RoadVitals

2001 Pierce Arrow XT

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Latest May 30, 2017
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2001 Pierce Arrow XT. 3 safety recalls have been issued covering this model year; and 19 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

3 campaigns cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
17V348000

POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT

May 30, 2017
225 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain 1999-2013 Arrow XT, Dash, Enforcer, Quantum and Velocity fire trucks equipped with the electric All-steer rear steering option. The affected vehicles have rear steer axle shafts that were not properly heat treated.
The risk: Axle shafts that are not properly heat treated may break and potentially disable the vehicle, increasing the risk of a crash.
The remedy: Pierce will notify owners, and dealers will replace the rear steer axle shafts, free of charge. An interim notice was mailed on July 24, 2017. The recall began June 3, 2020. Owners may contact Pierce customer service at 1-888-974-3723.
Pierce ManufacturingManufacturer number 74B283View on NHTSA.gov
13V525000

EQUIPMENT

Oct 22, 2013
3,115 units potentially affected
The defect: Pierce Manufacturing Inc. (Pierce) is recalling certain model year 2000-2009 Enforcer and model year 2000-2010 Dash, Lance, and Arrow XT vehicles. While raising or lowering the cab as part of vehicle maintenance, the mounts on which the cab tilt cylinders pivot may fatigue and fail allowing the cab to fall until the safety catch activates.
The risk: If a person is in the path of the moving cab when a mount fails, the person may be hit by the falling cab, increasing the risk of injury.
The remedy: Pierce will notify owners, and dealers will affix new safety signs advising the operator to stay clear of the cab while it is being tilted, free of charge. The recall began on January 6, 2014. Owners may contact Pierce at 1-920-832-3000. Pierce's recall number is 74B240.
Pierce ManufacturingManufacturer number 74B240View on NHTSA.gov
10V423000

STEERING

Sep 21, 2010
2,652 units potentially affected
The defect: PIERCE IS RECALLING CERTAIN MODEL YEAR 1998 THROUGH 2008 ARROW XT, LANCE, VELOCITY, ENFORCER, IMPEL, AND DASH CUSTOM FIRE APPARATUS VEHICLES MANUFACTURED FROM MAY 30, 1998 THROUGH NOVEMBER 25, 2008. THE STEERING GEAR BRACKET MAY FRACTURE AND BREAK. IF THIS OCCURS THE STEERING GEAR MAY DETACH FROM THE VEHICLE.
The risk: DETACHMENT OF THE STEERING GEAR WILL RESULT IN A LOSS OF STEERING CONTROL THAT COULD CAUSE A CRASH.
The remedy: PIERCE WILL NOTIFY OWNERS AND DEALERS WILL INSTALL A NEW STEERING GEAR MOUNTING BRACKET FREE OF CHARGE. THE SAFETY RECALL BEGAN ON OCTOBER 12, 2010. OWNERS ARE BEING INSTRUCTED TO INSPECT THE STEERING GEAR BRACKET PRIOR TO EACH TRIP. THE REMEDY TO REPAIR THIS DEFECT IS EXPECTED TO BEGIN NO EARLIER THE JANUARY 31, 2011. OWNERS MAY CONTACT PIERCE AT 1-888-974-3723.
PIERCE MANUFACTURINGManufacturer number 74B207View on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

PB_572.4

Introduction of tri-crimp, Spiralock™ chassis/aerial hardware.

PB_750

To improve the fitment and operational reliability of manual window cranks by installing a fabricated collar over the regulator splines, eliminating looseness and reducing effort when raising or lowering the window.

SB_746

Single axle tillers can be retrofitted to have a 91° jackknife angle, an improvement from the previous jackknife angle of 88°. New tillers are configured with this change as per Sales Bulletin PSB1063.

SB_747

IMMI, the creator and supplier for Rolltek and other Supplemental Restraint System (SRS) products, is implementing design changes due to obsolescence of select parts. Most recently, the AB8 Front Impact Protection (FIP) sensors are no longer available and cannot be ordered. If you believe there is an issue with the AB8 FIP sensor, please contact customer service for technical support. We now require all active and inactive diagnostic codes be included when starting a Technical Incident for an SRS issue. Having the codes at the start of the incident ticket process will provide efficient troubleshooting and increase the accuracy of the suggested corrective actions.

SB_733

This bulletin provides a procedure by which to apply a software update to applicable Command Zone devices installed in Pierce custom chassis apparatus using a Single Packet Update (SPU) file loaded via the CZ Webpages application. This procedure is applicable to apparatus equipped with either CL-711 or CL-714 series Displays.

SB_734

This bulletin provides a procedure by which to apply a software update to applicable Command Zone devices installed in Pierce custom chassis apparatus using a Single Packet Update (SPU) file loaded onto a USB stick. This procedure is applicable only to apparatus with a CL-714 series Display, with Telematics Control Unit software version 6.0.X or greater, and with a ‘Tech Module’ port installed.

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

Pierce Arrow XT by model year
YearComplaintsRecallsInvestigationsIssue Index
2026010—
2025020—
2024010—
2023030—
2022060—
2021080—
2020090—
2019090—
2018080—
2017091—
20168141—
20150141—
2014071—
20130112—
20120112—
20110123—
20100163—
20090152—
20081163—
20070133—
2006083—
2005183—
2004072—
2003061—
2002040—
2001Viewing030—
2000030—
1999020—
1998010—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.