RoadVitals

1991 Oldsmobile Cutlass Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
8
Newest Mar 12, 2007
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
1
8 investigations on file

Recall campaigns

8 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

07E021000

FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES

Mar 12, 2007
742 units potentially affected
The defect: CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.
The risk: FUEL MAY LEAK, POSSIBLY RESULTING IN A FIRE.
The remedy: DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.
DELPHIView on NHTSA.gov
06E043000

FUEL SYSTEM, GASOLINE

May 19, 2006
88,303 units potentially affected
The defect: CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
The risk: THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
The remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
HONEYWELL INTERNATIONAL, INC.View on NHTSA.gov
00V189000

STRUCTURE

Jul 11, 2000
713,435 units potentially affected
The defect: VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA, WHERE ROAD SALT USE IS HEAVY. A CONDITION WHERE ONE OR BOTH FRONT ENGINE CRADLE BOLTS CAN PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINERS.
The risk: IF BOTH BOLTS PULL THROUGH, THE FRONT OF THE CRADLE WOULD NO LONGER BE SUPPORTED AT THE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT COULD SEPARATE FROM THE STEERING GEAR.
The remedy: DEALERS WILL REPLACE THE FRONT AND REAR FRAME/CRADLE BOLTS AND RETAINERS.
GENERAL MOTORS CORP.Manufacturer number 00061/00065View on NHTSA.gov
97V058000

STRUCTURE

Apr 8, 1997
676,535 units potentially affected
The defect: VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.
The risk: IF THIS WERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, A VEHICLE CRASH COULD RESULT.
The remedy: DEALERS WILL REPLACE THE REAR CRADLE BOLTS AND RETAINERS.
GENERAL MOTORS CORP.Manufacturer number 97016View on NHTSA.gov
95V173000

SEAT BELTS:FRONT:ANCHORAGE

Sep 15, 1995
2,216,325 units potentially affected
The defect: THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."
The risk: CONSEQUENCE OF NON-COMPLIANCE: IN A COLLISON, STRESS CAN CAUSE THE ATTACHMENT METAL TO TEAR AND ALLOW THE ANCHORAGE TO SEPARATE FROM THE BODY OF THE VEHICLE. THE SAFETY BELT MAY NOT PROTECT AN OCCUPANT IN THE EVENT OF A VEHICLE CRASH.
The remedy: DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.
GENERAL MOTORS CORP.View on NHTSA.gov
92V124000

SEATS:FRONT ASSEMBLY:RECLINER

Sep 1, 1992
319,181 units potentially affected
The defect: THE POWER SEAT OR RECLINER WIRING HARNESS CAN BE PINCHED OR CAN CHAFE ON THE SEAT FRAME OR SPRING SUPPORT ROD, WEARING THROUGH THE WIRE INSULATION AND CAUSING AN ELECTRICAL SHORT.
The risk: THE HIGH CURRENT CAUSED BY THE ELECTRICAL SHORT WELDS THECIRCUIT BREAKER ELEMENTS TOGETHER IN THE CLOSED POSITION, LEAVING THE CIRCUITUNPROTECTED AND GENERATING SUFFICIENT HEAT TO BURN THE WIRE INSULATION ANDIGNITE THE SEAT CUSHION MATERIAL.
The remedy: REPAIR ANY ABRADED WIRING AND REROUTE THE WIRING HARNESS USING A WIRING HARNESS CLIP.
GENERAL MOTORS CORP.View on NHTSA.gov
92V043000

VISIBILITY:POWER WINDOW DEVICES AND CONTROLS

Apr 1, 1992
37,030 units potentially affected
The defect: MOISTURE CAN ENTER THE EXPRESS-DOWN ELECTRONIC CONTROL MODULE AND CAUSE A SHORT CIRCUIT THAT CAUSES WINDOW OPERATION WITHOUT OPERATOR CONTROL, AND LEAVES THE WINDOW IN THE DOWN POSITION.
The risk: THE ELECTRONIC CONTROL MODULE WILL FAIL FROM OVERHEATINGAND COULD RESULT IN A FIRE HAZARD INSIDE THE DOOR PANEL.
The remedy: REPLACE THE WINDOW EXPRESS-DOWN ELECTRONIC CONTROL MODULE.
GENERAL MOTORS CORP.View on NHTSA.gov
92V003000

SEAT BELTS

Jan 10, 1992
347,866 units potentially affected
The defect: THE FRONT DOOR SHOULDER BELT GUIDE LOOPS MAY BE CRACKED AND ARE NOT IN COMPLIANCE WITH FMVSS 208.
The risk: THE SEAT OCCUPANT FACES INCREASED RISK OF INJURY IN THEEVENT OF A SUDDEN STOP OR ACCIDENT.
The remedy: INSTALL REINFORCING PLATES ON THE CRACKED SHOULDER BELT GUIDES.
GENERAL MOTORS CORP.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

RQ97017OpenRecall Query

CRADLE BOLT FAILURES

Opened Oct 2, 1997

There is no summary currently available

STRUCTURELed to recall 97V058000
RP01001ClosedRecall Process

STRUCTURE

Opened Nov 28, 2001
Closed Jun 13, 2002

There is no summary currently available

STRUCTURELed to recall 00V189000
EA00011ClosedEngineering Analysis

ENGINE CRADLE SEPARATION

Opened Apr 10, 2000
Closed Jan 12, 2001

THE ENGINE CRADLE FRONT BOLTS AND/OR RETAINERS MAY FAIL, ALLOWING THE FRONT OF THE ENGINE CRADLE TO FALL, POSSIBLY SEPARATING THE STEERING INTERMEDIATE SHAFT FROM THE STEERING GEAR, WITH COMPLETE LOSS OF STEERING CONTROL

ENGINE AND ENGINE COOLINGLed to recall 00V189000
PE94063ClosedPreliminary Evaluation

CORRODED REAR DISK BRAKES

Opened Aug 12, 1994
Closed Dec 21, 1994

There is no summary currently available

SERVICE BRAKES, HYDRAULIC
PE94048ClosedPreliminary Evaluation

SUB-FRAME ABSORBER FAILURE

Opened Jun 21, 1994
Closed Dec 30, 1994

There is no summary currently available

ENGINE AND ENGINE COOLING
EA92024ClosedEngineering Analysis

STICKING THROTTLE

Opened Jun 26, 1992
Closed Jan 31, 1994

There is no summary currently available

VEHICLE SPEED CONTROL:LINKAGES

Showing 6 of 8 inquiries on file for this model year, open ones first. Every one of them is listed on NHTSA.gov.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .