SEAT BELTS:FRONT:BUCKLE ASSEMBLY
1990 Dodge Ram 50
Recalls, owner-reported complaints, investigations and safety data
Data refreshed
Overview
Our database contains 4 NHTSA owner-reported complaints for the 1990 Dodge Ram 50, most frequently naming the brakes, electrical and seat belts categories. 1 safety recall has been issued covering this model year; and 1 manufacturer communication is on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Complaint activity over time
When owners filed reports about this model year
View as table
| Month | Complaints filed | Cumulative |
|---|---|---|
| Mar 1996 | 1 | 1 |
| Jul 2004 | 1 | 2 |
| Sep 2004 | 1 | 3 |
| Mar 2019 | 1 | 4 |
What owners report
Complaints grouped by the component NHTSA recorded
- Brakes240.0%
- Electrical120.0%
- Seat belts120.0%
- Suspension120.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Safety recalls
1 campaign cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
THE SEAT BELT FOR BOTH PASSANGERS, DOES NOT LOCK TO HOLD PASSANGERS IN PLACE IN CASE OF SUDDEN IMPACT.
- NHTSA ID
- 11183457
- Incident
- Feb 10, 2019
- Mileage
- 115,589 mi
DRIVER'S SIDE WHEEL LOCKED UP WHILE DRIVING 70 MPH. THIS CAUSED THE VEHICLE TO SPIN AROUND TO THE LEFT ON THE HIGHWAY. NO INJURY OR CRASH WAS REPORTED. VEHICLE WAS TOWED TO A REPAIR SHOP. VEHICLE'S FRONT WHEELS BEARING AND FRONT ROTORS NEEDED TO BE REPLACED. DEALER WAS NOT CONTACTED.*AK
- NHTSA ID
- 10094564
- Incident
- Sep 26, 2004
- Mileage
- 80,000 mi
THE ENGINE GROUND WIRE WAS INSTALLED INCORRECTLY, CAUSING THE SENSORS TO BURN OUT. THE GROUND WIRE SHOULD HAVE HAVE BEEN MOUNTED ON THE ENGINE BLOCK. INSTEAD, IT WAS MOUNTED ON THE EXHAUST MANIFOLD. *AK (PARTS AFFECTED: THROTTLE POSITION SENSOR/IDLE SPEED CONTROL MOTOR POSITION SENSOR/ENGINE COOLANT TEMPERATURE SENSER) *SC *JB
- NHTSA ID
- 10066922
- Incident
- Jul 1, 2004
- Mileage
- 62,000 mi
BRAKES; FAILURE ON THE BRAKES SYSTEM WHEN DRIVING THE BRAKES LOCK UP. *AK
- NHTSA ID
- 981059
- Incident
- Mar 18, 1996
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
ELECTRICAL SYSTEM:WIRING; ENGINE AND ENGINE COOLING; EQUIPMENT
68069384A$, R8069384A$, 68086182A$, R8027067A$, RL002012A$ - Gasket, Cylinder Head Cover Before replacing injectors for Diagnostic Trouble Codes P0201, P0202, P0203, P0204, P0205, and/or P0206, please make sure that the wiring loom and/or connector in the valve cover gasket is not the root cause to your concern. In addition, make sure that the wiring attaching nuts are torqued to their proper value.~
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.