2000 Lexus LX

Tire size is a P275 / 70 / R18 On 10/11/2025 I experienced a belt separation on my driver side rear tire which resulted in a noticeable bulge in the tread area. I had similar issues with two other matching tires in this set and one of them blew out leading to a rapid loss of air. I am sure if I wouldn't have been hyper-aware of early tell tale signs of this potential issue from the previous incidents, this tire may have also blown out on me. This is three out of the five General ATP tires in this set of five that have failed from the same belt separation issue.

NHTSA ID

11693882

Incident

Oct 11, 2025

A RAPID DISCHARGE OF BRAKE FLUID OCCURRED FROM THE ABS VALVE BODY ON THE MASTER CYLINDER. I DROVE THE VEHICLE THAT DAY AND PARKED IT IN THE DRIVEWAY. ABOUT AN HOUR LATER I WENT OUT TO MOVE IT AND WHEN I DID THERE WAS A LARGE PUDDLE WHERE IT WAS PARKED. I LOOKED UNDER THE VEHICLE AND FLUID WAS DRIPPING OFF THE FRAME RAIL ONTO THE GROUND. WHEN I OPENED THE HOOD I COULD SEE FLUID DRIPPING AT ABOUT A DRIP A SECOND FROM BELOW THE MASTER CYLINDER/ABS VALVE BODY. THE DRIP RATE WAS DEPENDENT ON THE KEY BEING IN THE 'ON' POSITION AND THE BOOSTER PUMP RUNNING. UPON CLOSER INSPECTION THE DRIP APPEARS TO POSSIBLY BE COMING FROM A PORT ON THE BOTTOM OF THE ABS VALVE BODY.

NHTSA ID

11382987

Incident

Dec 9, 2020

Mileage

195,000 mi

OWNER OF A NEWLY ACQUIRED '00 LX470 FROM TOYOTA/LEXUS. WHEN I PURCHASED THE CAR, IT PASSED SAFETY AND MECHANIC INSPECTION. AFTER OWNING FOR LESS THAN 4 MONTHS, I WAS DRIVING HOME ON STREET ROADS. THE ABS LIGHT COMES ON SUDDENLY, AND I HEAR A HIGH-PITCHED BEEPING NOISE FROM THE DASH. WITHIN 5 MINUTES OF DRIVING, I AM MOVING ABOUT 30 MPH WHEN THE BRAKES GO OUT-COMPLETELY. AS IN, PEDAL TO THE FLOOR WITH NO SLOWING. WAS FORCED TO BRING THE VEHICLE TO A STOP WITH THE EMERGENCY BRAKE, THANKFULLY WITH NO INJURIES OR CRASH. WENT TO GET A PROFESSIONAL INSPECTION AND WAS INFORMED THAT MY BRAKE MASTER CYLINDER/ACTUATOR HAD FAILED. THIS REPAIR IS VERY COSTLY, AND HAS SO FAR AMOUNTED TO NEARLY 5K TO FIX. UNSURE AS TO HOW TOYOTA HAS NOT RECEIVED CRITICISM FOR THIS POTENTIAL DANGER YET. *TR

NHTSA ID

11255741

Incident

May 15, 2019

Mileage

250,000 mi

HI THERE. HAVE BEEN A LATER OWNER OF A '00 LX470 WITH ROUGHLY 250K MILES. EARLY ON IN MY OWNERSHIP--WITH THE VEHICLE IN MOTION AND NO PRIOR WARNING-- THE ABS LIGHT COMES ON AND A LOUD BEEPING NOISE STARTS. WITHIN 5 MINUTES OF DRIVING, THE BRAKE PEDAL SUDDENLY GOES DEAD (PUSHES ALL THE WAY TO THE FLOOR), AND I WAS FORCED TO BRING THE CAR TO A SAFE STOP WITH THE EMERGENCY BRAKE. THE CURRENT REPAIR FOR THIS HAS BEEN COSTLY AND DIFFICULT--WITH A PROFESSIONAL SHOP INSPECTION INFORMING ME THAT MY MASTER CYLINDER/ACTUATOR HAS FAILED. THANKFUL NO DAMAGE WAS CAUSED TO OTHER VEHICLES. *TR

NHTSA ID

11255740

Incident

May 15, 2019

Mileage

250,000 mi

VEHICLE WHILE DRIVING AT SPEED OF 30 TO 50 MILES AN HOUR SUDDENLY HAS SINGLE WHEELED FRONT BREAKING ON LEFT WHEEL OR RIGHT WHEEL ALL OF A SUDDEN. TENDS TO FEEL LIKE WHAT THE BRAKING SYSTEM DOES DURING THE ACTIVATION OF THE VEHICLE SKID CONTROL SYSTEM WHILE DRIVING ON SLIPPERY SURFACES IN WINTER LIGHT CONDITIONS. THIS ALSO HAPPENS WHEN THE VEHICLE IS PUT INTO REVERSE AFTER FIRST STARTING ENGINE, SHIFTING INTO REVERSE AND BACKING UP SHORT DISTANCE. THE FACT THAT THE VEHICLE DOES IT WHILE DRIVING AT SPEEDS OF 30 TO 50 MILES AN HOUR IS QUITE DANGEROUS DUE TO THE FACT THAT IT HAPPENS ALL THE SUDDEN AND DRY PAYMENT. THIS HAPPENED AT HIGHWAY SPEED'S IN TRAFFIC WITH US COULD HAVE CAUSED AN ACCIDENT THOUGH I WAS ABLE TO SAFELY PULL OVER.

NHTSA ID

11191582

Incident

Mar 20, 2019

Mileage

211,500 mi

TL*THE CONTACT OWNS A 2000 LEXUS LX. THE CONTACT STATED THAT THE CHECK ENGINE AND CONTROL SYSTEM INDICATORS ILLUMINATED INTERMITTENTLY. THE VEHICLE HAS NOT BEEN TAKEN TO DEALER FOR A DIAGNOSIS. THE CURRENT MILEAGE WAS 85,000 ,AND FAILURE MILEAGE WAS 81,000.8AK

NHTSA ID

10186907

Incident

Jan 6, 2007

Mileage

81,000 mi

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. While Lexus paint quality, durability, and resistance to environmental factors is continuously being improved, it remains the responsibility of the dealer to protect and maintain the vehicle’s paint finish from the time of arrival at the dealership until retail delivery to the customer. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting. SUPERSESSION NOTICE The information contained in this bulletin supersedes Service Bulletin No. BO029-91. •The entire bulletin has been updated. Service Bulletin No. BO029-91 is obsolete

Vehicles may occasionally be subjected to contamination by airborne iron particles shed from railroad tracks, train wheels, exposure to heavy machinery facilities, grinding, welding, etc. This type of contamination can be identified by the presence of small, red or brown particles on the paint surface. These particles are often difficult to see on dark color paints but can be easily felt when brushing a hand across horizontal body surfaces such as the hood, roof, or deck lid. Follow the Repair Procedure in this bulletin to clean vehicles that may have been subjected to contamination by airborne iron particles such as rail dust during rail transportation or extended storage near industrial areas.

Vehicles may occasionally be subjected to contamination by airborne iron particles shed from railroad tracks, train wheels, exposure to heavy machinery facilities, grinding, welding, etc. This type of contamination can be identified by the presence of small, red or brown particles on the paint surface. These particles are often difficult to see on dark color paints but can be easily felt when brushing a hand across horizontal body surfaces such as the hood, roof, or deck lid. Follow the Repair Procedure in this bulletin to clean vehicles that may have been subjected to contamination by airborne iron particles such as rail dust during rail transportation or extended storage near industrial areas.

Lexus vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application. SUPERSESSION NOTICE The information contained in this bulletin supersedes Service Bulletin No. L-PG004-94. •The entire bulletin has been updated.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. While the quality and durability of paint on Lexus vehicles is continuously being improved, it remains the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

Lexus vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application. SUPERSESSION NOTICE The information contained in this bulletin supersedes Service Bulletin No. L-PG004-94. •The entire bulletin has been updated.