2022 Mercedes-Benz AMG GLB35

According to a MB USA representative, the warning light instructing me not to drive over 50 miles per hour was related to my suspension. In addition to the warning light, I have repeatedly expressed my concerns about a loud creaking noise coming from the wheel area while driving, turning the corner, pulling in and out of driveway, etc. However, South Bay Mercedes is never able to duplicate the noise or identity the warning. I have also contacted MB USA on multiple occasions and they confirmed that I have three (3) open cases, but refuse to provide me with the case number and fail to respond as stated during each call. The suspension warning light has been coming on, intermittently, a few months after I purchased the vehicle and South Bay Mercedes only suggested a tire change and service appointments while blatantly disregarding the problem. Now I am getting a warning light that states, Service Required Do Not Shift Gears Visit Dealer. I have had this car less than a year as it was purchased brand new, and South Bay Mercedes/MB USA have been giving me the runaround for months; only corresponding to schedule upcoming service appointments. I have since changed my front tires, but continue to get warning messages. I have repeatedly expressed concerns about my safety and never received a response from MB USA.

NHTSA ID

11508462

Incident

Jul 19, 2022

I purchased my car in April of this year 2022 and have driven less than 10K miles. The tread of my front two tires has already worn down to less than 3/32 compared to the rear wheel 6/32. Driving conditions are normal and according to Mercedes this is known issue. This exceeds normal wear and tear and should be a safety concern.

NHTSA ID

11497272

Incident

Dec 10, 2022

This NCU replaces the prior NCU issued on May 15, 2025, and contains additional MY 2023 and MY 2024 vehicles which are highlighted below. In our continuing efforts to ensure the proper performance of Mercedes-Benz products and to enhance the satisfaction of our customers, Mercedes-Benz USA, LLC (“MBUSA”) is extending the warranty coverage on the Diagnostic Module for Tank Leakage detection (DMTL) in certain Model Year (“MY”) vehicles listed below from the original New Vehicle Limited Warranty of 4 years/50,000 miles to 10 years/120,000 miles (vehicles certified as LEV II) and 15 years/150,000 miles (vehicles certified as LEV III), whichever occurs first, for the following condition: •Under certain circumstances, the DMTL may trigger erroneous Diagnostic Trouble Code (DTC) entries that may result in the illumination of the Check Engine Malfunction Indicator Lamp (‘MIL’).

Complaint CEL light on with no drivability concerns. Cause Signal timing error. Remedy 167, 465: SW has been released. Update the FSAM to the latest SW version. 290, 118, 243, 247: Software is still in development. This fault code does not cause a drivability concern and will clear itself within 2-3 key cycles. The vehicle can be released back to the customer.

Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end). The noise is heard once in each instance when changing direction of travel. Note: Sound file in attachment Cause If the complaint is eliminated by experimentally loosening the outboard collar nut (by 1 turn), the problem is due to cracking of the microweld between the wheel bearing inner race and the joint housing of the side shaft. Note: The collar nut must always be replaced after being loosened. See also LI33.20-P-078406 Remedy Coat contact surface of side shaft with wheel bearing with Molykote paint. To do this, proceed as follows: 1. Remove side shafts 2. Clean contact surface A (see image file in attachment "Outer joint housing before") before coating with Molykote, using "spirit" (free of dust and grease) 3. Coat contact surface A (see image file in attachment "Outer joint housing after") with Molykote and leave to dry for "one hour" in removed condition 4. Reinstall side shafts Note: Before using the antifriction coating (Molykote), stir it or shake it thoroughly for (at least 1 minute).

Complaint Radio station cover art does not refresh when switching stations. The UI continues to show the old station’s artwork instead of updating to the new one. Cause When a new station change request is triggered, a temporary glitch is causing the Head Unit application to fail to overwrite the previous request. This glitch is causing the cover art mismatch in the Radio application. Remedy Please do not replace any parts. The E505.9 software is released and available in XENTRY Q3 2026.

Complaint CEL light on with no drivability concerns. Cause Signal timing error. Remedy 167: SW has been released. Update the FSAM to the latest SW version. 465, 290, 118, 243, 247: Software is still in development. This fault code does not cause a drivability concern and will clear itself within 2-3 key cycles. The vehicle can be released back to the customer.

Dear Mercedes-Benz USA Dealers, The part numbers listed in the chart below should no longer be installed, and any existing stock must be returned to your facing PDC. The deadline for all dealer returns is no later than Thursday, July 9, 2026. After July 9th, returns of these parts will no longer be accepted. These parts should be returned via ZSR Special Return, using item category SCM Authorized Part Return. Please include a copy of this NCU as your authorization to return these parts. This procedure will not affect your return allowance. All returned parts will be replaced in accordance with the chart provided below.