RoadVitals

1978 Plymouth Volare Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
5
Newest May 1, 1978
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

5 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

78V097000

SUSPENSION:FRONT:CONTROL ARM:UPPER ARM

May 1, 1978
1,100,000 units potentially affected
The defect: POSSIBLE FATIGUE FAILURE CAN OCCUR IN THE FRAME SUPPORT PLATES (FRONT SUSPENSION PIVOT BAR SUPPORT PLATE) THAT CONNECTS A PORTION OF THE FRONT SUSPENSION TO THE VEHICLE FRAME ON THE INVOLVED VEHICLES.
The remedy: THE DEALER WILL INSPECT SUPPORT PLATES FOR INDICATIONS OF FAILURE AND, IF NECESSARY, WILL REPLACE THE PLATES. ADDITIONAL SUPPORT BRACKETS WILL ALSO BE INSTALLED TO REINFORCE THE SUPPORT PLATE AT THE PIVOT BAR ATTACHMENTS.
CHRYSLER CORPORATIONView on NHTSA.gov
77V240000

LATCHES/LOCKS/LINKAGES:HOOD:LATCH

Dec 28, 1977
1,207,458 units potentially affected
The defect: ON THE INVOLVED VEHICLES, THE HOOD SECONDARY CATCH SYSTEM MAY BE MISALIGNED WHICH MAY CAUSE THE SECONDARY CATCH TO MALFUNCTION. CONSEQUENTLY, THE HOOD MAY NOT BE SECURELY LATCHED.
The remedy: DEALER WILL ADJUST THE CATCH SYSTEM TO FULLY SECURE THE HOOD, WITHOUT CHARGE.
CHRYSLER CORPORATIONView on NHTSA.gov
77V211000

STEERING: STEERING WHEEL/HANDLE BAR

Nov 28, 1977
22,000 units potentially affected
The defect: THE COLUMNS MAY CONTAIN STEERING SHAFTS IN WHICH THE STEERING COLUMN COUPLING ROLL PIN RETAINING NOTCH WAS MACHINED TOO DEEP. THIS MAY CAUSE THE STEERING WHEEL SHAFT TO BECOME DISENGAGED FROM THE REST OF THE STEERING ASSEMBLY.
The remedy: DEALER WILL INSTALL A COTTER PIN THROUGH THE ROLL PIN TO ENSURE RETENTION, AT NO COST TO OWNER.
CHRYSLER CORPORATIONView on NHTSA.gov
77V188000

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS

Oct 25, 1977
1,225,000 units potentially affected
The defect: ON THE INVOLVED VEHICLES, DAMAGE TO THE FRONT WHEEL BRAKE HYDRAULIC SYSTEM COULD OCCUR DUE TO FRONT WHEEL BRAKE LINE TUBE CORROSION. FRONT WHEEL BRAKE HOSES MAY BECOME BRITTLE AND CRACK DUE TO PROLONGED OPERATION IN COLD TEMPERATURES.
The remedy: THE DEALER WILL REPLACE BOTH FRONT HOSES IF FOUND NECESSARY AND IN ADDITION, WILL INSTALL A PLASTIC SHIELD BETWEEN THE BATTERY THERMO-GUARD AND THE TUBES TO PREVENT CORROSION.
CHRYSLER CORPORATIONView on NHTSA.gov
77V179000

FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS

Oct 14, 1977
241 units potentially affected
The defect: THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH A FUEL SUPPLY TUBE, ROUTED IN SUCH A WAY THAT IT INTERFERES WITH THE FRAME CROSSMEMBER BRACKET. THIS TUBE IS LOCATED BETWEEN THE FUEL PUMP AND THE FUEL FILTER.
The remedy: THE DEALER WILL INSPECT THE INVOLVED VEHICLES TO ENSURE ADEQUATE FUEL TUBE AND FRAME CROSSMEMBER BRACKET CLEARANCE. THE DEALER WILL ALSO MAKE SURE THAT THE TUBE IS SECURELY CLIPPED TO MAINTAIN CLEARANCE TO THE BRACKET AS WELL AS OTHER ENGINE COMPONENTS. IF THE FUEL SUPPLY TUBE IS FOUND TO BE DAMAGED FROM THIS CONTACT WITH THE CROSSMEMBER BRACKET, IT WILL BE REPLACED AT NO CHARGE.
CHRYSLER CORPORATIONView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources