2014 BMW 428I

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

Car jyst shut down in the middle of the street without any dashbord lights, strange noises or symptoms. Won't turn over. After tow to BMW dealer they said oil pump broke. I took it to volvo dealer they said oil starvation. They changed design of oil pump drive but don't inform anybody to do it which is very unacceptable. And they should do recall on that. That was very dangerous situation. This oil pump very slowly desteoys without any symptoms. It's really ticking time bomb becouse they now it quietly change design.Thank you.

NHTSA ID

11697411

Incident

Sep 13, 2025

I have tried reaching BMW USA 3-4 times since November 2024 until now. The representative said BMW is working on correcting the problem. I have CC the email that was sent this June 2025 with no replies. 1 year has passed since the recall was issued and BMW USA has not created a remedy/fix for the coolant problem. I had this car on the TURO car rental platform as I am a host on TURO. I can't list this car to rent out because of the recall. Turo will not allow owners of recalled cars to list their cars because the car could be "potentially unsafe." Yet, the "owner" is driving these "unsafe"' cars on the road. I did my part. I already sent another recent email to get a solution. What would be my next step? (Almost one year now....) Also, I am sending this email Pacific time at 5:07 WED., July 30th. On the document: the Update IS on THURSDAY JULY 31st. WHAT???!!!!! Make it make sense . Frustrated OWNER

NHTSA ID

11677375

Incident

Jun 10, 2025

the recall was dated 12 August 2024. To date BMW North America has not provided the parts needed to effect the repair. it has been 10 months since the recall. BMW NA is dragging its feet. it is time something is done to require BMW NA to fix the problem,

NHTSA ID

11666273

Incident

Aug 12, 2024

The contact owns a 2014 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ID

11666222

Incident

Aug 13, 2024

The manufacturer has failed or is unable to remedy this safety recall for my vehicle in a timely manner. Issue: 1 open recall since Aug 13, 2024 for: ENGINE COOLANT PUMP: The electrical connector of the engine coolant pump could become damaged. Small drops of liquid from the positive crankcase ventilation (PCV) system could drip down onto the electrical connector of the pump.

NHTSA ID

11661645

Incident

Aug 13, 2024

The contact owns a 2014 BMW 428I. The contact stated that while driving approximately 65 - 70 MPH and attempting to change lanes, the vehicle lost power steering functionality. The message “Chassis Unstable” was displayed on the instrument panel. The contact used excessive force to steer the vehicle to pull over to the side of the road to inspect the vehicle. The contact was unable to find the cause of failure and continued to drive the vehicle without power steering functionality. The message of an excessive power drain for the battery was displayed. The vehicle was unable to switch to different settings, such as Sport 1, Sport 2, and Eco Pro due to the drive setting remaining stuck in Comfort Mode. The cruise control failed intermittently. While driving approximately 65 -70 MPH, the contact noticed a burning plastic odor coming from the front-end of the vehicle into the cabin. After arriving at the destination and inspecting underneath the hood of the vehicle, the contact noticed that the terminal door for the jumper cables and the housing were smoking. Additionally, there were burned areas surrounding the battery. The vehicle was taken to the dealer, who diagnosed that the electronic control module had failed and needed to be replaced. The vehicle was not repaired. The contact became aware of NHTSA Campaign Number: 16V704000 (Steering); however, the VIN was not included. The manufacturer was informed of the failure. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 80,000.

NHTSA ID

11654719

Incident

Nov 15, 2023

Mileage

80,000 mi

Car shut down and is believed to be a lemon car, and continuously leaks in spite being serviced on numerous occasions.

NHTSA ID

11651746

Incident

Dec 16, 2023

The contact owns a 2014 BMW 428I. The contact stated that the vehicle was experiencing a significant oil leak. The contact stated that upon parking the vehicle, the contact noticed that a significant amount of oil was leaking onto the ground. The vehicle was taken to Crescent Automotive, where it was purchased. The vehicle was then taken to C&C Automotive, where a synthetic oil change was performed. The vehicle was taken to an independent mechanic, where the filter, the drain plug, the drain plug gasket, and the air filter were replaced; however, the failure recurred. The vehicle was taken to a local Pep Boys, where the oil leak was evaluated, but the vehicle was not repaired. The vehicle was taken to a BMW dealer, where an unknown service was performed; however, the failure persisted. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 99,099.

NHTSA ID

11651083

Incident

Dec 22, 2023

Mileage

99,099 mi

Right Tie Rod Return

Fuel tank limited warranty for leakage, due to defects in materials or workmanship, has been extended to 15 years/150,000 miles as determined from the original in-service date

Fuel tank limited warranty for leakage, due to defects in materials or workmanship, has been extended to 15 years/150,000 miles as determined from the original in-service date

The basic conditions for initializing the power windows are not met.

The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle “discharged battery” complaints.

The paint finish on the door jamb (above the door striker) is scratched due to the inner door cavity window seal.