RoadVitals

2007 Mack Chn

Recalls, owner-reported complaints, investigations and safety data

Data refreshed

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
1
Latest Feb 14, 2011
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
12
Latest Oct 23, 2007
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains 1 NHTSA owner-reported complaint for the 2007 Mack Chn, most frequently naming the engine category. 12 safety recalls have been issued covering this model year; and 69 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

What owners report

Complaints grouped by the component NHTSA recorded

  • Engine1100.0%

Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.

Safety recalls

12 campaigns cover this model year

View all 12

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
07V497000

TRAILER HITCHES:FIFTH WHEEL ASSEMBLY

Oct 23, 2007
950 units potentially affected
The defect: ON CERTAIN TRUCKS EQUIPPED WITH A SAF HOLLAND SIMPLEX FIFTH WHEEL, THE LEVER ARM PIVOT BOLT MAY HAVE BEEN OVER TIGHTENED. AN OVER TIGHTENED PIVOT BOLT CAN DISTORT THE PIVOT BOLT SPACER SLEEVE, WHICH MAY PREVENT THE FIFTH WHEEL LATCH JAW FROM CLOSING AND LATCHING SECURELY AROUND THE TRAILER KING PIN.
The risk: THERE IS A POSSIBILITY THAT THE PIVOT BOLT CAN BECOME LOOSE WITHOUT THE DRIVER'S KNOWLEDGE. WHEN THIS OCCURS, THE DRIVER COULD DRIVE AWAY AND THE TRAILER COULD BECOME DISENGAGED, INCREASING THE RISK OF A CRASH.
The remedy: DEALERS WILL REPLACE THE PIVOT BOLT AND SLEEVE WITH A HEX HEAD SHOULDER BOLT AND WASHER FREE OF CHARGE. THE RECALL BEGAN ON JANUARY 28, 2008. OWNERS MAY CONTACT MACK TRUCKS AT 1-800-528-6586.
MACK TRUCKS, INCManufacturer number SC0331View on NHTSA.gov
07V401000

FUEL SYSTEM, DIESEL

Sep 5, 2007
35,649 units potentially affected
The defect: ON CERTAIN TRUCKS EQUIPPED WITH ASET AC MODEL ENGINES, THE ENGINE AS CONFIGURED WITH AN EXTERNAL EXHAUST GAS RECIRCULATION SYSTEM MAKES SERVICING THE FUEL INJECTION LINES DIFFICULT WHEN USING TRADITIONAL TOOLS. THEREFORE, IT IS POSSIBLE FOR FUEL LEAKS TO DEVELOP WHEN REMOVING AND INSTALLING THE FUEL INJECTION LINES.
The risk: A LEAK IN THE FUEL INJECTION LINE MAY SPRAY FUEL ON THE HOT SURFACES OF THE EXHAUST GAS RECIRCULATION SYSTEM, WHICH COULD RESULT IN AN ENGINE FIRE.
The remedy: DEALERS WILL REPLACE THE FUEL INJECTION LINES FREE OF CHARGE. NOTE: THIS RECALL SUPERSEDES A PREVIOUS CAMPAIGN CONDUCTED IN 2006 (PLEASE SEE 06V392). THE RECALL BEGAN ON SEPTEMBER 11, 2007, WITH SUBSEQUENT MAILINGS EVERY SIX WEEKS UNTIL APRIL 2008. OWNERS MAY CONTACT MACK AT 800-528-6586.
MACK TRUCKS, INCManufacturer number SC0324View on NHTSA.gov
07V361000

SERVICE BRAKES, AIR:SUPPLY:CHECK VALVE

Aug 15, 2007
21,847 units potentially affected
The defect: ON CERTAIN TRUCKS EQUIPPED WITH PARKER SINGLE CHECK VALVES (SCV) PROVIDED BY BENDIX. THE DEFECT EXISTS IN THE PARKER SCV THAT CONNECTS WITH THE SUPPLY PORT OF THE SR-7 SPRING BRAKE MODULATING VALVE. AFTER PROLONGED USE OF THE PARKER SCV, THE VALVE BODY RETAINER MAY BECOME EXCESSIVELY WORN AND EVENTUALLY BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE.
The risk: THIS CONDITION CAN CAUSE A DELAY IN THE APPLICATION OF THE SPRING BRAKES TO PARK THE VEHICLE AFTER THE OPERATOR PULLS THE DASH VALVE BUTTON. THESE CONDITIONS CAN OCCUR WITHOUT WARNING, LEADING TO UNINTENDED VEHICLE ROLLAWAY, BRAKE DRAG, OR IN THE CASE OF LOSS OF PRIMARY CIRCUIT, INABILITY TO MODULATE THE SPRING BRAKES.
The remedy: MACK IS WORKING WITH BENDIX TO REPLACE THE PARKER SINGLE CHECK VALVE. THE RECALL BEGAN ON JANUARY 9, 2008. OWNERS MAY CONTACT BENDIX AT 1-440-329-9000 OR MACK AT 1-800-528-6586.
MACK TRUCKS, INCManufacturer number SC0334View on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

Engine
Filed Feb 14, 2011

2007 MACK TRUCK CHN 613, 427 ASET AC ENGINE FAILURE DUE TO OIL PUMP DRIVE GEAR SPINNING LOOSE ON AUXILIARY SHAFT. WHEN THE VEHICLE BEGAN TRAVELING DOWN HILL, THE OIL PUMP DRIVE GEAR FAILED CAUSING AN IMMEDIATE LOSS OF OIL PRESSURE. THE ENGINE BECAME A CRITICAL INSTRUMENT IN CONTROLLING THE VEHICLE'S DOWN HILL SPEED PARTICULARLY THE ENGINE BRAKE FEATURE AKA THE "JAKE BRAKE". THE ENGINE BRAKE USES ENGINE OIL FLOW TO OPERATE. SINCE THERE WAS NO MORE OIL FLOW, THE ENGINE BRAKE WAS RENDERED UNUSABLE. AT THIS POINT, THE CHOICE WAS TO CONTINUE DOWN HILL AND RELY SOLELY ON THE VEHICLE BRAKES TO CONTROL THE VEHICLE SPEED, OR CONTINUE TO USE THE ENGINE WITHOUT THE ADDED BRAKING POWER OF THE ENGINE BRAKE KNOWING THAT THE ENGINE WOULD BE DESTROYED. THE DRIVER CHOSE TO DESTROY THE ENGINE AND NOT RISK HIS LIFE OR THE LIVES OF OTHERS. THE DEALER REFUSED TO REPAIR THE VEHICLE UNDER WARRANTY BECAUSE THE EECM INDICATED THE ENGINE'S MAXIMUM ALLOWED SPEED WAS EXCEEDED. FURTHER INVESTIGATION REVEALED THE PROBLEM IS INHERENT TO ALL ASET ENGINES BECAUSE THE OIL PUMP GEAR HELIX WAS CHANGED FOR THE NEW DESIGN ENGINE. THE AUXILIARY SHAFT DIRECTION OF ROTATION WAS REVERSED AND THE DIRECTION OF THRUST ON THE DRIVE GEAR FORCES THE DRIVE GEAR AWAY FROM THE REAR BEARING JOURNAL WHICH IT IS NESTED AGAINST. OLDER ENGINE DESIGN HAD THE DIRECTION OF THRUST TOWARD THE BEARING JOURNAL WHICH HELD THE GEAR IN PLACE. ANY CONDITION, (LIKE AN ENGINE OVERSPEED) THAT WOULD INCREASE OIL PRESSURE COULD DISLODGE THE GEAR. ACCORDING TO THE DEALER, AN ENGINE OVERSPEED CONDITION CAN ONLY OCCUR WHILE GOING DOWN HILL AND USING THE ENGINE TO CONTROL VEHICLE SPEED. IF THE HILL WOULD HAVE BEEN HIGHER, THE ENGINE MAY NOT HAVE BEEN ABLE TO CONTINUE TO SLOW THE VEHICLE AND A CRASH WOULD MOST LIKELY HAVE OCCURRED. THIS HAPPENED IN SOUTHEAST LOUISIANA WHERE HIGH HILLS ARE NON EXISTENT. HAD THIS HAPPENED IN A MOUNTAINOUS AREA, IT COULD HAVE BEEN DISASTROUS. MACK TRUCKS REFUSES TO DISCUSS THIS ANY FURTHER. *TR

NHTSA ID
10382644
Incident
Dec 20, 2010
Mileage
107,000 mi

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

CBR 2573-1 202604

POWER TRAIN

CBR - Mack Chassis - Through Shaft Bearing Retainer Breakage On Mack Carriers.

CBR 2488 072025

ELECTRICAL SYSTEM

CBR - A significant GPS reporting issue is affecting fleet operations, with trucks maintaining back-office communication but failing to transmit GPS location data.

CBR 407 072025

ELECTRICAL SYSTEM; SERVICE BRAKES

CBR - To correct the MID136 SID 66 FMI 7 fault code the latest Bendix VCP file will need to downloaded.

CBR-407 202409

SERVICE BRAKES

CBR: To correct the MID136 SID 66 FMI 7 fault code the latest Bendix VCP fi le will need to be downloaded.

CBR-2383 202406

ELECTRICAL SYSTEM; VEHICLE SPEED CONTROL

CBR - Accelerator Pedal: Inspection Instructions

CBR-202 202402

POWER TRAIN

CBR - Automated Manual Transmission ( AMT ) Flywheel Pilot Bearing Wear On Input Shaft.

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

Mack Chn by model year
YearComplaintsRecallsInvestigationsIssue Index
2008010—
2007Viewing1120—
20060130—
20050100—
2004070—
2003030—
2002020—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.