RoadVitals

2001 Terex HR40 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Aug 8, 2011
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

11V418000

EQUIPMENT

Aug 8, 2011
109 units potentially affected
The defect: TEREX IS RECALLING CERTAIN MODEL YEAR 2000 AND 2001 HR37M AND HR40M UTILITY TRUCKS MANUFACTURED FROM NOVEMBER 2000 THROUGH DECEMBER 2001. THE AERIAL DEVICES INSTALLED ON THESE TRUCKS MAY CONTAIN A LOWER BOOM LIFT CYLINDER WITH DEFECTIVE COMPONENTS. THE MATERIAL USED TO PRODUCE THE CYLINDER ROD ENDS WAS NOT TO SPECIFICATIONS.
The risk: THE CYLINDER ROD ENDS MAY CRACK CAUSING THE CYLINDER TO DISCONNECT WHILE IN USE. PERSONAL INJURY OR DEATH CAN OCCUR TO THE USER OR TO PERSONS AROUND THE VEHICLE.
The remedy: TEREX WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT THE CYLINDER ROD ENDS FOR CRACKS. DEALERS WILL ALSO TEST THE CYLINDER MATERIAL FOR HARDNESS. THE SAFETY RECALL BEGAN ON AUGUST 30, 2011. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-884-3892 OR EMAIL TO [email protected].
TEREX TELELECT, INC.Manufacturer number SN579View on NHTSA.gov
09V168000

EQUIPMENT

May 19, 2009
192 units potentially affected
The defect: TEREX TELELECT, INC. IS RECALLING 192 MY 1999 THROUGH 2001 HR37 AND HR40 UTILITY TRUCKS MANUFACTURED FROM JUNE 21, 1999 THROUGH JANUARY 30, 2001, WHICH UTILIZE HYDRAULIC CYLINDER 437250D TO LIFT THE LOWER BOOM ASSEMBLY. THESE UNITS WERE BUILT WITH ROD EYE MATERIAL THAT WAS NOT TO SPECIFICATION IN THE LIFT CYLINDER.
The risk: THE ROD EYE MATERIAL MAY FAIL AND ALLOW THE BOOM AND PLATFORM TO FALL, POSSIBLY RESULTING IN SERIOUS INJURY OR DEATH TO THE OPERATOR OR PERSONS NEAR THE VEHICLE.
The remedy: TEREX WILL NOTIFY OWNERS AND REPLACE THE LOWER BOOM LIFT CYLINDER FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 29, 2009. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-884-3892.
TEREX TELELECT, INC.Manufacturer number CB586View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources