Reports submitted to NHTSA by owners and drivers, shown in full
Data refreshed
Our database holds 686 NHTSA owner-reported complaints for the 2010 Mazda Mazda3. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Showing 1–25 of 686 · page 1 of 28
The AT light came on the dash, added transmission fluid because it was a little low but the light still has not gone off. I think there is an electrical problem within the transmission. It's had shifting issues since purchasing this vehicle. I also have a small child that comes with me to work and I do not want my car to catch on fire while we are in this vehicle.
my girlfriend had bought a car from a dealership in Pennsylvania and the car is registered in Pennsylvania at a dealer called premier world wide auto sales. when she had bought the car all four of the tires i believe should have failed pa safety inspection and the owner of this shop keeps telling me that they pass one hundred percent even though the tires have signs of dry rot all the way around all four tires and would not stop giving me problems and trying to prove me wrong the dot codes show that the tires in the front were 10 years of age and the rear tires at 8 years of age and showing signs of dry rot the tire size all around is 205/55r16 and this is completely unacceptable for a business that has been operating for as long as its been operating because all i can think about is how many other cars has this dealership sold with dry rotting tires nor did they show my girlfriend when she bought the car any of the work that had been done by the shop that had done the inspection prior she was told that everything on this car was great and that there weren't any issues when infact that was not the case i found a leak coming from an engine oil pressure sensor and a cv axle boot torn and flinging grease along with the tires with none of this being disclosed to my girlfriend who bought the car shortly after
NHTSA Complaint Narrative I am filing this complaint regarding a 2010 Mazda 3, VIN [XXX] . The vehicle experiences intermittent transmission control failures, including difficulty shifting out of first gear and warning indicators triggered by vibration. The transmission and transmission control module have already been replaced. The dealership has identified the wiring harness as the cause of the remaining failure. Mazda North American Operations has confirmed that the required wiring harness (BBM9-67-020H) is discontinued and unavailable. However, Mazda has not provided a written determination of whether the known wiring harness recall (engine wiring harness chafing affecting control systems) applies to this VIN, nor confirmed recall completion history. Mazda has advised the customer to seek aftermarket or salvage parts, but has not provided an approved repair remedy or goodwill assistance despite the issue affecting drivability and safety. I am requesting that NHTSA review whether Mazda has met its obligations regarding: 1.recall applicability determination by VIN, and 2.providing an adequate remedy when OEM repair parts are no longer available for a safety-related defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
See attached document for complaint.
I have reason to believe the dealership I bought my vehicle from rolled back my odometer. Upon checking my carfax information, 12/01/24, the odometer read 161,142, which the dealership did own my vehicle at this time. When I bought this car in April of 2025, the odometer was reading 130,000.
On August 15, 2025, my 2010 Mazda 3 began displaying the ABS warning light intermittently while driving. The ABS system is a critical safety feature, and when the light comes on, I am unsure if the braking system will function properly in an emergency. I scanned the vehicle using a Foxwell diagnostic tool and retrieved the following ABS-related fault codes: C0020:1C-2B – ABS Pump Motor Control Circuit U0425:62-60 – Invalid Data Received from IPC/ABS Control Module U0140:00-28 – Lost Communication with Body Control Module These issues are consistent with Mazda Technical Service Bulletin 04-002/13 (July 17, 2013), which documents ABS pump motor failures caused by poor motor brush contact. This is a serious safety concern because the ABS system fails without warning, leaving the driver and passengers at risk of brake loss in critical conditions. Why this should be investigated: The defect occurs intermittently, making it difficult to predict or reproduce. It matches a known documented defect acknowledged by Mazda in TSB 04-002/13. Other owners have reported similar ABS pump failures in Mazda vehicles of this generation. The failure compromises safe braking and should be treated as a safety defect warranting investigation and possible recall. Action Requested: I am requesting that NHTSA investigate this recurring ABS pump/motor failure in 2010 Mazda 3 vehicles and determine whether a recall should be issued to address this known defect.
The a.b.s pump module is defective in these vehicles. There are tons of people having issues with them. When they fail it happens suddenly resulting in brake failure, power steering failure, the car does not like to shut off, the vehicle will go into "limp mode" and every light on the dash comes on. The part itself is costing close to $1000 u.s.d . With all of tge effected things tgat go with it i believe it can be very dangerous and should be recalled
This vehicle is subject to recall #: 17V-082 referring to a drivers seat lifter link than can break. My car has a broken lifter link, was brought to the dealership and instead of replacing the entire seat adjuster unit like the recall states, they simply installed a reinforcement bracket. When brought back to Med Center Mazda they state it has already been repaired and therefore cannot be repaired again. The vehicle still has a broken seat lifter link.
Transmission slipping. Not shifting correctly.
I purchased two tires from Les Schwab in Molalla, OR on 1/15/25 in which upon them changing the tires they damaged one of my TPMS sensors and they did not replace it. I didn't have a warning light before I went in and now I do and they knowingly did not replace it when TPMS sensor service was part of purchasing the new tires. Instead they quoted me $451.96 to replace the sensors in all 4 tires other than replaced the one they broke. A set of TPMS sensors online cost $28, this is unethical of them to take advantage of consumers like this and they should be held accountable. If I'm not mistake it says in "49 USC 30122(b)" that "Prohibition.-A manufacturer, distributor, dealer, rental company, or motor vehicle repair business may not knowingly make inoperative any part of a device or element of design installed on or in a motor vehicle or motor vehicle equipment in compliance with an applicable motor vehicle safety standard prescribed under this chapter unless the manufacturer, distributor, dealer, rental company, or repair business reasonably believes the vehicle or equipment will not be used (except for testing or a similar purpose during maintenance or repair) when the device or element is inoperative." 205/55 R16
Transmission control module issues. Car was driving on the expressway and wouldn’t shift out of second gear. Engine light and AT light came on. Had to drive slowly on the expressway and get off on the closest exit. Cars were speeding past me and I had to be careful not to get hit. Research and shop shows the 2010 Mazda 3 vehicles have lots of issue with the TCM because they get hot due to there location.
Tha dashboard is melted causing glares on very sunny days and makes driving difficult.
ABS or the ABS computer malfunction or wasn't working correctly and almost cause an accident.
my Mazda 03 dashboard is melting, and I am not able to see out the window... I have talked to dealer and manufactory, and they will not pay the whole amount knowing it's a safety issue. I don't understand how they can sell product on car that is malfunctioning and a safety issue. I bought the car brand new in 2010 and didn't have any issues until this year. Please call me back at [XXX] my name is [XXX] . I was not in an accident, just think this is a safety issue. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
While driving on the interstate, the driver’s side airbag deployed without any obvious cause. There was no pothole, bump, or clear reason for the airbag to deploy. There was moderate traffic. This put myself and others nearby at risk by causing me to flinch after getting hit by the airbag. I was lucky to not swerve into anything or cause any damage. It caused temporary loss of hearing and a sore neck, but no serious injury. Prior to the failure, there were no dash lights, messages, or other symptoms.
ABS module malfunction all four wheel speed sensor not read in the same time and powersteering cut off cause by unready wheel speed check engine light ABS light and Steering Light on.
ABS will cause complete brake failure when it is engaged. For example, needing to stop quickly to avoid hitting another vehicle and the brakes will lose all pressure and the vehicle will not stop. Several mechanics have not been able to diagnose or fix. Immediately after the incident, there will be minimal brake pressure of about 20%, eventually it will return to normal. Must avoid applying brakes in emergency situations as it will actually be worse than attempting to steer out of it. This has happened about 6 times in 4 years. It happened the first time about 3 days after I bought the vehicle in 2019.
TCM has failed to communicate in engine. Car doesn’t not shift properly or has hard shifts if it is able to get back into gear. Car may experience AT engagement making it hard to steer and control vehicle. Can happen in the middle of driving. Independent service Auto mechanic shop Vehicle has no warning lights indicating failure until hard shift when driving 50miles per hour and engine would no longer speed up AT light then came on. Once parked for two days check engine light came on and vehicle no longer would shift into gear.
Fuel is leaking from the top of the gas tank, which is a very dangerous issue.
ABS LIGHT STAYS ON, BREAK LIGHT STAYS ON. ABS is not working.
Power Steering sometimes works and sometimes not. Can go out and stop working or start working, in the middle of driving. i noticed Mazda has a recall for 2007, 2008, 2009 Mazda 3 cars, but *NOT* 2010 Mazda 3. I suspect the same issue.
The dashboard adhesive migrates to the surface of the dashboard. Adhesive then sublimates and condenses on the windshield making a glaze on the windshield, making it extremely difficult to see the road in sunrise or sunset conditions. I've repeatedly cleaned the windshield with many different cleaners including acetone, but at best I am only able to improve visibility, not restore it. In the attached photo, the upper portion of photo illustrates the film of adhesive on the glass after it was wiped with a clean paper towel, creating a hazy appearance. The entire windshield was cleaned with acetone and heavy duty degreaser and window cleaner prior to the photo.
The contact owns a 2010 Mazda Mazda3. The contact stated that the adhesive tape on the instrument panel was melt, making it difficult to see the instrument panel. The vehicle was taken to the dealer who stated that the instrument panel needed to be replaced. The vehicle was not repaired. The manufacturer was contacted and made aware of failure. The contact was informed that an Extended Warranty for the failure had expired. The failure mileage was 105,000.
Monday 7/10/2023 car was fine ie (the seat) next day Tues 7/11/2023 opened drivers side door couldn’t believe my eyes. The driver seat had somehow migrated clear up to an inch from my chest to the steering wheel. I called Maple Shade Turnersville to make an appointment-wasn’t able to get in until 7/20/2023. I was told I had to return on 7/24/2023. Did that. Appt was 7:30AM. Was given a loaner car. At around 10:30 Am Mazda Tuenersville called to ask me to return the loaner (?). When I arrived Pat Kearny told me he couldn’t do anything to help with the car seat. Told me my car was too old that they didn’t make parts for my 2010 Mazda 3 for the already recalled seat problems. Now I’m in a big bind. My steering wheel is one inch from my chest. I am very upset what happened here.
Mon-7/10/2023 used the car. Tues 7/11/2023 attempted to use my car opened the door on the drivers side-saw a bizarre position of the seat. It had somehow migrated during the night to approx 4” from the steering wheel when I try to get into the seat my chest stomach area is an inch away can’t reach the pedals very well because my right knee is up against the dashboard. Took the car to the dealership the man in charge told me there’s nothing they could do the car is too old. He told me to take it to an independent repair shop to get the parts from junk yard. Said he would have to cut the bolts on the seat track said he couldn’t do that. Please see the photos and video.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .