Reports submitted to NHTSA by owners and drivers, shown in full
Data refreshed
Our database holds 835 NHTSA owner-reported complaints for the 2016 Chevrolet Malibu. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Showing 1–25 of 835 · page 1 of 34
“Steering assist is reduced, drive with care” is showing up for a couple second and disappearing. When that happens my car seems to shut off and the steering wheel stiffens and pull to either the left of right side. All this happens while driving. After the 3rd time of it happening within 10min, my gas fuel level dropped but when back up to the “original” level
Rear steering knuckle and control arm knuckle.my car moves side to side. I have replaced everything in the rear end. I just recently bought this car.
Vacuum pump failure causing hard brake pedal which made near to impossible to brake safely and properly that lead to timing chain issues
The brake vacuum pump broke, causing my brakes to go rock hard and pieces fell down into the camshaft, causing engine damage
My car started overheating on my way home. I pulled over to find that there is a hole in my lower radiator hose, which was caused by the lower radiator hose being rubbed against the belt that is turned by the water pump. I had my wife and child bring me coolant on the side of the road where I was broken down. I eventually was able to get my car to my brothers but it required multiple stops and refilling of coolant. Once we got the car jacked up and the lower radiator hose replaced, we found the bottom of the radiator is loose and is pushing the lower radiator hose against the belt that rubbed the hole into the lower radiator hose. I then had my car towed to Dan Cummins in Georgetown Kentucky, located at 1470 Cherry Blossom Way, Georgetown, KY 40324. The mechanic drove my car that I had towed to the shop which damaged the new radiator hose that I had just put on the car. Dan Cummins of Georgetown Kentucky, who is an authorized Chevrolet Dealership, was informed (by me) that some 2016 Chevy Malibu's have been recalled because of a faulty lower radiator mount causing the lower radiator hose to push against the belt which causes the lower radiator hose to get a hole and leak. Dan Cummins suggested that I report my issue because my VIN is not covered by the recall. Authorized Chevy dealer Dan Cummins also suggested that I take my car elsewhere to be repaired while refusing to cover the damage they caused to the brand new lower radiator hose that I had purchased and put on the car. I would like for my Chevy Malibu with VIN [XXX] added to the recall so that I can have my Chevy Malibu repaired by an authorized Chevy dealership at no cost to me for something I did not do or cause. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The gear shift sometimes does read that it’s in park
I bought this car about 10 days ago. Throat was in pain, coughed up blood, dizzy, sweaty, and shaking. There's gas all over the ground coming from front under hood smelling through the vents. Very loud smelling. Took it to Chevrolet dealership on Covington hwy Decatur GA today and had to leave it there. I still don't feel good and neither the passengers in car. Car could've caught on fire gas leaking out when put in. Never experience this ever in my life. I may have to go to the hospital my chest feel very tight and I had a chronic asthmatic and my child in the car with me that's been on a breathing machine since last night and it's now 3:35 pm next day.
The vehicle is experiencing premature clear coat failure on the hood and roof. The affected areas show widespread oxidation, dulling, and breakdown of the clear coat, while vertical panels remain unaffected. This indicates failure limited to UV-exposed surfaces and does not appear to be normal wear. The condition is uniform across the panels and not caused by impact, chemicals, or improper maintenance. I have observed similar clear coat failure on other 2016 Chevrolet Malibu vehicles, suggesting a potential pattern or manufacturing defect affecting paint durability. The issue significantly impacts the vehicle’s exterior condition and resale value and continues to worsen over time. Photos are available documenting the condition.
On 04/28/2026, when diagnosing a reoccurring check engine light on the vehicle at a Chevy Certified Service, the mechanic "Borescoped cylinder 4 and found significant scuffs on the cylinder wall which along with the misfires indicate a cracked piston. The big picture appears to be the piston cracked which caused excessive oil consumption and misfires. The excess oil and unburned fuel overloaded the converter causing it to fail. The engine and converter will need to be replaced." In 2017, a recall was issued by GM to mitigate Stochastic Pre-Ignition (SPI) Causing Cracked Piston (17019). Between the initial purchase of the vehicle (11/2016) and performed service required by this recall (03/10/2017), there were approximately 5000 miles driven. No engine diagnosis was performed or recommended. After the 17019 was addressed, the engine misfires continued along with reoccurring CEL. C.S.P. N182195660 Predictive Monitoring for Stochastic Pre-ignition (SPI) released in 2019 states the 1.5 L LFV engines in certain 2016 and 2017 model year Chevrolet Malibu vehicles may have a preignition condition that requires immediate repair. This condition may cause the engine to perform poorly, misfire, run rough, and/or excessively consume oil. It may also illuminate the vehicle’s service engine light. Over time, if not repaired, the condition can damage the vehicle’s pistons and engine. The VIN for this Malibu was not attached to this notice despite it having SPI recall history. On 06/2023 (after the N182195660 program ended), at 80k miles a diagnosis revealed a potential cracked cylinder with no mention of the pre-ignition condition that could cause the crack, and the only way to fix is to replace the entire engine (as per dealer recomendation). Since vehicle was out of warranty, the repair est. was nearly $10k. I firmly believe my 2016 Malibu has suffered the consequences of poor mismanagement on this recall, and am demanding mitigation from GM to fix this issue.
The contact owns a 2016 Chevrolet Malibu. The contact stated that while driving approximately at 55 MPH in a rain storm and making a right turn, the ABS and Traction Control warning lights had illuminated, and the driver suddenly lost control of the steering and crashed into a tree. During the incident the driver sustained a concussion and neck and shoulder injuries which later required medical treatment. No police report was filed. The vehicle was later towed to the local mechanic. The cause of the failure was not determined. The manufacturer was notified of the failure, but no assistance was offered. The local dealer was not contacted. The failure mileage was 144,000.
Main seal leaking and engine needs replaced at 95,000 miles.
My car will rev up to 4000 rpm’s and my car will not go about 20 mph. My cruise stopped working after my car went into reduce engine power. The dealership said they fixed all issues but was back to doing the high rev within a week. It started this week telling me to shift to park even though my car was in park. The shift to park cable has been replaced twice now. I have been dealing with this since July of 2025. My car has been in the shop more times than I can count.
My car caught on fire under the hood. As I was driving on road I heard a sound and my car started slowing down and smoke started coming from under the hood got out the car not a minute later flames of smoke engulfed the car
Fuel Injector Backing ring Failing causing O-ring to dislodge and Rupture due to high pressure fuel leaking past the seal. This is causing a Major fire Hazard. Gm seal kits will not fix the problem do to Backer ring not being in the kit. part number for the o-ring kit is 12673056. this part should not be sold without the backer ring. if installed without the rings they will fail and will be Leaking fuel on the hot Cylinder next to the ignition coils. Misfire and bad fuel smell and possible no start or Fire!!
Have been getting reduced engine power since the summer on and off. Check engine light says its throttle bottle sensor and accelerator pedal position sensor. Which I was told there was a recall but my vin isn’t listed
I am reporting a recurring safety defect related to GM’s known “Shift to Park” issue. My vehicle displays a “Shift to Park” warning even when the vehicle is already in park, preventing the car from shutting off properly and creating a safety risk. This issue has been widely reported and associated with GM recalls and service bulletins. GM previously repaired this issue once while my vehicle was under warranty, acknowledging it as a known defect. The same defect has now reoccurred after the warranty period expired. GM is refusing to repair it again, despite the issue being recall-related and tied to a known defective design rather than wear and tear. This defect affects safe vehicle operation, risks battery drain, rollaway hazards, and driver distraction. I believe this is an unresolved safety defect that should be covered regardless of warranty status.
While driving, the vehicle experienced a mechanical failure involving the engine and lubrication system. Oil leakage was observed, and the engine began operating abnormally. This created a risk of sudden engine failure while the vehicle was in motion, which could result in loss of power, stalling, or loss of control, especially at highway speeds or in traffic. Prior to the failure, warning signs included abnormal engine behavior and fluid loss. The issue was not caused by driver error and occurred during normal operation. Continued operation in this condition presents a fire risk if oil contacts hot engine components. The problem has been inspected by a repair facility, and the failure appears to be related to a mechanical or manufacturing defect rather than wear or misuse. The component is available for inspection upon request. This defect poses a safety risk to the driver, passengers, and other motorists due to the possibility of sudden engine failure, loss of propulsion, or fire.
On December 16, 2025 the check engine light and service stabiltrek warning light appeared on my 2016 Chevy Malibu Hybrid. On December 17, 2015 I took the car the Capital Cheverolet service dept who has been servicing my car regularly for the past five years. They performed a complete diagnostics on my car that determined I need to "replace the EBCM with brake pressure modulator valve" and said it would cost over $2800.00. Upon further research I discovered that the same make model and year was recalled under recall #39440. I also learned the my VIN number was not included in this recall. This is a safety defect that has rendered my car not drivable until I get it fixed. As a senior citizen on a fixed income I am unable to fixed. I would like to know why was my car not included in the recall and if its possible to get it on the recall list so it can be fixed.
The vehicle went into shift to park and will not turn off. This is a known problem with ALL GM vehicles that hasn’t been fixed or offered a warranty for. It’s dangerous and causes the car not to move shut off in traffic and drains the battery. My car currently isn’t working due to this issue and the repair to fix is too much with no assistance from GM for a known defect. My car was almost hit because of the car had to be towed because it’s unable to be moved.
The contact owns a 2016 Chevrolet Malibu. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate. In addition, the vehicle occasionally accelerated independently. The contact stated that several unknown warning lights were illuminated, and the engine seized. The contact stated that the vehicle was jump-started daily, and the unknown warning lights turned off when the vehicle started. The vehicle was taken to the dealer; however, the failure was not duplicated. The vehicle was taken to several independent mechanics; however, the failure was not duplicated. In addition, the vehicle was taken back to the dealer where the vehicle was purchased; however, the failure was not duplicated. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 90,000.
My 2016 Malibu has a severe EBCM-related safety defect causing all four brakes to drag and overheat (reaching 240°F), leading to unstable handling. This condition mirrors the 2016 Malibu EBCM recall (GM Recall 39440). I sought help from GM. A GM-certified dealer-Monken in Centralia, IL performed a “diagnostic scan” which documented the core hydraulic failure: a constant, uncommanded 6.839 psi residual brake line pressure when the pedal was released. (A healthy system should be near 0 psi) This 6.839 psi is actively forcing the brakes to drag. The dealer ignored their own scientific data and submitted a fraudulent diagnosis of ("rust buildup") to GM, which GM used to deny the claim based on mileage. “Rust buildup” doesn’t create hydraulic pressure. GM is aware of this specific, documented, quantifiable safety defect (the 6.839 psi pressure) and is refusing to investigate it further. I stressed to GM that the vehicle wasn’t safe to drive and that I have a small child who has to ride in the car with me. GM dismissed my concerns by stating the dealership won’t release my car unless its safe to drive. I then had to drive the car 22 miles back home with all 4 brakes dragging. I requested the full diagnostic scan report (that the mechanic confirmed he could provide me with when I dropped my car off there) numerous times and never did I get one. I informed them that I would be filing a complaint hadn’t I received it by a certain time. The new kid in service then did send me screenshots of a generic OBDII scanner where I saw the 6.839 psi. I knew what the issue was prior to taking my car to Monken. I had an independent scan done prior. I only took the car there to comply with GM’s protocol to be eligible for assistance. I am requesting NHTSA investigate GM for failure to address a documented hydraulic control safety defect that causes brake dragging and overheating, which is non-compliant with safety standards. I can give further info Please call me for further details.
URGENT Complaint: NO RESPONSE to Demand for Rescission - Odometer Fraud, Deceptive Practices - Banner Ford of Monroe, LA
UNKNOWN While I'm driving my car will lose power and go into reduced engine power mode and slows me down to a crawl. I've almost been hit in the back many times for to this. The coffee is P2138
Check engine light comes on and dash says reduced engine power
Car suddenly stopped dead cold while driving on a highly driven road. No power. Several attempts were made to get off the main road and drive to a close neighborhood. Finally started and at every stop sign the car grinded during stopping and threw me backwards in driver's seat. Needed a tow. .
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .