2017 Ford E-Series

2017-2018 F-Super Duty/F-650/F-750/E-Series/Transit chassis cab and stripped chassis vehicles have their front alignment set as part of final assembly. The addition of aftermarket equipment such as utility and box bodies will change the ride height and therefore the alignment angles. Front-end alignments performed before the addition of aftermarket equipment may not be accurate. It is the responsibility of the final-stage manufacturer to check and set alignment angles and set clear vision (steering wheel orientation) after the addition of the aftermarket equipment. Reference page nine of the Body Builders Layout book for more information about this and the addition of aftermarket bodies to incomplete vehicles.

Some vehicles may exhibit an illuminated MIL with diagnostic trouble codes (DTCs) P0011, P0012, P0014, P0015, P0016, P0017, P0018, P0019, P0021, P0022, P0024 and/or P0025. This may be due to small debris causing the VCT solenoid to stick. Before attempting any component diagnosis or replacement of the VCT solenoid, refer to Powertrain Control and Emissions Diagnosis (PC/ED) pinpoint test HK11 to cycle the affected VCT solenoid 10 times to attempt to clear the debris. For claiming, use causal part 6M280 and applicable labor operations in section 10 of the Service Labor Time Standards (SLTS) Manual.

2016-2017 E-Series vehicles do not require the rear axle fluid fill level to be checked during PDI. The axle fluid fill level is set by the supplier and the addition or topping off of any fluid may overfill the rear axle housing above specification. In addition, replacing axle fluid with synthetic fluid will void the axle warranty.

Some vehicles may have a concern where the safety belt retractor webbing does not extract from the stowed position or exhibits excessive pressure on the occupant during use. This may be due to a normal condition which happens when the seatbelt retracts at a high rate of speed. The Workshop Manual, Section 501-20A General Procedures has been updated with a locked seatbelt retractor releasing procedure.

The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic throttle bodies (ETBs). The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.