadway. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID 11606337 · filed Aug 4, 2024

Too few reports in this category for a page of its own — they appear in the full complaint list.

Electrical

Reports naming the electrical system — wiring, battery, charging, control modules, infotainment and electrical accessories.

1
report

From owner reports, verbatim

TL* THE CONTACT OWNS A 2020 (NA) KEYSTONE RAPTOR 425TS FIFTH WHEEL TRAILER. THE CONTACT STATED THAT THE TRAILER WAS NOT EQUIPPED WITH THE BONDING JUMPER CONNECTING WIRE THAT SHOULD BE LOCATED IN THE FUEL DOOR AREA. WITHOUT THIS CONNECTING WIRE, THE VEHICLE COULD CATCH FIRE WHEN REFUELING ANOTHER ITEM, SUCH AS AN ATV OR GOLF CART. THE MANUFACTURER WAS MADE AWARE OF THE DEFECT AND ADVISED THE CONTACT TO GO TO A LOCAL DEALER TO HAVE IT INSTALLED; HOWEVER, NO DEALER HAS BEEN ABLE TO ASSIST.

NHTSA ID 11246453 · filed Aug 26, 2019

Too few reports in this category for a page of its own — they appear in the full complaint list.

Other / unspecified

Reports whose component NHTSA recorded as unknown, or that do not map to one of the categories above.

1
report

From owner reports, verbatim

Component failed: while traveling at 65 mph on [XXX] the black tank (waste tank) fell from its mounting brackets and hitting the road way. At the time approximately 10 gallons on clean water was in the tank. No warning or way to know it dislodged from its brackets. I was flagged down by a passing motorist. How was your safety at risk: Routed under the waste tank there are approximately 12 power wires, generator fuel lines (connect to 30 gallon fuel tank) and propane lines. (120 gallons), When i came to a stop and surveyed the damage along side the road, i realized my generator was running, caused by arching/shorting wires. I had numerous hot wires sparking and arching. the tank fell forward out of its mounts and the front was dragging on the road way along with the underbelly insulation. The generator fuel lines were loose and pulled from their mounts, but fortunately were not leaking. After the vehicle was safely secured and removed from the roadside, it was taken to a Keystone dealer in Saco, Maine. The dealer confirmed the tanks slid from the mounts, the technician stated, when installing the new tank, he was able to move the mounting brackets inwards to better secure /hold the tank in place. My tank brackets were moved one inch inward. In short, the process to install the tank mounts in the correct position is not repeatable. Dealer charges were $1,509. supplies to secure tank and connect wires were ~ $200. I have invoice, unable to upload. The vehicle is available for inspection, although repairs have been made. No warning lights or messages or symptoms were given. the tank is not visible from the underside due to the chassis insulation and shielding. When posting my experience on the Facebook Keystone Raptor website, I learn of 5-6 others who experienced the same issue, include a video with a tank dragging down the roadway. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID 11606337 · filed Aug 4, 2024

Too few reports in this category for a page of its own — they appear in the full complaint list.

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .