2016 Land Rover LR4 Problems

am writing to formally request reimbursement in the amount of $18,397.76 for engine damage sustained by my 2016 Land Rover LR4 HSE LUX (VIN: [XXX] ), caused by a known defect in the factory-installed plastic outlet pipe. This defect directly led to catastrophic engine failure, leaving me stranded on the highway and incurring substantial repair costs. I purchased this LR4 as a Certified Pre-Owned (CPO) vehicle with an extended warranty in July 2019 from Land Rover Richmond, VA. From that time until the failure in October 2023, I drove the vehicle only 18,670 miles, the majority of which were accumulated during highway commutes from Virginia to Maryland for culinary classes between August and October 2023.The issue stems from a design flaw in the plastic outlet pipe used in many Land Rover and Jaguar models from 2013 through at least 2017. This pipe is prone to leaking and breaking at the seam due to its inability to withstand engine heat and pressure. As a result, it leads to coolant loss, engine overheating, and ultimately, engine failure. In my case, initial repairs to replace the pipe cost $4,228.54, but subsequent diagnosis revealed damaged cylinders and a failed engine, requiring full engine replacement at a cost of $14,169.22. I retained the damaged parts removed during the repair, including the failed plastic outlet pipe, and I have taken detailed photographs clearly showing the break at the seam where the leak occurred. These parts and images serve as physical evidence of the defect and support my claim that this failure was due to poor material design and not owner negligence. What is particularly troubling is that Land Rover North America was aware of this defect. A Technical Bulletin (JTB00566NAS4) was issued on May 23, 2018, detailing this exact problem—but only for Jaguar vehicles, despite the issue being identical in affected Land Rover models. Remaining letter attached as I ran out of characters. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I took my 2016 LR4 (55k miles) in to the dealer in San Antonio a few days ago. As part of the review of my vehicle, they suggested that I should replace the cylinder block coolant outlet pipe, even though there is no current issue with or damage to it, for a cost of $2,042.13. They said that this part is "known for catastrophic failure around this mileage." That statement (about being known for catastrophic failure) is made not only in the repair estimate option selector portal but also somewhat emphatically by the technician in the walk-around video of my vehicle, and it was reiterated by the service representative ("We try to give people the option to replace the parts with the updated design since we see them fail so often."). If there is a part in the LR4 that, at 55k miles - on a well maintained vehicle with no apparent issue associated the part - is expected by the dealer to break and cause "catastrophic damage," that seems pretty clearly a safety defect that Land Rover should address, not me. I did not have the work done because, as stated, there is nothing presently wrong with the part other than that the dealer believes based on what they have seen that it is likely to break and cause catastrophic damage. But I am nonetheless very concerned that this part is going to break in the near future, presumably rupturing and releasing all of the engine's coolant, and cause some sort of serious incident and/or accident. I am attaching the estimate - let me know if you would also like the walk around video by the technician (it is very helpful but I am having a hard time getting it off my iphone, because of the size, even after editing the clip).

Formal safety complaint against dealer for recall malpractice and non-compliance with federal safety repair procedures under Campaign 21V635000. During recall service, the service department completely bypassed the mandatory TOPIx Workshop Manual Section 310-01 electronic priming sequence, leaving high-pressure fuel rails completely dry upon reassembly. Bypassing this safety protocol introduced severe air pockets into the high-pressure fuel system. Time-stamped OBD diagnostic screenshots taken on the dealer lot right before departure confirm the vehicle's computer had already registered severe fuel pressure drops and engine misfires due to dry-running High-Pressure Fuel Pumps and injectors. This mechanical deviation caused the mechanical High-Pressure Fuel Pumps to fail internally and the Bank 2 fuel injectors to seize permanently wide open, resulting in continuous fuel dumping, fouled spark plugs, a destroyed oxygen sensor, and a total loss of motive power on a public roadway. Furthermore, the dealership generated federal recall compliance documentation certifying a quality-control test drive was performed when the official repair order shows identical "In" and "Out" mileage, proving the vehicle never left the service bay. The dealer refuses to remedy the related damage under federal guidelines and refuses to communicate a resolution. Due to intentional document falsification, consumer demands the manufacturer fund a $0.00 balance remedy executed at an alternate certified facility including: (1) Replacement of BOTH High-Pressure Fuel Pumps (HPFPs), (2) Replacement of all Bank 2 injectors, plugs, and oxygen sensor, (3) Crankcase oil flush due to fuel dilution, (4) Engine compression and emissions back-pressure tests, and (5) A written 12-month nationwide parts/labor warranty.

The contact owns a 2016 Land Rover LR4. The contact stated that while driving at 75 MPH the low coolant warning light was illuminated, the steering wheel became difficult to maneuver, the brake pedal was depressed and traveled to the floorboard without stopping the vehicle. The vehicle was shifted to neutral, and the start/stop button was depressed in order to stop the vehicle. The vehicle was towed to the dealer where it was diagnosed with cracks in the coolant and fuel systems that caused a leak and needed replacement. The coolant reservoir tank and fuel flange was replaced however the low coolant warning light and other lights were still on. The vehicle was then taken to a certified Land Rover repair facilities were the mechanic informed her that the coolant tank was not replaced but sealant was placed on the cracks. The independent mechanic replaced the coolant reservoir along with the brakes that the dealer that the dealer had install backwards. The contact stated that the low coolant warning light was still illuminated and that neither facilities could remedy the issue. The contact state that she received a notice for NHTSA Campaign Number: 21V635000 (Fuel System, Gasoline). The dealer was contacted and informed her that there was no recall for her vehicle. The contact stated that the manufacturer was notified and informed her to contact the dealer to schedule a recall repair appointment. The contact stated that while waiting for the dealer to verify the recall, she was driving at 75 MPH, when the power steering and braking capability was lost with smoke and fire coming from the engine compartment. The contact stated she pulled over and her and her child exited the vehicle without injury. The fire and police department were contacted. The fire department extinguished the flames. A police report was not filed. The vehicle was towed to the dealer where it sat for several months without repairs. The failure cause was not diagnosed or repaired. The vehicle was still at the dealer . The insurance company was

Engine MIL Illuminated With DTC P0089-64 Stored [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I had done a safety recall repair 'RECALL N623 FUEL TANK' on my 2016 Land Rover LR4 Landmark edition (32,051 miles) on 6-19-2022 at LAND ROVER PASADENA, 3485 East Colorado Blvd, Pasadena, CA 91107. Few days after they did the free recall fix I got the below error code 'P0442, Evaporative Emission system leak' that the dealership claims is not related to the recall fix that they did and wants to charge me $250 just to evaluate the issue. But I'm 100% certain this leak is some thing they didn't seal properly at the time of the recall. I'm very unhappy of the outcome and hope I can get this issue fixed without spending any money as before the recall I had no errors what so ever in this car and all started after the free recall fix.

The contact owns a 2016 Land Rover LR4. The contact stated while driving at an undisclosed speed, the low brake fluid warning light illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed that the brakes had failed and needed to be replaced. The vehicle was not repaired. The dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 117,000.

Complete failure of the electronic parking braking system which locked the wheels and could not be unlocked. Diagnosed by repair shop as requiring a replacement of the electronic parking brake module. Vehicle mileage is about 50,000. Part is about $1,000. I have a 2011 Land Rover LR4 which suffered from the same issue. VIN for that one is SALAG2D49BA569119.

MY 16 YEAR OLD SON WAS DRIVING THE 2016 LR4 THAT WE PURCHASED "PRE-CERTIFIED" LESS THAN 3 WEEKS AGO FROM FIELD'S LR IN NORTHBROOK ILLINOIS. GOING 68 ON THE HIGHWAY, THE WHEEL STARTED TO LOCK UP, THE GAS PEDDLE FAILED, AND SMOKE STARTED COMING THROUGH THE VENTS. HE WAS ABLE TO KEEP A COOL HEAD FOR A NEW DRIVER AND GET TO SIDE OF ROAD BY SHEER LUCK THAT THE ROAD VEERED TO THE LEFT. ONCE IN PARK MORE SMOKE CAME THROUGH VENTS AND HE AND HIS FRIEND JUMPED OUT AND RAN, WHILE THE ENGINE CONTINUED TO CATCH FIRE AND EVENTUALLY BLOW UP, AS SHOWN IN THE VIDEO BELOW. POST EXPLOSION PICTURES ATTACHED TOO.

WHILE DRIVING WITH MY FAMILY ON THE HIGHWAY, THE FOLLOWING ALERTS STARTED TO DISPLAY: CHARGING SYATEM FAULT; ABS FAULT; STABILITY CONTROL NOT AVAILABLE; EMERGENCY BRAKE ASSIST NOT AVAILABLE; TRANSMISSION FAULT. THE CAR THEN SUDDENLY DROP THE SPEED FROM ABOUT 45 MPH TO ABOUT 10 MPH, CAUSING A NEAR MISS WITH THE CARS BEHING US.THE ENGINE STARTED TO SHAKE AND VIBRATE AND SOUND ROUGH. I WAS ABLE TO PULL OVER BEFORE THE ENGINE QUIT AT ALL, AND THEN THE MESSAGE "LOW BATTERY, PLEASE START ENGINE" APPEARED. TRIED TO RE-START BUT THERE WAS NO REACTION ON THE CAR.

Excessive tire wear under normal conditions. Tires evaluated by service dept of local auto dealer as defective. Pirelli refused to honor implied warrantee as expressed by tire dealer after a two year delay in responding to request for a pro rated adjustment. Tires were unsafe early in their life cycle.

The upper dash board of the LR4 is made out of I believe leather. But it's shrinking and distorting so badly that I worry about the passenger side airbag deploying properly. It could affect it potentially 2 ways, first, doesn't deploy because it cant, or it deploys incorrectly. Either could have devastating consequences to the front passenger. I have done research on this and Land Rover knows this to be an issue, yet they want the customer to pay for the repair. I've read multiple accounts of other customers with this issue, sometimes Land Rover fixed it, others they did not. I have not been in an accident where this has been an issue, I'm concerned it will be an issue based on research. You are more than welcome to take a look and verify the issue. If need be, I can reach out to others that may have been impacted by this issue. As you can see in the images it's shrinking so badly that it's tearing the stitching out. Which then could put a bind on on the deployment of the airbag.

The contact owns a 2016 Land Rover LR4. The contact stated after reversing, he attempted to shift into drive(D) however, the gear shifter would not move and remained seized in reverse(R). There were no warning lights illuminated. The contact turned off the vehicle. The contact could not restart the vehicle as the gear shifter would not move into park(P). Upon investigating the issue online, the towing agent who arrived at the scene detached half of the console to reach the emergency release cable to move the vehicle. The vehicle was towed to the contact's residence. The dealer was notified of the failure and informed the contact that the electronic switch needed to be replaced; however, the part was not available. The contact contacted several unknown dealers who confirmed that the part was not available. The vehicle was diagnosed but not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 80,000.

MY 16 YEAR OLD SON WAS DRIVING THE 2016 LR4 THAT WE PURCHASED "PRE-CERTIFIED" LESS THAN 3 WEEKS AGO FROM FIELD'S LR IN NORTHBROOK ILLINOIS. GOING 68 ON THE HIGHWAY, THE WHEEL STARTED TO LOCK UP, THE GAS PEDDLE FAILED, AND SMOKE STARTED COMING THROUGH THE VENTS. HE WAS ABLE TO KEEP A COOL HEAD FOR A NEW DRIVER AND GET TO SIDE OF ROAD BY SHEER LUCK THAT THE ROAD VEERED TO THE LEFT. ONCE IN PARK MORE SMOKE CAME THROUGH VENTS AND HE AND HIS FRIEND JUMPED OUT AND RAN, WHILE THE ENGINE CONTINUED TO CATCH FIRE AND EVENTUALLY BLOW UP, AS SHOWN IN THE VIDEO BELOW. POST EXPLOSION PICTURES ATTACHED TOO.

The upper dash board of the LR4 is made out of I believe leather. But it's shrinking and distorting so badly that I worry about the passenger side airbag deploying properly. It could affect it potentially 2 ways, first, doesn't deploy because it cant, or it deploys incorrectly. Either could have devastating consequences to the front passenger. I have done research on this and Land Rover knows this to be an issue, yet they want the customer to pay for the repair. I've read multiple accounts of other customers with this issue, sometimes Land Rover fixed it, others they did not. I have not been in an accident where this has been an issue, I'm concerned it will be an issue based on research. You are more than welcome to take a look and verify the issue. If need be, I can reach out to others that may have been impacted by this issue. As you can see in the images it's shrinking so badly that it's tearing the stitching out. Which then could put a bind on on the deployment of the airbag.