SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM
2012 Mitsubishi I-Miev Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Data refreshed
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
6 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE
AIR BAGS
SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM
SERVICE BRAKES; SERVICE BRAKES, HYDRAULIC:POWER ASSIST
AIR BAGS:FRONTAL:SENSOR/CONTROL MODULE-INACTIVE
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
Brake Vacuum Pump Failure
On May 10, 2019, the Office of Defects Investigation (ODI) opened Recall Query RQ19-002 to investigate three complaints alleging brake vacuum pump failures after the remedies for Recalls 13V-031 and 14V-522 had been completed in model year (MY) 2012 Mitsubishi i-MiEV vehicles. The investigation was opened on model year (MY) 2010 through 2017 Mitsubishi i-MiEV vehicles to cover all products sold in the United States with the same vacuum pump (Recall 14V-522 included MY 2010 through 2014 i-MiEV vehicles). Mitsubishi Motors North America, Inc. (MMNA) provided information about nine (9) additional reports of brake vacuum pump failure in its response to ODI's information request letter for RQ-002 (MY 2012 - 8, MY 2014 - 1). In addition, MMNA's response indicated that there are no MY 2010 through 2011 i-MiEV vehicles currently in the United States (a small number of MY 2010 through 2011 pre-production i-MiEV demo vehicles were listed as scrapped or exported - four of these were included in the scope of 14V-522).On November 8, 2019, MMNA submitted a Defect Information Report (DIR) to NHTSA describing a defect in the brake vacuum pump in approximately 2,108 MY 2012 through 2017 Mitsubishi i-MiEV vehicles manufactured from October 28, 2011 through June 10, 2016 (NHTSA Recall 19V-804, Mitsubishi Recall SR-19-002). Mitsubishi's DIR identified a defect in the brake vacuum pump design that may allow water to penetrate the pump and cause internal corrosion, which may result in brake vacuum pump failure and increased risk of a vehicle crash. Recalled vehicles will have the vacuum pump replaced with a redesigned pump that has improved sealing and anti-corrosion performance.Mitsubishi's DIR indicates that the recall covers all i-MiEV vehicles sold in the United States, as U.S. sales began with MY 2012 and concluded with MY 2017.This investigation is closed based on Recall 19V-804. The ODI reports cited above can be reviewed at NHTSA.gov under the following ID numbers:11078966, 11171175, 11187483.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations
Data on this page last refreshed .