RoadVitals

2013 Peterbilt 320 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
5
Newest Jun 14, 2019
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

5 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

19V452000

EXTERIOR LIGHTING:TAIL LIGHTS; EXTERIOR LIGHTING:TURN SIGNAL

Jun 14, 2019
343 units potentially affected
The defect: PACCAR Incorporated (PACCAR) is recalling certain 1990-2020 Peterbilt 320 and 520 vehicles built with specific amber rear turn signals. The turn signals may also light up with the stop/tail lights when the brakes are applied. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
The risk: Rear Turn signals that illuminate at the same time as the brake lights may create confusion and impair the effectiveness of the brake lights, increasing the risk of a crash.
The remedy: PACCAR will notify owners, and for trucks with rear amber lights, dealers will add a jumper harness between the chassis electrical harness and amber tail lights, free of charge. The recall began August 1, 2019. Owners may contact PACCAR customer service at 1-940-591-4220. PACCAR's number for this recall is 19PBC.
PACCAR IncorporatedManufacturer number 19PBCView on NHTSA.gov
15V309000

ENGINE AND ENGINE COOLING:ENGINE

May 26, 2015
4,823 units potentially affected
The defect: PACCAR Incorporated (PACCAR) is recalling certain model year 2010-2016 Kenworth T440, T800, and W900 trucks manufactured August 31, 2009, to April 20, 2015, and 2008-2015 Peterbilt 320, 337, 348, 365, 382, and 384 trucks manufactured July 27, 2007, to April 28, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.
The risk: If engine oil comes into contact with a hot surface, there is an increased risk of a fire.
The remedy: Cummins will notify owners on behalf of PACCAR, and Cummins service centers will administer the repairs which include securing the ends of the 90-degree elbow and reprogramming the electronic control module (ECM) with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Kenworth customer service at 1-425-828-5000, Peterbilt customer service at 1-940-591-4000 or Cummins Inc. at 1-800-343-7357. PACCAR's number for this recall is 15KWH and 515-G.
PACCAR IncorporatedManufacturer number 15KWH and 515-GView on NHTSA.gov
15V108000

STEERING:LINKAGES:TIE ROD ASSEMBLY

Feb 24, 2015
5,141 units potentially affected
The defect: PACCAR Incorporated (PACCAR) is recalling certain model year 2009-2015 Peterbilt 320, 365, 367, 388, and 389 trucks manufactured July 21, 2008, to February 28, 2014. The front axle tie rod end clamp bolts may be improperly torqued.
The risk: Undertorqued tie rod end clamp bolts are susceptible to corrosion, which may cause loose bolts to separate resulting in a loss of vehicle control and an increased risk of a crash.
The remedy: PACCAR will notify owners, and dealers will replace the front axle tie rod assembly on any vehicle where the factory installed assembly has not been previously replaced, free of charge. Owners were mailed interim notices on May 11, 2015. The recall began on April 4, 2016. Owners may contact Peterbilt customer service at 1-940-591-4220. PACCAR's number for this recall is 215-C.
PACCAR IncorporatedManufacturer number 215-CView on NHTSA.gov
14V439000

ELECTRICAL SYSTEM

Jul 21, 2014
1,966 units potentially affected
The defect: PACCAR Inc. (PACCAR) is recalling certain model year 2013-2015 Kenworth K300 and Peterbilt 210, 220, and 320 chassis manufactured March 14, 2012 to July 14, 2014. The affected vehicles may have loose fitting electrical connectors on the power distribution module which may cause the engine to shut off.
The risk: An unexpected engine shut down increases the risk of a crash.
The remedy: PACCAR will notify owners, and dealers will install nylon tie straps to hold the connectors in place until the permanent remedy, a connection position device, becomes available. Both remedies will be provided free of charge. The recall began January 29, 2015. For more information, Peterbilt owners may call 1-940-591-4220 and Kenworth owners may call 1-425-828-5000. PACCAR's number for this recall is 14KWH (Kenworth), and 714-G (Peterbilt).
PACCAR IncorporatedManufacturer number 14KWH,714-GView on NHTSA.gov
12V026000

SERVICE BRAKES, AIR:SUPPLY:CHECK VALVE

Jan 30, 2012
15,932 units potentially affected
The defect: PACCAR IS RECALLING CERTAIN MODEL YEAR 2012-2013 KENWORTH T170, T270, T370, T440, T470, T660, T700, T800, W900, AND PETERBILT 320, 330, 337, 348, 365, 367, 382, 384, 386, 388, 389, AND 587 VEHICLES, MANUFACTURED FROM JANUARY 31, 2011, THROUGH JANUARY 19, 2012, AND EQUIPPED WITH BENDIX ATR-6 ANTILOCK TRACTION RELAY VALVES. IN EXTREMELY COLD CONDITIONS, THESE BENDIX RELAY VALVES MAY POTENTIALLY DEVELOP INTERNAL LEAKAGE. INTERNAL LEAKAGE CAN LEAD TO AIR PRESSURE BEING DELIVERED TO AFFECTED PRIMARY OR SECONDARY BRAKE CAUSING CONTINUOUS BRAKE APPLICATION.
The risk: UNEXPECTED CONTINUOUS BRAKE APPLICATION CAN CAUSE THE BRAKES TO OVERHEAT AND LEAD TO A FIRE. UNEXPECTED CONTINUOUS BRAKE APPLICATION CAN CAUSE THE DRIVER TO LOSE CONTROL OF THE VEHICLE, INCREASING THE RISK OF A CRASH. ALSO, THE BRAKES MAY BE APPLIED WITHOUT ILLUMINATING THE BRAKE LIGHTS, FAILING TO GIVE PROPER WARNING TO OTHER DRIVERS.
The remedy: PACCAR WILL NOTIFY OWNERS, AND PROVIDE A TEMPORARY REPAIR UNTIL BENDIX DEVELOPS A PERMANENT REMEDY. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON FEBRUARY 10, 2012. OWNER MAY CONTACT KENWORTH AT 1-425-828-5440 AND PETERBILT AT 1-940-591-4196.
PACCAR INCORPORATEDManufacturer number 12KWA/0112-AView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources