2012 Toyota Prius V

The Office of Defects Investigation (ODI) has received a petition dated September 19, 2023 from the owner of a 2012 Toyota Prius V requesting that ODI reevaluate its decision to deny DP19-004. In the letter, the petitioner reported experiencing an unexpected and complete loss of brake power while driving, accompanied by multiple dashboard warning lights. This petition is based on the petitioner's direct experience and assessment that ODI closed DP19-004 because its prompting petition was withdrawn by that petitioner. ODI will review the work conducted during DP19-004 and a review of any additional related complaints and crashes via a new defect petition The petition and related materials can be reviewed at NHTSA.gov under the following ODI number:11553736.

Brake actuator assembly failure on a vehicle with 99,818 miles. Whirring sound when braking followed by lighting of several brake alert lights on dash including PCS and ABS and others. The whirring noise has occured for several weeks, but the light indicators happened on 6/28/26. Toyota has an acknowledged Customer Support Program (20TE07) for this exact failure on this exact and Toyota declined to cover the repair. This vehicle is 14 years old but has well under 150k miles and Toyota will not honor claim though they clearly are aware of the safety hazard.

NHTSA ID

11747171

Incident

Jun 28, 2026

Driving down the highway, the engine suddenly threw a rod, causing a terrible jolt, after which the engine burst into flames. There had been no warning lights.

NHTSA ID

11747076

Incident

Jun 7, 2026

The ABS system has failed. All brake related warning lights have appeared on the dash board and the ABS no longer works. The car will brake for now, but the pedal is mushy. The issue was diagnosed by a dealer. The diagnosis from the dealer, based on diagnostic trouble codes they did not provide, is that brake fluid is leaking in the master cylinder and brake booster. The recommendation is to have both the master cylinder and booster replaced. This vehicle has 143,000 miles on it. No accidents have occurred as a result of the brakes yet but how long before the brakes ultimately fail is unknown.

NHTSA ID

11745426

Incident

Jun 2, 2026

ABS, brake, and traction control lights, all illuminated at once on the dashboard. Inspection found DTC C1391 indicating the accumulator is leaking or failing to hold pressure correctly. We are advised that the braking system performance will decline, eventually failing. An very expensive repair is required and Toyota apparently has a shortage of the parts required. We cannot drive the vehicle given the potential of braking failure and cannot get it repaired in a timely manner for lack of Toyota parts.

NHTSA ID

11743546

Incident

May 29, 2026

The contact owns a 2012 Toyota Prius V. The contact stated that while driving at an undisclosed speed, the brake master cylinder was constantly cycling. No warning lights were illuminated. The vehicle was not taken to the dealer or an independent mechanic to be diagnosed or repaired. Most recently, while the vehicle was turned off, the brake master cylinder was cycling. The contact stated that while the keys were in his hands and standing several feet away from the vehicle, the brakes started cycling. The manufacturer was notified of the failure but offered no assistance. The approximate failure mileage was 140,000.

NHTSA ID

11715101

Incident

Feb 2, 2025

Mileage

140,000 mi

The power assist braking system failed while I was driving in the rain. I was approaching a stoplight and I had to push down a lot harder and farther than I typically have to in order to stop. Luckily I was not going that fast and there were no cars ahead of me, but I stopped beyond where I had intended at a busy intersection. No warning lamps or messages had been illuminated prior to this happening. After the failure, the Brake system, ABS, and SLIP indicator lights were on and remained on when the car was restarted. An independent service center used a scan tool and found code C1391 stored in memory, indicating that the brake booster is unable to hold pressure due to an internal leak. The vehicle has not yet been inspected by the manufacturer, police or insurance, but can be available upon request.

NHTSA ID

11704509

Incident

Nov 26, 2025

I bought this car over a week ago for a good price, performed fine until I’m driving it home on the interstate and some abs/brake lights came on the dash. I enter my city and notice the brakes aren’t performing as tight as they were during the test drive. A few days later I take it to a local dealership to get it looked at. The brake actuator and pump had gone bad, causing this issue. It cost almost $5,000 to fix there, I couldn’t afford it so I had to only pay the $185 for the diagnostic. It’s an on and off thing, sometimes the lights go away and it brakes as it should, but most of the time the lights are on and the brakes don’t work as they should. I fear one day the brakes may eventually give out on me and cause an accident. I am available for inspection.

NHTSA ID

11703955

Incident

Nov 26, 2025

After 13 years and 112,000 the brake booster and brake booster pump went out on my car. Toyota extended the warranty to 10 years because of this issue. Now just outside of the 10 yr mark my car has this issue and Toyota will not cover it. This is a huge expense and also a major issue with this year and model of car.

NHTSA ID

11692218

Incident

Aug 30, 2025

OBSOLETE NOTICE February 13, 2026: This bulletin is now obsolete. Please see T-SB-0009-26.

This bulletin includes basic procedures for performing a rescue charge on Ni-MH high voltage (HV) batteries. This bulletin should be used in conjunction with the applicable model and model year Repair Manual while performing a rescue charge. The GRX-5100 should be used wherever the Repair Manual references the Toyota Hybrid System (THS) charger.

Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.

Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: •Minor damage: requires only buffing to repair. •Moderate damage: usually requires neutralizing, color sanding, and buffing. •Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.

To prevent brake rotor rust from forming during transportation and storage, wheel film will be used instead of a cardboard type of anti-rust cover. The purpose of the wheel film is to shield the disc brake rotor from weather elements and initial rust before the vehicle is delivered to the customer. Consequently, the film should remain on the wheel for as long as possible.

The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. It is the dealer’s responsibility to protect and maintain the quality of the vehicle’s paint finish after receipt at the dealership prior to the first sale. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting.