ENGINE AND ENGINE COOLING:ENGINE
1984 Dodge Ram 50
Recalls, owner-reported complaints, investigations and safety data
Overview
Our database contains no NHTSA owner-reported complaints for the 1984 Dodge Ram 50. 1 safety recall has been issued covering this model year; 2 NHTSA investigations name it; and 1 manufacturer communication is on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Safety recalls
1 campaign cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govSafety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect.
STEERING OUTPUT SHAFT
SUMMARY OF INFORMATION FROM MANUFACTURER:BOTH CHRYSLER AND MITSUBISHIINDEPENDENTLY CONCLUDED THAT THE FAILURES WERE DUE TO SEVERE IMPACT LOADINGTRANSMITTED TO THE SHAFT BY THE STEERING LINKAGE SYSTEM -- IN OTHER WORDSSHAFT FAILURE IS THE RESULT, NOT THE CAUSE, OF THE ALLEGED COLLISIONCIRCUMSTANCES.MITSUBISHI (VEHICLE PRODUCER) DID STRENGTHEN THE SHAFTDURING THE 1984 MODEL YEAR BY INCREASING THE SPLINE AND BEARING JOURNALDIAMETERS.ANALYSIS:FAILING COMPONENT IS THE STEERING BOX CROSS SHAFT (OUTPUT SHAFT)WHICH BREAKS BETWEEN THE BOTTOM BEARING IN THE STEERING BOX AND THE PITMANARM.KNOWN FAILURES INVOLVE 4 WHEEL DRIVE UNITS WHICH ARE EQUIPPED WITHPOWER STEERING.CROSS SHAFT AND PITMAN ARM SALES ARE CONSIDERABLY HIGHERON THE 4 WD UNITS THAN THE 2 WD UNITS.CHRYSLER REPORTS THE CROSS SHAFTDIAMETER WAS INCREASED IN APRIL, 1984, FOR INCREASED SHAFT STRENGTH TOIMPROVE ITS CAPABILITY TO WITHSTAND SEVERE IMPACT LOADS.PROPOSED ACTION:IR'S TO CHRYSLER AND MITSUBISHI SENT 11/16 - 17/87.AWAITING RESPONSES.===
PITMAN ARM FAILURE
SUMMARY OF INFORMATION FROM MANUFACTURER:BOTH CHRYSLER AND MITSUBISHIINDEPENDENTLY CONCLUDED THAT THE FAILURES WERE DUE TO SEVERE IMPACT LOADINGTRANSMITTED TO THE SHAFT BY THE STEERING LINKAGE SYSTEM -- IN OTHER WORDSSHAFT FAILURE IS THE RESULT, NOT THE CAUSE, OF THE ALLEGED COLLISIONCIRCUMSTANCES.MITSUBISHI DID STRENGTHEN THE SHAFT DURING THE 1984 MODELYEAR BY INCREASING THE SPLINE AND BEARING JOURNAL DIAMETERS.ANALYSIS:FAILING COMPONENT IS THE STEERING BOX CROSS SHAFT (OUTPUT SHAFT)WHICH BREAKS BETWEEN THE BOTTOM BEARING IN THE STEERING BOX AND THE PITMANARM.KNOWN FAILURES INVOLVE 4 WHEEL DRIVE UNITS EQUIPPED WITH POWERSTEERING.CROSS SHAFT AND PITMAN ARM SALES ARE CONSIDERABLY HIGHER ON 4WHEEL DRIVE UNITS THAN 2 WHEEL DRIVE UNITS.CHRYSLER REPORTS THE CROSSSHAFT DIAMETER WAS INCREASED IN APRIL, 1984, FOR INCREASED SHAFT STRENGTHTO IMPROVE ITS CAPABILITY TO WITHSTAND SEVERE IMPACT LOADS.PROPOSED ACTION:UPGRADE THIS PE TO AN EA.CONTACT MITSUBISHI FORINFORMATION ON COMPARABLE VEHICLES.===
Recent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
No owner complaints recorded for this model year
Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
ELECTRICAL SYSTEM:WIRING; ENGINE AND ENGINE COOLING; EQUIPMENT
68069384A$, R8069384A$, 68086182A$, R8027067A$, RL002012A$ - Gasket, Cylinder Head Cover Before replacing injectors for Diagnostic Trouble Codes P0201, P0202, P0203, P0204, P0205, and/or P0206, please make sure that the wiring loom and/or connector in the valve cover gasket is not the root cause to your concern. In addition, make sure that the wiring attaching nuts are torqued to their proper value.~
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.