ELECTRICAL SYSTEM:12V/24V/48V BATTERY; ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS
2020 Altec ST Spray Truck
Recalls, owner-reported complaints, investigations and safety data
Overview
Our database contains no NHTSA owner-reported complaints for the 2020 Altec ST Spray Truck. 1 safety recall has been issued covering this model year; and 3 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Safety recalls
1 campaign cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
No owner complaints recorded for this model year
Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
EQUIPMENT
Altec has learned that a pressure regulator bolt spacer on certain ST550/720/750 spray trucks and SK430/560 spray units built from July 2020 to February 2023 might not have been installed on the pressure regulator bolt weldment, resulting in the hoses on the tank exceeding their rated pressure on the affected units.
EQUIPMENT; WHEELS
Altec has learned that the fender rubber on certain units built from July 2020 to October 2020 can become detached from the wheel well fender cutout of the utility body. Altec recommends that all fender rubber be inspected using the inspection procedure described in the SIL. If the installed fender rubber does not pass inspection, order and install the Fender Rubber Replacement Kit. If the fender rubber passes the inspection, complete the Inspection Sheet at the end of this document. No additional inspections are required.
STRUCTURE
The receiver hitch capacity and warning placards were not installed on the affected units. Use of the hitch at loads higher than the design ratings due to the lack of these placards can overload the receiver tube, resulting in damage to the receiver tube and/or the bumper. The Receiver Hitch Placards Kit is included with the SIL. Altec requires this kit to be installed by the next preventive maintenance interval.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.