RoadVitals

1985 Oldsmobile Cutlass Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Newest Jun 16, 1989
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
6 investigations on file

Recall campaigns

3 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

89V102000

VEHICLE SPEED CONTROL

Jun 16, 1989
1,755,897 units potentially affected
The defect: A SMALL NYLON BUSHING IN THE CRUISE CONTROL SERVO BAIL MAY SLIP OUT OF PLACE, CAUSING INTERMITTENT AND UNEXPECTED INCREASES IN ENGINE SPEED OR DIESELING (ENGINE RUN ON WITH IGNITION OFF).
The risk: SERVO ROD ASSEMBLY COULD CATCH ON ENGINE COMPONENTS ANDRESULT IN A STUCK THROTTLE WITH POTENTIAL FOR A VEHICLE CRASH.
The remedy: INSTALL A NEW BUSHING IN CRUISE CONTROL SERVO BAIL.
GENERAL MOTORS CORP.View on NHTSA.gov
84V154000

SEAT BELTS:FRONT:RETRACTOR

Nov 27, 1984
19 units potentially affected
The defect: THE VEHICLES WERE ASSEMBLED WITH FRONT SEAT BELT RETRACTORS WHICH MAY NOT PERFORM ADEQUATELY DURING A COLLISION.
The remedy: THE DEALER WILL REPLACE THE LEFT AND RIGHT FRONT SEAT BELT RETRACTORS FREE OF CHARGE.
GENERAL MOTORS CORP.View on NHTSA.gov
84V124000

STEERING:LINKAGES:TIE ROD ASSEMBLY

Oct 10, 1984
10,359 units potentially affected
The defect: THE TIE RODS ARE PART OF THE STEERING LINKAGE AND TRANSMIT TURNING MOVEMENTS TO THE WHEELS. THE BOLTS THAT FASTEN THE TIE RODS TO THEIR ADJUSTERS MAY NOT BE TIGHT ENOUGH. THIS COULD ALLOW THE TIE ROD TO LOOSEN AND DETACH ITSELF FROM THE ADJUSTER.
The remedy: THE TIE ROD END BOLTS WILL BE TIGHTENED WITHOUT COST TO THE OWNER.
GENERAL MOTORS CORP.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

PE89145ClosedPreliminary Evaluation

PARKING BRAKE CABLE

Opened Jul 21, 1989
Closed Sep 22, 1989

===

PARKING BRAKE
PE89104ClosedPreliminary Evaluation

JAMMED STEERING MECHANISM

Opened Mar 17, 1989
Closed May 12, 1989

SUMMARY: THE OIL FILL TUBE MAY BECOME LOOSE, CAUSING IT TO FALL ANDPOSSIBLY BECOME LODGED NEAR THE STEERING GEAR.THIS MAY CAUSE THESTEERING MECHANISM TO BECOME JAMMED, RESULTING IN A LOSS OF VEHICLECONTROL.===

STEERING
C89001ClosedInvestigation

THROTTLE NON-RETURN

Opened Mar 6, 1989
Closed Jan 16, 1990

There is no summary currently available

VEHICLE SPEED CONTROL:LINKAGES
EA88023ClosedEngineering Analysis

THROTTLE LINKAGE STICKING

Opened Feb 2, 1988
Closed Mar 6, 1989

===

VEHICLE SPEED CONTROL:LINKAGES
DP87021ClosedDefect Petition

CUTLASS SUPREME BRAKE LOCKUP

Opened Jul 1, 1987
Closed Jul 17, 1987

CUTLASS SUPREME BRAKE LOCKUP

SERVICE BRAKES, HYDRAULIC
EA86025ClosedEngineering Analysis

WINDSHIELD WIPERS

Opened Aug 25, 1986
Closed Mar 2, 1988

SUMMARY:GM BELIEVES THE PROBLEM HAS BEEN CORRECTED THROUGH ITS PUBLI-CATION OF 7 SERVICE BULLETINS CONCERNING THIS MATTER. IN ADDITION, GMDOES NOT BELIEVE WINDSHIELD WIPER FAILURE REPRESENTS A SAFETY HAZARD.ANALYSIS: THREE FAILURE MODES HAVE BEEN IDENTIFIED; INSULATING FILM MAYBUILD UP BETWEEN THE BRUSH FACE AND THE COMMUTATOR OF THE WIPER MOTOR,CORROSION MAY FORM IN THE WIPER MOTOR BRUSH AND DISENGAGEMENT OF THEWIPER ARMS MAY OCCUR. IN VIEW OF THE EXISTING LEGAL PRECEDENT, THE LARGENUMBER OF WARRANTY CLAIMS CONCERNING WIPER MOTOR FAILURES (114,000) ANDTHE HIGH WIPER MOTOR AND MOTOR KIT PART SALES (251,000), IT IS IMPERATIVETHAT THIS MATTER RECEIVE MANAGEMENT SUPPORT.STATUS: GM RESPONSE DATED 2/23/87. ANALYZING AS TIME PERMITS.EA CLOSED 3/2/88.=== D@

VISIBILITY

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .