2018 Peterbilt 579 Problems
Owner-reported complaints filed with NHTSA, grouped by component
Data refreshed
What this page shows
Everything below is an owner-reported complaint submitted to NHTSA about the 2018 Peterbilt 579, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Reports by component
Ranked by how many owner reports name each component category
- Electrical433.3%
- Brakes325.0%
- Steering216.7%
- Engine18.3%
- Other / unspecified18.3%
- Suspension18.3%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Each component in detail
What the reports in each category say, in the owners' own words
Electrical
Reports naming the electrical system — wiring, battery, charging, control modules, infotainment and electrical accessories.
From owner reports, verbatim
This vehicle about 6-8 weeks ago started throwing codes for all systems above (over 100 codes). This issue affected all systems of the vehicle including but not limited to the speed and braking of the vehicle, plus the fuel system and adaptive driving systems. We took it to the dealer Performance Peterbilt in Tifton, GA. They cleared the codes and said they resolved it by replacing a NOX sensor. We left the repair shop and within 50-100 miles the exact same issue started up again. We took it back to the same shop, they worked with Paccar and determined it needed a new ECM (Computer), this was changed out and still did not resolve issue. They then changed out the main wire harness. This resolved some issues but not all issues. Now the repair dealer is stating it needs a dash wire harness. This vehicle has relatively low miles 500K and has only been serviced by Peterbilt dealers through it's life. This issue causes the vehicle to accelerate and brake randomly plus many other issues by stopping power in hauling. We have another IDENTICAL vehicle which is now doing the same thing but have not brought it into the shop yet until manufacturer can get this 1st truck fixed properly to ensure safety.
On 8/10/2024 our sleeper berth hvac fans abruptly quit working. After checking fuses we noticed the fan control switch was hot. After removing the panel that the switch is held in we noticed the HVAC Fan Control switch (Part# 599-5000) was charred, upon removing the switch from the plug we observed the actual plug is melted, and one of the wires on the wire harness has charring of the plastic insulation. This could have very well caught fire. I am going to have to replace the wiring harness as re-pining the plug will not solve the issue of the wire being burned and the insulation being charred. There was no warning lamps, occasionally the fan would turn off then resume.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Brakes
Reports naming service brakes, the antilock braking system, brake hoses, master cylinders or the parking brake.
From owner reports, verbatim
See attached document for complaint.
This vehicle about 6-8 weeks ago started throwing codes for all systems above (over 100 codes). This issue affected all systems of the vehicle including but not limited to the speed and braking of the vehicle, plus the fuel system and adaptive driving systems. We took it to the dealer Performance Peterbilt in Tifton, GA. They cleared the codes and said they resolved it by replacing a NOX sensor. We left the repair shop and within 50-100 miles the exact same issue started up again. We took it back to the same shop, they worked with Paccar and determined it needed a new ECM (Computer), this was changed out and still did not resolve issue. They then changed out the main wire harness. This resolved some issues but not all issues. Now the repair dealer is stating it needs a dash wire harness. This vehicle has relatively low miles 500K and has only been serviced by Peterbilt dealers through it's life. This issue causes the vehicle to accelerate and brake randomly plus many other issues by stopping power in hauling. We have another IDENTICAL vehicle which is now doing the same thing but have not brought it into the shop yet until manufacturer can get this 1st truck fixed properly to ensure safety.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Steering
Reports naming the steering system — racks, columns, power-steering assist and steering linkage.
From owner reports, verbatim
Front axle begins popping and making metal to metal noises when hitting bumps and or turning. We took it to the shop and they found the nuts to the U-bolts that hold the leaf springs to the front axle had begun backing off and were out of torque spec. Upon receiving the truck back the front end no longer made this noise. Approximately 8 months later we are hearing the same metal on metal and popping noises that we heard previously. We have also noticed similar year Peterbilt 579's with this same noise and popping so this isn't specific to our vehicle.
BENDIX WINGMAN COLLISION MITIGATION SYSTEM, THIS SYSTEM AS AM TRYING TO BRAKE THE VEHICLE DETERMINED THAT THE VEHICLE IN FRONT WAS CLOSER THAN IT REALLY WAS AND LOCKED THE BRAKES AND STEERING, AT SUCH TIME THE DRIVER LOOSES CONTROL OF THE VEHICLE COMPLETELY, THIS WAS THE FOURTH TIME IT DID THIS, THE THIRD TIME IT LOCKED THE BRAKES I WAS TRYING TO BRAKE WHILE A CAR WAS DRIVING OUT OF A DRIVEWAY, SECOND TIME I WAS TRYING TO PASS A CAR AND IT DETECTED THE CAR TO CLOSE AND LOCKED THE BRAKES, FIRST TIME BUMPER TO BUMPER IT WAS RAINING, ON A HIGHWAY A VEHICLE CUT IN FRONT OF ME TRIED TO APPLY THE BRAKES AND THE SYSTEM LOCKED UP THE BRAKES AND STEERING, THERE WAS PLENTY OF ROOM FOR ME TO STOP WITHOUT THIS SYSTEM HAVING TO LOCK THE BRAKES UP ON ME
Too few reports in this category for a page of its own — they appear in the full complaint list.
Engine
Reports naming the engine itself — including stalling, misfires, oil consumption, cooling and internal engine components.
From owner reports, verbatim
This vehicle about 6-8 weeks ago started throwing codes for all systems above (over 100 codes). This issue affected all systems of the vehicle including but not limited to the speed and braking of the vehicle, plus the fuel system and adaptive driving systems. We took it to the dealer Performance Peterbilt in Tifton, GA. They cleared the codes and said they resolved it by replacing a NOX sensor. We left the repair shop and within 50-100 miles the exact same issue started up again. We took it back to the same shop, they worked with Paccar and determined it needed a new ECM (Computer), this was changed out and still did not resolve issue. They then changed out the main wire harness. This resolved some issues but not all issues. Now the repair dealer is stating it needs a dash wire harness. This vehicle has relatively low miles 500K and has only been serviced by Peterbilt dealers through it's life. This issue causes the vehicle to accelerate and brake randomly plus many other issues by stopping power in hauling. We have another IDENTICAL vehicle which is now doing the same thing but have not brought it into the shop yet until manufacturer can get this 1st truck fixed properly to ensure safety.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Other / unspecified
Reports whose component NHTSA recorded as unknown, or that do not map to one of the categories above.
From owner reports, verbatim
See attached document for complaint.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Suspension
Reports naming suspension components — springs, struts, shocks, control arms and related hardware.
From owner reports, verbatim
Front axle begins popping and making metal to metal noises when hitting bumps and or turning. We took it to the shop and they found the nuts to the U-bolts that hold the leaf springs to the front axle had begun backing off and were out of torque spec. Upon receiving the truck back the front end no longer made this noise. Approximately 8 months later we are hearing the same metal on metal and popping noises that we heard previously. We have also noticed similar year Peterbilt 579's with this same noise and popping so this isn't specific to our vehicle.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — owner-reported complaints and the components recorded on them
Data on this page last refreshed .