RoadVitals

2018 Vanleigh Beacon Problems

Owner-reported complaints filed with NHTSA, grouped by component

Data refreshed

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
1
Latest May 10, 2024
Components namedHow many of our component categories appear on at least one report for this model year. One report can name several.
1
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

What this page shows

Everything below is an owner-reported complaint submitted to NHTSA about the 2018 Vanleigh Beacon, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Reports by component

Ranked by how many owner reports name each component category

  • Body & structure1100.0%

Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.

Each component in detail

What the reports in each category say, in the owners' own words

Body & structure

Reports naming the vehicle structure, frame, body panels, doors, hood and trim.

1
report

From owner reports, verbatim

There are several issues with my Vanleigh RV that I believe warrant investigation and recall. The main structural element I believe common with all my problems is the under-designed frame in its entirety. I have had to have the rear portion of my frame strengthened by the frame manufacturer (Lippert) due to it going out of camber. This has caused numerous slide operation problems as well as continual floor damage inside the RV. There is also too much flex in the front portion of the frame causing continuous body damage. I applied the Vanleigh recommended fix of inserting wood slats into the aluminum channels on each side of the front end but things have gotten worse. The newly recommended fix is to remove the outer surfaces of the front of the RV and weld additional support into the aluminum frame structure. I believe these aluminum welds have broken due to the previously recommend Vanleigh fix with the wood slats. The slats stiffened the bottom aluminum but now pushed the movement further up the structure thus breaking the aluminum welds of the RV sides around the king pin section.

NHTSA ID 11588034 · filed May 10, 2024

Too few reports in this category for a page of its own — they appear in the full complaint list.

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .