2018 Peterbilt 367

The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE21-015) based on one Vehicle Owner Questionnaire (VOQ) and supporting fleet reports. The reports indicated that the subject quarter fenders were prone to cracking and/or separation.After a comprehensive review of the data related to the quarter fender failures on the subject vehicles, ODI did not identify the existence of a safety-related defect trend. Quarter fender failures resulted in a warranty claim rate less than one percent (<1%) of the total vehicle population. All separations, including those due to tread separations, road hazards, etc., accounted for less than point one percent (<0.1%) of the total vehicle population.ODI discovered that the minimum recommended gap between the top of the quarter fender and the bottom of the trailer was not known or being followed. The optional quarter fenders were supplied by Fontaine Spray Systems (FSS), who recommended a two inch (2) gap. ODI analyzed the claim data using a calculated gap. A calculated gap using the top of the quarter fender flap and assuming the trailer is level with the top of the fifth wheel hitch was necessary, as PACCAR doesn't know specifically what trailer a purchaser will couple to the tractor. It is safe to assume no trailers on the market extend below the upper fifth wheel plate, but many do provide additional clearance over the wheels where the quarter fenders are located. ODI determined that 94 percent of warranty claims and 84 percent of separations violated FSS' recommendation.ODI confirmed that the VOQ vehicle and the fleet report vehicles also violated FSS' recommended gap. In one fleet the gap was negative point three inches (-0.3).PACCAR has updated its vehicle specification process and issued a customer advisory notice to existing owners. In light of the low rate of reported failures and separations, further use of agency resources does not appear to be warranted. The closing of this investigation does not constitute a finding by NHTSA that no safety-related defect exists. The agency reserves the right to take further action if warranted by the circumstances.

105 chassis have been removed from the chassis list and unflagged in PRWS due to expiration of applicable warranty coverage. Total chassis population is 732.

The Condition, Chassis Affected, Service Action, Warranty, and Procedure sections have been updated to include the latest prognostics bulletin verbiage.

The attached procedures document has been updated with more detail and explanations. This is not a stand-alone procedure. Cummins Quickserve troubleshooting will specify the use of these procedures while troubleshooting specific fault codes.

Procedure pictures updated for clarity. When troubleshooting Cummins X15 fault codes 555 or 556, follow this additional testing, inspection, and documentation procedure to help identify the root cause of dusted engines. This is not a stand-alone process but must be used alongside Cummins troubleshooting steps. Cummins Quickserve will reference this bulletin for fault codes 555 or 556.

"Campaign New and improved software is now required for chassis equipped with an Engine Model Year 2016 PACCAR MX-13 engine to maintain DEF sensor performance and ensure compliance with emissions standards.

Info Only Unnecessary starter replacements can result from customer complaints regarding engine starting issues. A new Starter Troubleshooting Guide has been created to provide a comprehensive list of starting system checks, which should reduce unnecessary starter replacements and associated warranty claims. Engine starting system warranty claims now require a completed Starter Checklist, a Battery Pack Midtronics Report, and a Cable Drop Midtronics Report. Claims filed without these documents may be denied.