ELECTRONIC STABILITY CONTROL (ESC); SERVICE BRAKES, AIR:ANTILOCK:ABS WARNING LIGHT
2009 Peterbilt 388 Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
15 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
TIRES
EQUIPMENT:OTHER:LABELS; TIRES
STEERING:LINKAGES:TIE ROD ASSEMBLY
SERVICE BRAKES
EQUIPMENT:OTHER:LABELS
ENGINE AND ENGINE COOLING
FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY
STEERING:COLUMN
STEERING:COLUMN
ENGINE AND ENGINE COOLING:ENGINE:DIESEL
SERVICE BRAKES, AIR:DISC
PARKING BRAKE:CONVENTIONAL:AIR
TRAILER HITCHES
LATCHES/LOCKS/LINKAGES:DOORS:LATCH
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
Intermittent Loss of Power Steering Assist
On May 1, 2020, the Office of Defects Investigation (ODI) opened PE20006 to investigate complaints of intermittent loss of power steering assist in Daimler Truck North America (DTNA), Volvo Trucks of North America (Volvo) and PACCAR vehicles equipped with a ZF/TRW (TRW) THP60 steering gear. The investigation focused on 2010-2020 DTNA Freightliner Cascadia, M2 and WST; Volvo VN, VAH and VHD and PACCAR 337, 365, 389, 567, 579 model vehicles.Field reports and interviews with fleet drivers allege that high power steering fluid temperatures could result in internal seal and bearing failures causing pressure fluctuation, affecting left and right-hand turns. The inability of the driver to steer the vehicle as intended can increase the risk of a crash and injury. ODI analyzed data provided by TRW, DTNA, Volvo, and PACCAR in response to individual information request letters.ODI found that most failures occurred within the first two years and/or 50,000 miles of service. The claim rate decreased with time and miles in service and remained less than 0.5%. ODI normalized data from each of the manufacturers and determined that there was not a substantial difference in the failures.Additionally, TRW improved a seal in the steering gear in December 2015.Trucks built on or after 2016 (as 2017 and newer model years) show a decreasing trend of failures. In view of the overall low failure rate, the nature of early-life failure, and failure rate trending downward for model years 2017 and newer, this Preliminary Evaluation (PE) is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist.The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.
Driveshaft separates from tractor
SummaryOn July 13, 2010, the Office of Defects Investigations (ODI) opened an investigation on model year (MY) 2007-2009 Peterbilt tractors equipped with the (SPL170XL extended lube inter-axle driveline).ODI opened this investigation based on one Vehicle Owners Questionnaire (VOQ) and certain Peterbilt field reports.During the course of the investigation, ODI reviewed PACCAR's IR (October 22, 2010) response with associated data related to Warranty and complaint information, mined field data, interviewed customers and visited local dealers within the Washington Metropolitan area.PACCARconducted testing regarding torsional loading and identified various causative factors contributed to this safety defect finding.The Defect is a consequence of the bearing surfaces of the SPL170XL extended lube universal joint that attaches the inter-axle driveline to the drive axle becoming prematurely worn due to a breakdown of lubrication and/or excessive heat.Prematurely worn bearing surfaces may result in the u-joint becoming loose and/or binding.This condition may result in universal joint failure, allowing the inter-axle driveline to detach from the axle, which may cause the drive shaft to separate from the vehicle, increasing the risk of personal injury or property damage hazard.ODI learned that the affected population of the alleged defect extended to peer models within PACCAR.In summary, the following vehicles are being recalled: MY 2007 and 2008 Kenworth trucks, models T600, T660, T2000, T800 and W900 and MY 2007/2008 Peterbilt trucks, models357, 378, 379, 385, 386, 387, 388, and 389 allequipped with extended lube inter-axle drivelines manufactured by Dana Corporation.The recall affects vehicles manufactured between February 2, 2006 and April 30, 2007.At this time PACCAR has not yet identified a fix for the inner-axle safety defect and is currently conducting testing with the intent to provide a solution to the failure.ODI will monitor the development of PACCARS testing and ensure a timely repair for the consumer.This investigation is closed.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations