RoadVitals

2010 New Flyer D40LFR Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Aug 22, 2011
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

11V431000

ENGINE AND ENGINE COOLING

Aug 22, 2011
78 units potentially affected
The defect: NEW FLYER IS RECALLING CERTAIN MODEL YEAR 2010 HEAVY DUTY TRANSIT BUSES, MODELS D35LFR, D40LFR, D60LFR, DE40LFR, DE60LFR, XD35, XDE35, AND XDE40, MANUFACTURED FROM SEPTEMBER 30, 2010, THROUGH JUNE 3, 2011, EQUIPPED WITH A CUMMINS ISB, ISL, ISC, or ISX DIESEL ENGINE. THE V-BAND CLAMP ASSEMBLY, PART NUMBERS Q187684, Q187685, AND Q187686, USED TO CONNECT THE INLET AND OUTLET CONE SECTIONS TO THE DIESEL OXIDATION CATALYST (DOC)/DIESEL PARTICULATE FILTER (DPF) INCLUDE A T-BOLT WHICH CAN FRACTURE AND FAIL WHEN SUBJECTED TO STRESS OR LOAD. A FRACTURE OR FAILURE OF THE T-BOLT MAY CAUSE THE CLAMP TO LOOSEN AND THE INLET OR OUTLET SECTIONS ATTACHED TO THE DOC/DPF HOUSING TO DISCONNECT.
The risk: IF THE INLET OR OUTLET SECTIONS DISCONNECT, HOT EXHAUST GASES CAN VENT PRIOR TO EXITING THE TAILPIPE, CREATING THE RISK OF COMBUSTION AND A FIRE. IF BOTH CLAMPS FAIL, THERE IS A RISK IN SOME APPLICATIONS THAT THE DOC/DPF HOUSING MAY DETACH COMPLETELY, CREATING A ROAD HAZARD.
The remedy: NEW FLYER IS WORKING WITH CUMMINS TO IDENTIFY AND NOTIFY OWNERS OF THE RECALL CAMPAIGN. REPAIRS WILL BE PERFORMED BY AUTHORIZED CUMMINS DEALERS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON SEPTEMBER 1, 2011. OWNERS MAY CONTACT CUMMINS AT 1-812-377-5000 OR NEW FLYER CUSTOMER SERVICES AT 1-204-934-4876.
NEW FLYER INDUSTRIES LTDManufacturer number R11-019View on NHTSA.gov
11V237000

LATCHES/LOCKS/LINKAGES:DOORS:LATCH

Apr 14, 2011
1,123 units potentially affected
The defect: NEW FLYER IS RECALLING CERTAIN MODEL YEAR 2007-2011 LOW FLOOR TRANSIT BUSES PRODUCED FROM MAY 24, 2007, THROUGH MARCH 1, 2011 AND EQUIPPED WITH TEETER LEVER ASSEMBLIES. THERE IS INSUFFICIENT ENGAGEMENT BETWEEN THE TEETER LEVER BASE AND THE CAM PLATE.
The risk: FAILURE OF THE TEETER LEVER ASSEMBLY WILL CAUSE THE REAR SIDE EXIT DOOR TO OPERATE IMPROPERLY. A PASSENGER LEANING ON OR FORCED AGAINST THE DOOR COULD FALL THROUGH THE DOOR AND SUSTAIN INJURIES.
The remedy: NEW FLYER IS WORKING WITH THE MANUFACTURER OF THE TEETER LEVER ASSEMBLIES, VAPOR BUS, TO REPAIR THE AFFECTED BUSES FREE OF CHARGE. PLEASE SEE VAPOR BUS DEFECT REPORT 11E-010. THE SAFETY RECALL BEGAN ON APRIL 29, 2011. OWNERS MAY CONTACT VAPOR BUS AT 1-847-777-6450 OR NEW FLYER CUSTOMER SERVICES AT 1-204-934-4874.
NEW FLYER OF AMERICA, INC.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources