ELECTRICAL SYSTEM:STARTER ASSEMBLY
2014 E-One Quest Ii
Recalls, owner-reported complaints, investigations and safety data
Overview
Our database contains no NHTSA owner-reported complaints for the 2014 E-One Quest Ii. 3 safety recalls have been issued covering this model year; and 6 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Safety recalls
3 campaigns cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govSUSPENSION:FRONT
ELECTRICAL SYSTEM:STARTER ASSEMBLY
Recent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
No owner complaints recorded for this model year
Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
EQUIPMENT
August 2020 TSB report for E-ONE, Inc.
EQUIPMENT
E-ONE, Inc. TSB report for the month of February 2020.
EQUIPMENT
E-ONE, Inc. TSB report for January 2020 sent 02/03/20 missing Index of Manufacturer (MFR) Communications. This communication is to add that record.
EQUIPMENT; FUEL SYSTEM, GASOLINE
E-ONE has identified that a large number of DEF tank senders that have been returned for evaluation have been diagnosed as no fault found from the manufacturer. In an effort to minimize this in the future, we are sending this bulletin along with troubleshooting steps for your technicians to use when you receive customer complaints related to DEF tank gauge level issues.
ELECTRICAL SYSTEM:WIRING
During a routine truck delivery inspection a malfunction of the air flow restriction indicator light was detected. Our investigation determined that the malfunction was introduced in 2007 with the launch of the new ISSPRO gauge cluster. The new dash gauge cluster changed the requirement for air flow sensor signal from active high to active low. This malfunction went unnoticed until now due to our published air filter routine maintenance requirements and the air filter?s longevity. Revised units affected by year.
EQUIPMENT
E-ONE WOULD LIKE TO MAKE SURE CUSTOMERS ARE AWARE OF THE PROPER AERIAL OPERATING SEQUENCE WHEN USING THEIR HP100 PLATFORMS. WHEN SETTING UP OUTRIGGERS IT IS EXPECTED THAT THE SYSTEM BE TRANSFERRED TO AERIAL MODE AFTER OUTRIGGERS ARE SET, EVEN IF YOU DO NOT INTEND ON USING THE AERIAL DEVICE RIGHT AWAY. THE AERIAL CIRCUIT HAS BETTER COOLING CAPACITY AND OPERATES AT A LOWER STANDBY PRESSURE THAN THE OUTRIGGER SYSTEM. THE OUTRIGGER SYSTEM OPERATES ON A HIGH PRESSURE STANDBY SYSTEM TO ENSURE RESPONSIVE AND TIMELY DEPLOYMENT OF OUTRIGGERS. IF THE PTO IS LEFT ENGAGED FOR EXTENDED PERIODS OF TIME, WHILE THE SYSTEM IS IN JACK MODE, IT COULD OVERHEAT. IT IS ALSO EXPECTED OF THE CUSTOMER TO DISENGAGE THE PTO WHENEVER THE SYSTEM IS NOT USED. IF THE OUTRIGGERS ARE SET, AND THE AERIAL DEVICE IS NOT NEEDED, PLEASE EITHER TURN OFF THE PTO OR ENGAGE THE AERIAL SYSTEM WITHIN 10 MINUTES.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Compare model years
Complaint and recall counts across every year of this model
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.