Corrosion of Third-Row Seat Attachment
Opened Apr 23, 2012
Closed May 2, 2013
Ford is conducting a safety recall to repair the third-row seat's latch mechanisms in approximately 196,667 model year (MY) 2004 through 2007 Ford Freestar and Mercury Monterey vehicles (see NHTSA recall 13V-081 for more details).The recall covers vehicles originally sold, or currently registered, in the salt belt states or high corrosion areas of the United States: Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, and Wisconsin.Approximately 100,000 remaining MY 2004-2007 Freestar and Monterey vehicles--those vehicles that were not originally sold, or are not currently registered, in salt belt states--are not included in the recall action. Although these vehicles are the same as the ones described above, they experience significantly lower failure rates because of reduced road salt exposure.ODI is currently aware of only one complaint on vehicle outside of the recall scope.ODI will monitor complaints and take further action if warranted by the circumstances.For owners of vehicles that are outside of the recall scope but exhibit the defect condition, owners (and affected Ford dealers) can contact Ford to request the recall repair.This Engineering Analysis is closed.See attached report and associated recall file for additional information.The ODI reports cited above can be reviewed online at http://www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification numbers: 10399896, 10410491, 10420028, 10424850, 10433928, 10436592, 10438529, 10440616, 10441489, 10441641, 10442809, 10446564, 10450295, 10450559, 10450587, 10452933, 10453826, 10454977, 10455545, 10456985, 10457423, 10457910, 10458738, 10459042, 10460511, 10461074, 10462910, 10463126, 10463262, 10463366, 10463600, 10464243, 10467003, 10467680, 10468429, 10469188, 10469200, 10470216, 10470510, 10471280, 10471520, 10471813, 10471978, 10472514, 10473087, 10473159, 10477025, 10477387, 10477954, 10478449, 10479247, 10479758, 10480611, 10480665, 10481054, 10481412, 10482213, 10482236, 10482613, 10482620, 10487872, 10489445, 10490515, 10490641, 10490663, 10490744, 10491495, 10492220, 10493470, 10493572, 10496348, 10497631, 10497976, 10498310, 10498433, 10499681, 10499861, 10500495.
SEATSLed to recall 13V081000 PE11033ClosedPreliminary Evaluation Service Jack Failure
Opened Sep 13, 2011
Closed Dec 7, 2012
The subject vehicles (SV) are all automatic transmission, front wheel drive vehicles with hand actuated mechanical park brakes. The investigation focused on allegations that the service jack failed and caused the vehicles to fall. The subject scissors-type jack appears to fail at the slotted hinge joints where the jack screw is located (bends at mid-point). The failures occur while the jack is in use, and vehicle movement (forward or backward) is typically reported coincident with the failure. Ford reported that most MY 2003 Windstar and all MY 2006-2007 Freestar/Monterey also use the subject jack, an additional 223,246 vehicles.NHTSA has received six consumer complaints (VOQs) involving three injury incidents and a fatality.Ford reported 26 complaints for the SVs involving an additional 4 injuries. In the fatal incident, the van fell on a person working on the engine under the otherwise unsupported vehicle; ODI was unable to determine whether the vehicle was adequately chocked or the park brake was properly set. Reported injuries include a broken arm, head and hand injuries, arm and rib bruises, and muscle strains. NHTSA has received just one new report since opening this investigation. The complaint trend in ODI and Ford data is flat if not declining.Ford provides instructions and warnings in the owner's manual, on a placard placed with the jack, and on the jack itself. These instruct consumers to put the vehicle gear selector in Park, properly set the parking brake, chock the opposite wheel, use the jack only for changing a tire, loosen the lug nuts prior to jacking, and to not get under a vehicle supported by the jack only (NHTSA also recommends that jacks only be used for tire changing).In the VOQs, roughly half the consumers were using the jack for something other than tire changing, half had not chocked a wheel, and half had not properly set the parking brake. ODI notes that since the front wheels are drive wheels (with an open center differential) the Park gear cannot provide vehicle stability (longitudinally) when a front wheel is raised. All NHTSA complaints and most of the complaints to Ford involved failures while a front wheel was raised.In response to ODI's inquiry, Ford conducted testing on a 2004 Freestar. Ford's tests showed that when a front tire was raised the service jack held without failing under various scenarios except when a rocking force was applied and the parking brake was not properly set. Based on its testing and its analysis of field data, Ford concluded that the type of jack failure evidenced in this investigation (bending at mid-point) was likely caused by vehicle movement due to an improperly secured vehicle, or other misuse of the jack. Ford notes that rates in this investigation were similar to those in another investigation (EA91-049) which ODI closed. ODI also analyzed jack data for MY 2003 and newer vehicles to compare to the SV population. To assist with this analysis, ODI requested data from the jack manufacturer (actually its successor company) who provided limited data but did identify other models using the same design jack. ODI was unable to identify a significant difference in the incidence of jack failures (including those involving bending failures) between the SVs, other vehicles which used the same jack, or other vehicles where the jack type was unknown or different.A safety-related defect has not been identified at this time and further use of agency resources does not appear to be warranted.Accordingly, investigation PE11-033 is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist and ODI reserves
EQUIPMENT:MECHANICAL:ACCESSORY SCISSOR/SCREW/BOTTLE JACK/LIFT
PE10033ClosedPreliminary Evaluation Engine Stalling
Opened Aug 23, 2010
Closed Jul 15, 2011
The subject vehicles suffered from a design issue whereby water could run down onto the cowling under the hood and located in the area of the windshield wipers and then drip onto a computer module, the Powertrain Control Module (PCM), which could be manifested in a variety of symptoms depending on which part of the circuit board became wet or which of the connector pins shorted out.In addition to causing an engine to stall, which may or may not then restart, the water intrusion could also cause the transmission to shift poorly, the vehicle to have erratic power, a malfunction indicator light to come on, or result in an inability to start the vehicle, an inability to shift the vehicle into either forward or reverse. Also the problem could cause a higher than normal idle RPM in Park, or for the radio to malfunction, or the interior lights to stay on.During this investigation ODI was concerned with the effect of the engine stalling or a drastic and sudden loss of power either of which may create a safety risk.In reviewing the actual number of these types of incidents, collectively referred to here as engine stalls, the number was found to be below what would be considered a defect trend.For example, the number of engine stalls identified in Ford's warranty claims for the model year (MY) 2004 subject vehicles, the MY with the most failures, was 200 out of population of 125,865, for a failure rate of 0.16%.The one crash recorded by a complainant to NHTSA, VOQ 10311522, alleged that the engine stalled, due to water intrusion into the PCM, while the road was turning causing her to go off the road and according to the police report the vehicle then hit an embankment and a tree stump. Ford reported in their response that there were three alleged crashes but none of these were validated as being caused by a problem with water intrusion into the PCM causing a stall.Accordingly this investigation is closed.The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist.The agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and take further action in the future if warranted.
POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM)